Here are two pics showing the two hatches I had to cut to get access to the waste hose. The first shows the hose where it comes from the cabinet under the floor. The cutout at the base of the cabinet is (I assume) oem and is covered with a small metal plate. Below that is the hatch I cut. The...

So , after new stator and voltage reg. all is OK...except....starting the genny is easy...just pre heat...and then start...well, not that simple..engine starts but electrical end does not put out voltage.....so..check the fuse in the VR...blown, this is an intermitant issue, sometimes no...

I guess they don't need the props, but can't say enough about service at Raz Marine, Ft Lauderdale. Mike and Jacob rebuilt my FW pump while I waited the day before Christmas Eve. Their supplier screwed up the rotors they had on hand, so they rebuilt with a used rotor to get me going, and will...

I have this track on the ceiling of the head for the shower curtain but I'm missing the small rollers that go inside and hold the curtain. Anybody knows where I can get them? Don't know if this is original from the boat but I suppose it is.

I'm removing about 3,000 pounds from the boat, repowering from 2100 lbs Detroits to 1200 lbs Yanmars. Also removed all the interior wood floor and the frame will be replaced with aluminum, back wall removed (wood) will be replaced with PVC also removed A LOT of wood on the interior. How much do...

Just ran my fairly new to me 1969 Hatteras 36c (with Chris Craft 427's) for 52 miles at 2600 rpm (10 knots) and burned 180 gallons!!!! That equates to a total range when topped off of around 70 miles. Is there something wrong or was i a uninformed fool to buy this boat/engine combo???????

Can someone give me the dimensions (width and length) of the salon on a 36 Series 1. Thanks.

Hi I am looking at a 39' fly-bridge hat was customized by Hatteras to be an open day boat configuration. She was originally powered with special order 471 Ti Detroits at 315 hp and has since been repowered with 3126 Cats at a said 350 hp. I think the transmissions were also changed from the...

Hi all. I've got a few questions about the 40' Double Cabin from the late 80's and early 90's. I love checking out the convertibles and the 1510's but it seems that for those that would rather have an aft cabin than a cockpit and aren't quite up to the budget and size of the 53's the 40 double...

I've found a 1980 50C with a beautiful refit. It seems like a good price, however everybody tells me to stay away from the Series II 50Cs because the hull doesn't ride well. I'm told it "digs a hole in the water". What's the opinion of owners here and if the dock talk is true, can things be...