I'm thinking about swapping out the sleeper sofa and loveseat in my salon, and I'm not sure what way to go. I want a large sofa (possibly L shaped) with storage under all of it) but I don't want it to look like it came out of an RV. All the boat furniture places seem to be stuck in the same...

We just had our stuffing boxes repacked. Our guy used the black/gray Gore stuff and he put six rings in the stuffing box. We cannot get it to leak at all, and during our first run thereafter, mostly at idle speed, the stuffing boxes would not drip and they did get warm - about 150°. We didn’t go...

Was wondering what others performance numbers with same boat were.With the twin 6ly2am 440 hp I cruise @2600RPM,19 KTS=30 GPH swinging 24square 4 blades,Peter

Having issues finding replacement 24v DC Incandescent screw in light bulbs for the engine room. Thank you US government for saving me against the incandescent light bulb... but thats another story! Back on point, was curious if anyone has swapped out or found applicable 24v DC LEDs? I'm down to...

im new. sorry 5 previous bertrams.( 46 33 33 37 30) whats up with side exhausts on hatteras 41c? 6-71s..86 built in 86? are 4 blade props worth the trouble? any other comments gratefully accepted.not having received any info i will try to amplify my question. i have seen some 41c s with stern...

I am in the process of repowering my 1984, 36 convertible with Cat C9, 575hp engines.Has anyone repowered a 36 with these engines or know someone who has that would be willing to share their experiences.My boat currently has 410hp 671TI detroits. I also want to replace the side sliding windows with...

I just purchased a stackable washer dryer set and now I need to get them into the pump room on my 65SF. Has anyone done this on a similar boat? The old ones were similar units and not the original Whirlpool or Frigidaire units that most Hatts have. I have two ways into the pump room. There's a door...

I apologize for the long post but I'm in need of some troubleshooting advice on a fuel system problem with one of my 8v71s. I assume the fuel flow is typical for our old Hatts with 8v71s: tank to Racor filter to fuel pump to secondary filter (on engine) to heads. I just dismantled and...

My markers for the sling points on our 1979 Yacht fish are gone and I was wondering if anyone knew where they should be located. Also, I'm guessing that four straps are required- any one know if it should be done with 2? It's past time for our bottom job and the only travel lift at our marina is...