Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 474 of 1105 FirstFirst ... 374 424 464 472 473 474 475 476 484 524 574 974 ... LastLast
Threads 9461 to 9480 of 22081

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Swim Ladder Suggestions Needed on a 1966 Hatteras 41' Conv.

    I have the steps on the back of the transom however it is not to condusive being that it is all closed, no tuna door. Any suggestions for a ladder to get everyone out the water from ages 10-45? Any Help would be great!

    Started by 20pilot‎, 06-25-2013 02:15 PM
    • Replies: 3
    • Views: 1,290
    bobk
    06-28-2013, 04:27 PM Go to last post

  2. 6v71 tib

    Are there any reasons why 6V71 TIB's might be less desireable than an inline 6? I know about the TIB part and having owned a great set of inline TIB's I am not worried about that issue. RC

    Started by seasalt‎, 06-27-2013 09:07 AM
    2 Pages •
    1 2
    • Replies: 18
    • Views: 9,775
    Fanfare
    06-28-2013, 10:39 AM Go to last post

  3. Old Overheating problem finally solved

    Guy's and gals, I have been fighting for over 5 years trying to solve the overheating problem of my starboard engine and I think we found the culpret this week. This is not the engine I am currently rebuilding. The port engine is being rebuilt. I've thought I'd covered everything from boiling...

    Started by captbuddy‎, 02-07-2013 11:29 AM
    3 Pages •
    1 2 3
    • Replies: 26
    • Views: 8,809
    captbuddy
    06-27-2013, 10:34 PM Go to last post

  4. Trouble with a holding tank and need some ideas

    I am confused as to what is going on with one of my holding tanks. Boat is '79 53 ft yachtfish and the guest holding tank is acting funny. We have pumped out both holding tanks a few months ago and the full light on each holding tank has always worked. In addition all our heads seem to flush a bit...

    Started by mrdeepseafisher‎, 06-14-2013 09:32 PM
    3 Pages •
    1 2 3
    1 Attachment(s)
    • Replies: 20
    • Views: 5,910
    magnawake
    06-27-2013, 06:44 PM Go to last post

  5. Problem with zincs - radiator

    Changed the zincs on the 8v92. Had a problem getting one of the zincs out on the discharge side of the radiator. Had to take the casting off the radiator. There is a small 1/8 inch line of crud across the tubing in the radiator. Rest of radiator is clean. Question if I use a mild acid - will...

    Started by questover‎, 06-27-2013 02:38 PM
    • Replies: 1
    • Views: 955
    bobk
    06-27-2013, 03:07 PM Go to last post

  6. a/c pump quit

    Last night my a/c made a strange noise. I looked outside and noticed my pump wasnt running. I went below and the pump motor was making noise but you could see the armature wasnt spinning. Are these motors rebuildable and is there is anything i need to watch out for when i remove it? thanks as...

    Started by TROUBLE‎, 06-25-2013 04:53 PM
    • Replies: 7
    • Views: 1,986
    TROUBLE
    06-27-2013, 12:27 PM Go to last post

  7. Using a switch to change depth gauges on single sensor?

    My two Garmin chartplotters (lower Helm and FB) share depth data through the Garmin network. I have a separate Raymarine ST40 depth gauge on the FB Helm with it's own transducer as a back up but do not have one at the lower helm. I would like backups in both positions but don't want to install a...

    Started by MikeP‎, 06-26-2013 07:40 AM
    • Replies: 7
    • Views: 2,143
    SeaEric
    06-27-2013, 08:17 AM Go to last post

  8. Well pump leak while on dock water

    My freshwater system uses a Dayton 3/4 hp well pump and works great. The dockside water enters the line after the well pump and the pump operates as a check valve so as not to pressurize the water tanks. All is well except the well pump has begun slowly leaking while the dockside water is on. It...

    Started by davidwigler‎, 06-26-2013 06:24 AM
    • Replies: 3
    • Views: 1,315
    davidwigler
    06-26-2013, 10:02 PM Go to last post

  9. Running gear and spray zinc coating

    Hello Everybody I was talking with a yard manager the other day and he suggested using cold galvanizing zinc spray to protect the running gear from barnacles. I thought that was a very interesting solution. I have used the zinc spray before and it sticks like crazy, but I didn't use it...

    Started by bostonhatteras‎, 06-26-2013 08:26 AM
    2 Pages •
    1 2
    • Replies: 10
    • Views: 5,152
    Avenger
    06-26-2013, 04:30 PM Go to last post

  10. 1971 53 MY Water Line

    Finishing restoration All good on sea trial. Slight vibration on bridge at 2100 rpm WOT @ 17knts- none at 12knt. checking engine alignment on friday gauges slightly off but fixing. We seem to be experiencing a slight bow heavy feel. In the slip, the water on bridge seems to be collecting...

    Started by caryboat‎, 06-26-2013 07:59 AM
    • Replies: 3
    • Views: 1,480
    Nonchalant1
    06-26-2013, 01:45 PM Go to last post

  11. reverse polarity detection of shore power circuit

    I was wondering if the reverse polarity alarm and light need any fuse protection? My boat simply has it wired to check for voltage between neutral and ground. Also, since your not to have any neutral-ground bonds in the boat, does not the reverse polarity light and alarm in a way make a small...

    Started by sdowney717‎, 06-26-2013 06:40 AM
    • Replies: 4
    • Views: 1,644
    sdowney717
    06-26-2013, 11:18 AM Go to last post

  12. Fly Bridge Hatch Repair - More Bad Balsa Coring

    Lilly Marie has had a leak around the hatch going up to the Fly Bridge and the problem graduated to the point that the deck forward of the hatch rim had collapsed. It took a while to get in the mood to tackle another coring repair after the aft deck and cabin top projects, but the hatch was...

    Started by Vincentc‎, 06-26-2013 07:24 AM
    • Replies: 1
    • Views: 2,062
    micky
    06-26-2013, 09:32 AM Go to last post

  13. Question about hull speed fuel usage VS fuel usage while on a plane

    I am new to mid-sized power boats. I am considering a 46C. I was very surprised at the amount of fuel these diesel engines consume, particularly while on a plane (twice as much / 2gal per mile!) I have been on center consoles most of my life and generally you get better fuel economy when you get...

    Started by RobATX‎, 06-23-2013 11:15 PM
    • Replies: 8
    • Views: 2,818
    RobATX
    06-25-2013, 06:17 PM Go to last post

  14. 1988 Hat 48' Electrical-fuel low presure switch

    Wire end came loose on port fuel low presure switch shorting against presure switch housing. Does anyone know where to look for fuse. No voltage on lines now. Help. Ken

    Started by sealily‎, 06-19-2013 07:38 PM
    • Replies: 9
    • Views: 1,863
    Boatnut
    06-25-2013, 05:49 PM Go to last post

  15. DDEC Display Manual

    Does anyone know of an online source for a manual for the displays on my 1996, 12V92 TA's DDEC's? I have not been able to locate any source, let alone a source that would permit me to download the display manual.

    Started by JLR‎, 06-11-2013 08:16 AM
    2 Pages •
    1 2
    4 Attachment(s)
    • Replies: 13
    • Views: 4,356
    JLR
    06-25-2013, 05:32 PM Go to last post

  16. cleaning anodized aluminum tower

    This question is on behalf of friends who own a Rampage sportfishing boat that they keep at Ocean City, MD. The boat was equipped from new with an aluminum tower, which I imagine is anodized, and they are having trouble keeping it looking good. What are the best products for cleaning and shining up...

    Started by jim rosenthal‎, 06-23-2013 07:52 PM
    • Replies: 8
    • Views: 10,034
    Artzco
    06-25-2013, 02:37 PM Go to last post

  17. Fire Suppression System

    My tank hasn't been inspected since 1986. I assume it is CO2, is that correct? Is it worth having it inspected and hydro tested or is it toast?

    Started by davidwigler‎, 06-05-2013 03:58 PM
    3 Pages •
    1 2 3
    1 Attachment(s)
    • Replies: 20
    • Views: 5,930
    Fanfare
    06-25-2013, 11:10 AM Go to last post

  18. Cruisair potential relay replacement using APR5 Supco universal adjustable relay

    http://www.supco.com/images/pdfs/Manuals-Instructions/apr5%20-%20supr.pdf This one works. My potential relay failed. The APR5 also fits in the box. I did not like the slotted small screws used for attaching the wires, SO, I used small metal phillips screws from PC computer cases I have saved...

    Started by sdowney717‎, 06-25-2013 10:26 AM
    • Replies: 0
    • Views: 1,820
    sdowney717
    06-25-2013, 10:26 AM Go to last post

  19. What is this warning light?

    Does anyone know what the warning light in the lower left hand corner of this picture is for on a 1961 41' Convertible?

    Started by wschanback@optonline.net‎, 06-24-2013 07:48 PM
    1 Attachment(s)
    • Replies: 2
    • Views: 1,195
    SKYCHENEY
    06-24-2013, 09:00 PM Go to last post

  20. Fore deck seat on 48YF (or 41TC)

    Does anyone know what lies hidden under the 'seat' below the front windows on the above boats? Unless I remove the V-berth headlining I cannot see into it. I am considering a modification to the center window which is in serious need of refurbishment and I would like to remove or modify the seat? ...

    Started by silverpaul‎, 06-24-2013 05:43 PM
    1 Attachment(s)
    • Replies: 1
    • Views: 1,024
    SeaEric
    06-24-2013, 07:30 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 345 users browsing this forum. (1 members & 344 guests)

  1. madhatter1

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules