Since they are getting a bit ratty, I want to replace the two helm chairs on our 53MY flybridge. What product(s) would be a good choice? Thanks!

I’m looking to mount another furuno navnet3d screen under the back of the bridge to view the fish finder from the cockpit on my 88 38c. Navpods will do the trick but it’s as much as a used screen. Any alternatives?

Second boat i run where the alisons kind of clunk/slam in gear when hot... I noticed and Angela's 58 does it, and this 54ED too so it seem to be a common thing. my 8V71N always engage smoothly, cold or hot, and the 8V92 are smooth when cold. I know they have more torque and bigger props but...

My 74 36 C has the drain plug in the forward bilge under the port v berth bunk. It's extremely hard to reach and I always have to remember to tell the yard to block it with this in mind for proper drainage. Well, I'm pulling the boat for new bottom paint, wax, etc and want to put a transom drain...

Anybody ever installed a sender in a gas tank that doesn't already have one? This is gas, not diesel, and the original tanks have been moved inboard so the factory-supplied graduated dipstick is worthless. Thx Q

Hi: I try to found any kind of number or name in my cables without luck, they are the black one's but don't have any info anywhere. This is a very concern to me replace my cables but I don't want to pull it out without have the new one's . If anyone out there know the correct lenght for both...

The question of recertification of fixed CO2 systems was recently discussed in another post. In researching the the issue on my own, I found it difficult to get a definitive answer. I submitted the question to a friend who forwarded the below. From: Mxxxxx, Brian K CIV Sent: Thursday,...

I need to tighten up the throttle cables and replace burnt out instrument bulbs on my 1973 53 MY. it looks like the helm is held in place by 4 bolts with wing nuts, sort of. will the entire helm tilt forward if i remove the nuts? i don't want to cause damage by pulling out wires, etc, just for...