Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 34 of 1105 FirstFirst ... 24 32 33 34 35 36 44 84 134 534 1034 ... LastLast
Threads 661 to 680 of 22082

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Painting under brow and aft deck ceiling

    OK, So I open a can of warms and keep chasing. Atlantic Tower Hardtop is in, that lead to painting the flybridge and some deep paint prep. And I decided to replace the aft enclosure acrylic windows, so now I am sanding and fairing and taking all the dodger board to the paint booth. Replacing...

    Started by metama‎, 05-16-2023 08:24 PM
    1 Attachment(s)
    • Replies: 9
    • Views: 771
    metama
    05-20-2023, 06:43 PM Go to last post

  2. Hynautic HA5455 control fluid replacement

    Hynautic is not making the HA5455 fluid anymore. Does anyone know a replacement. We are replacing a throttle assembly and need to replace the fluid on our 1987 63' CPMY. Thank you.

    Started by 2nd SEAbatical‎, 05-20-2023 12:22 PM
    1 Attachment(s)
    • Replies: 3
    • Views: 476
    Avenger
    05-20-2023, 06:26 PM Go to last post

  3. AC will not turn off

    Have 4 old cruisaires on my 53 ED MY. The one in the salon (I think it is a 24k btu split unit) seems to be having a weird malfunction. The air gets ice cold and the ac seems to run until it cools to the desired temperature when the heat kicks on. I move the selector on the thermostat from Auto...

    Started by Cap'n Kirk‎, 05-18-2023 12:39 PM
    2 Pages •
    1 2
    • Replies: 11
    • Views: 882
    Captain Ralph
    05-19-2023, 04:16 PM Go to last post

  4. Hot Water Heater Coolant Loop Question

    1985 Hatteras 45' Convertible 6V92 TA's I'm installing an 11 gallon 120 volt hot water heater from Kuuma. My question is where is the best place to tap into the coolant side of the engine? The inlet/outlet on the water heater are 5/8". I'm hoping someone has this setup and would share some...

    Started by big papa‎, 05-16-2023 10:09 PM
    • Replies: 3
    • Views: 466
    SKYCHENEY
    05-17-2023, 07:21 PM Go to last post

  5. Looking for DIY boatyards that have sodablasting service near Jupiter,Fl. Thank you

    Looking to have the bottom sodablasted in prep for painting. Any recommendations on DIY boat yards that have sodablasting service also any recommendations on paint to use. (thinking about Micon CSC). Appreciate any info. Thank you Felix

    Started by Felix‎, 05-16-2023 01:40 PM
    • Replies: 4
    • Views: 555
    Felix
    05-17-2023, 12:22 PM Go to last post

  6. My batteries overcharged themselves

    We have a real twilight zone deal here. I'm on the boat at least 3 times per week (in back yard) and always keep the batts at 32v. The battery charger is always off at the breaker. When they need a little charge, I simply flick the breaker and let it run while I'm doing something on the boat....

    Started by JuiceClark‎, 05-11-2023 10:22 PM
    3 Pages •
    1 2 3
    • Replies: 21
    • Views: 2,299
    Pascal
    05-16-2023, 11:05 AM Go to last post

  7. Onan MDL4 Grinds at Startup

    My 1987 20kw Onan (32V) generator occasionally "grinds" when the starter tries to engage. I of course stop trying to start it immediately then try again. Most times it then fires off fine. The original starter (32V) was replaced by the prior owner with a 24V starter since I understand the 32V...

    Started by pmurphy‎, 05-04-2023 07:33 PM
    2 Pages •
    1 2
    6 Attachment(s)
    • Replies: 19
    • Views: 2,552
    SKYCHENEY
    05-15-2023, 09:00 PM Go to last post

  8. Small amounts of oil at my exhaust

    I just launched for the season and saw some oil sheen coming from each of my exhaust upon start up, I checked before launch and oil levels were good and my oil pressure was 40 at 1000 rpm and temps were 180 on each engine. I have 8 53 Detroit's naturally to asperated. Once docked and engines shut...

    Started by jerseyboy‎, 05-14-2023 03:47 PM
    2 Pages •
    1 2
    • Replies: 12
    • Views: 1,218
    edward
    05-15-2023, 07:21 PM Go to last post

  9. 12v71 temp sensors

    Looking for advice on temp sensors…. Have single stud sensors what are the recommended replacements? Thanks

    Started by skinners1‎, 05-12-2023 08:12 PM
    1 Attachment(s)
    • Replies: 4
    • Views: 711
    Captain Ralph
    05-15-2023, 10:46 AM Go to last post

  10. Fuel Polishing Help...

    A little background: 1985 61' MY w/ 12v71s Purchased vessel in 2022. Have dual 1000 racors on each engine. According to PO he never utilized the forward fuel tank, always ran on aft tank. He owned the boat for 6 yrs. Don't know why he didn't alternate. Fuel gauge shows full in...

    Started by skinners1‎, 01-05-2023 12:11 PM
    2 Pages •
    1 2
    5 Attachment(s)
    • Replies: 13
    • Views: 1,385
    skinners1
    05-15-2023, 10:16 AM Go to last post

  11. Wood around back door replacement

    Looking for advice or how to go about replacing the wood around the rear door on a 1987 53. I’ve noticed some severe rot going on in the bottom right corner. I’ve attached a picture to better see. Any help would be greatly appreciated. Thanks

    Started by Offshore5387‎, 05-13-2023 10:08 AM
    1 Attachment(s)
    • Replies: 4
    • Views: 687
    metama
    05-13-2023, 10:39 PM Go to last post

  12. Impellers for DD 6V71s

    Can I ask where everyone is getting thier impellers, brand name, and cost? Thanks guys!

    Started by sunsetacres1318‎, 05-12-2023 05:54 PM
    • Replies: 0
    • Views: 376
    sunsetacres1318
    05-12-2023, 05:54 PM Go to last post

  13. Detroit Diesel- 12V71TAC Replacement Zincs

    Are the brass plug replacement zincs 3/4" diameter with 3 3/8" length? How often should they be replaced for preventive maintenance?

    Started by Big Chief‎, 05-11-2023 09:26 AM
    • Replies: 1
    • Views: 544
    Briankinley2004
    05-11-2023, 08:41 PM Go to last post

  14. Impeller replacement

    I have a Hatt 50 with DD 6V92 engines. Where is best place to get quality impeller replacements?

    Started by sunsetacres1318‎, 05-10-2023 09:32 PM
    • Replies: 1
    • Views: 609
    omecojh
    05-11-2023, 06:28 PM Go to last post

  15. Epoxied in place deck mount plate, has anyone done this?

    Just curious as I am chasing leaking screw holes in my deck.... Has anyone tried any kind of epoxied down plate to mount things to? I have my two front deck boxes that are screwed to the bow deck, and at least one of the small screws has broken off and created a leak. I siliconed the hole for...

    Started by Bob Quinn‎, 05-10-2023 06:48 AM
    2 Pages •
    1 2
    1 Attachment(s)
    • Replies: 12
    • Views: 1,366
    meteor64
    05-11-2023, 02:09 AM Go to last post

  16. 2002 Hatteras Fuel Tanks

    I'm thinking of buying a 2002 Hatteras 55' Convertible. Can anyone tell me if the fuel tanks are glass or aluminum?

    Started by Dalbers‎, 05-09-2023 03:22 PM
    • Replies: 2
    • Views: 652
    jim rosenthal
    05-10-2023, 08:39 PM Go to last post

  17. boat for sale 58my

    Am l allowed to list my boat for sale here?

    Started by stewart‎, 05-10-2023 03:55 PM
    • Replies: 2
    • Views: 710
    jim rosenthal
    05-10-2023, 08:35 PM Go to last post

  18. Onan 15.0 marine genset

    Having some trouble with my genset. The top pulley periodically will freeze up and start burning the belt. If I let it cool down and restart it runs fine for awhile. I’m thinking possible bearings. I called Bridgeway Cummins in Grand Rapids and they want $1000 for the service call alone. I’m kind...

    Started by Phasma2128‎, 05-09-2023 12:22 PM
    1 Attachment(s)
    • Replies: 1
    • Views: 483
    bigbill
    05-09-2023, 10:45 PM Go to last post

  19. Open holes in Master Stateroom Air Handling unit compartment?

    My master stateroom has never smelled as fresh as the rest of the boat, and today while installing a Air Lock air quality unit I noticed two large holes open to a larger compartment under the bed. Shouldn't these be closed up? Thanks

    Started by Eddieclemons‎, 05-08-2023 09:47 PM
    2 Attachment(s)
    • Replies: 2
    • Views: 635
    doc g
    05-09-2023, 01:53 PM Go to last post

  20. Is there room for another Stair/swim platform/bimini top guy in Florida?

    As I am moving toward retirement here in Michigan, I need to find something to do in Florida. Just wondering how the market would be down there for someone like a swim platform / boat stairs / bimini top design and fabrication guy? Is the market flooded with these guys? Is there backlog? Do...

    Started by Bob Quinn‎, 05-02-2023 01:20 PM
    2 Pages •
    1 2
    • Replies: 11
    • Views: 1,368
    Angela
    05-08-2023, 08:54 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 348 users browsing this forum. (1 members & 347 guests)

  1. madhatter1

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules