Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1102 of 1105 FirstFirst ... 102 602 1002 1052 1092 1100 1101 1102 1103 1104 ... LastLast
Threads 22021 to 22040 of 22081

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Outdoor Table

    I currently have a fighting chair in my cockpit I would like to convert this to a table when I am Not Fishing. Anyone have any ideas where I can buy a table top only looking for low maintainence like PVC or Fiberglass Thanks

    Started by ZIDA‎, 04-14-2005 09:57 PM
    • Replies: 1
    • Views: 1,462
    jim rosenthal
    04-16-2005, 12:21 AM Go to last post

  2. Help with bleeding steering 58LRC

    We are on our maiden voyage from Portsmouth, VA - south. Prior to leaving the yard replaced a section of bad hose on the hydraulic steering system section in the lazarette. It appears they did not bleed the system fully and we are having some issue with steering the boat. Can anyone help? ...

    Started by zigzag930‎, 11-21-2020 05:11 PM
    2 Pages •
    1 2
    • Replies: 12
    • Views: 1,738
    zigzag930
    11-22-2020, 01:23 PM Go to last post

  3. Engine stalls, fuel issue Detroit 4-71. Simple troubleshooting?

    I had a man working over on the port side of my engine room this week and he was "crammed" in the area where the fuel lines come off the Floscan Homogenators/Pulse Dampers and connect over to the fuel pump. The motor has been running perfectly up to that point, but today when I started it to...

    Started by zigzag930‎, 04-13-2022 05:54 PM
    2 Pages •
    1 2
    • Replies: 14
    • Views: 1,376
    whoover
    04-16-2022, 08:17 PM Go to last post

  4. Exhaust Blankets - 58LRC, a few questions

    Does anyone know if the exhaust blankets in the attached photos would be the original for these engines? Do they contain asbestos? They are in overall decent shape except for one side where the cloth is worn out from running against people squeezing by. Is there a fiberglass tape or other...

    Started by zigzag930‎, 04-15-2022 09:19 AM
    2 Attachment(s)
    • Replies: 6
    • Views: 1,000
    rsmith
    04-18-2022, 10:14 AM Go to last post

  5. Worth going outside the US for refit work?

    I am considering taking our 58LRC down to Guatemala to have refit work done on her. Why? I'm tired of paying for sub-par quality of work here in Florida at $120-150/hr. I'm on the West Coast and haven't had a good experience yet with any of the yards over here. This is a list of potential...

    Started by zigzag930‎, 01-06-2023 04:56 PM
    2 Pages •
    1 2
    • Replies: 10
    • Views: 1,325
    rsmith
    01-15-2023, 09:45 AM Go to last post

  6. Alternator questions

    We are learning a lot about our new 58LRC, including some things that are not working. No surprise on a used boat, but it is frustrating that some of these tings were missed by the "engine" surveyor, despite my specifically asking for these items to be checked. One issue I discovered is a 24V...

    Started by zigzag930‎, 12-08-2020 07:34 PM
    • Replies: 6
    • Views: 1,340
    zigzag930
    01-20-2021, 08:44 PM Go to last post

  7. Engine Room temperature

    I'm wondering what others are seeing as temperature in their engine rooms. I will measure mine next trip out. The reason I'm asking is that I am getting a "thermal warning" on my Victron Multiplus inverter, usually after shutting down the engines (after running for a few hours). The engine...

    Started by zigzag930‎, 02-22-2022 07:40 PM
    2 Pages •
    1 2
    • Replies: 15
    • Views: 1,950
    Bob Bradley
    02-24-2022, 12:27 AM Go to last post

  8. Detroit Diesels - Anyone see this before?

    I'm hoping I just need to remove the plate and install a new gasket. Must be salt crystals right? Just don't want this to be an indication there is a blockage downstream. Engine is not running hot and seems like great water flow out the exhaust.

    Started by zigzag930‎, 02-26-2022 04:23 PM
    6 Pages •
    1 2 3 ... 6
    4 Attachment(s)
    • Replies: 50
    • Views: 6,783
    52CMY
    04-20-2023, 07:51 PM Go to last post

  9. Question for 58/65 LRC owners

    Can anyone send me a photo or describe what the cabinets on the far right side of the pilothouse are supposed to look like? Mine our simple open shelves and I'd like to return them to original. Where these pull out drawers or did they hinge on sides? Do they contain file hangers? I...

    Started by zigzag930‎, 09-19-2021 04:33 PM
    2 Attachment(s)
    • Replies: 3
    • Views: 693
    JD5652
    09-20-2021, 06:23 PM Go to last post

  10. 58' LRC Pilothouse floors and refinishing

    Does anyone know what wood and finish is used on the pilothouse floor of a 58LRC? Mine are in pretty nice shape except for the finish which is worn out in a few spots. I was thinking of surface sanding these floors and re-finishing them. Varnish? Polyurethane? Other?

    Started by zigzag930‎, 03-08-2021 08:37 AM
    • Replies: 0
    • Views: 533
    zigzag930
    03-08-2021, 08:37 AM Go to last post

  11. Scott B, saved my butt again.

    Yesterday, we were out on the hook for the 1st time in a few months (a number of repairs and upgrades being done) and had an issue with my Victron Multiplus not charging properly. About 3 weeks ago, I had updated the Firmware on the Cerbo, Multiplus and BVM. Didn't notice any problems as the...

    Started by zigzag930‎, 03-09-2024 11:08 AM
    2 Pages •
    1 2
    • Replies: 18
    • Views: 837
    SKYCHENEY
    03-17-2024, 09:02 PM Go to last post

  12. Power Problems with HVAC on Generator

    Not to hijack RyanB's thread on Power Problems with AC, I have created this separate thread on an issue I discovered this weekend. I have never attempted to run our 16KBTH 220V HVAC system or any of the HVAC systems on my Northern Lights 6K genset as I've always just run off our large Genset. ...

    Started by zigzag930‎, 07-19-2021 12:05 AM
    • Replies: 5
    • Views: 1,201
    zigzag930
    07-19-2021, 11:46 AM Go to last post

  13. HVAC Circulation pump - Magnetek. How to separate motor from pump end?

    Does anyone have any experience separating the motor from the pump on a HVAC Circulation pump? This is a "Magnetek Century AC motor" Seems to use a "Scot" pump which I have ordered, but I can't seem figure out if the old pump is "Keyed" or screwed onto the motor shaft. I've attached a...

    Started by zigzag930‎, 10-05-2021 05:44 PM
    4 Pages •
    1 2 3 ... 4
    11 Attachment(s)
    • Replies: 35
    • Views: 3,508
    Captain Ralph
    10-23-2021, 10:34 PM Go to last post

  14. Help with these Isolation Transformers (assuming that is what they are)

    I have 2 large boxes in the engine room (see below) which I believe to be isolation transformers as well as possibly voltage boosters/frequency converters. Of all the documentation I have on board, I don't have any information on these. I've attached a photo of the top unit and hope maybe...

    Started by zigzag930‎, 10-30-2022 02:21 PM
    3 Pages •
    1 2 3
    10 Attachment(s)
    • Replies: 20
    • Views: 1,607
    cww
    11-04-2022, 02:35 PM Go to last post

  15. 58LRC Shaft log problem

    On our 1st voyage, I noticed water was dripping from the shaft on the starboard engine more that normal. I'm not familiar with the type of packing setup on these vessels and expected to find a large packing nut that I could tighten. Instead I found a 2 flange setup with bolts that appear to...

    Started by zigzag930‎, 11-03-2020 06:51 PM
    2 Pages •
    1 2
    1 Attachment(s)
    • Replies: 17
    • Views: 2,453
    HahnR
    11-08-2020, 10:33 AM Go to last post

  16. Black sealant between teak on pilot house floors

    Hi guys, Today I decided that my pilothouse floors aren't looking too good and started to sand them down in preparation for re-coating with Polyurethane. I noticed that there are a few areas where the black sealant between the planks is missing. Is this black silicone, sikaflex or...

    Started by zigzag930‎, 03-23-2024 05:46 PM
    1 Attachment(s)
    • Replies: 6
    • Views: 289
    zigzag930
    03-24-2024, 10:15 AM Go to last post

  17. Any LRC owned have drawing CED38?

    I thought I had a pretty much complete set of drawings for my LRC, but just discovered that I am missing CED38, referenced by another 32V Drawing. I believe CED38 is a drawing of the DC panel/fuse box in the engine room. From what I can tell the "Parallel solenoid" should be in this panel, but...

    Started by zigzag930‎, 03-24-2024 05:25 PM
    • Replies: 6
    • Views: 246
    zigzag930
    03-24-2024, 10:12 PM Go to last post

  18. Rust on stainless (cleats, fittings, etc)

    I've used Colinite Metal polish on some of the stainless fittings on the front deck (cleats, etc). They looked great for a few weeks but are not starting show moderate surface rusting. The fittings I didn't clean are still fine, although they could use cleaning. Is there something I should...

    Started by zigzag930‎, 05-22-2021 06:38 PM
    • Replies: 8
    • Views: 1,536
    ageless
    06-01-2021, 11:46 AM Go to last post

  19. Starting Batteries for 32v - DC180-8'?

    Looking to build a new starting bank for a 4-71 DD. Existing battery setup is one bank having four 8v195's that is connected to start both engines. I'd prefer not to use the large 8v195's in the new bank and have found a battery recommended by DC Battery Specialists in Miami. I've used this...

    Started by zigzag930‎, 09-15-2020 07:07 PM
    3 Pages •
    1 2 3
    3 Attachment(s)
    • Replies: 22
    • Views: 1,934
    zigzag930
    01-18-2024, 03:52 PM Go to last post

  20. Bottom paint - 58LRC (How many gallons and approx cost)?

    I saw on another thread that a 58' takes about 4 gallons off paint, but it wasn't clear if that was for one or two coats. I'm guessing only one coat. Also, I've checked a few marinas around here (SW Florida) and they are getting around $100/ft to haul and 2 coats of paint. $580 to...

    Started by zigzag930‎, 01-18-2022 01:36 PM
    • Replies: 0
    • Views: 388
    zigzag930
    01-18-2022, 01:36 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 362 users browsing this forum. (3 members & 359 guests)

  1. Play'N Hooky Too
  2. Fanfare
  3. firbanks

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules