Good evening all, I would very much appreciate recommendations for a Detroit engine surveyor around Norfolk, Newport News/Richmond area or thereabout. I have researched the forum and found some names but they are either no longer active or moved away. The engines are the real concern here so...

Well everyone let me hear your thoughts. I have completed sea trial, mechanical and hull survey of a 1999 65' sport fish in Stuart. The sea trial went well, the boat reached 31 knots, port 99.1% and the starboard 100% load. Temps were 187 port, 190 starboard. RPMs were port 2232 and starboard 2207....

First, we use both dock water and our tank for supply and yes whenever we leave the boat we turn the dock water off even if for a walk. I’d like to add another quick disconnect at the bow for bow in docking. 1. Would it be bad form to use reinforced flexible hose to run to wherever I plan to...

It appears the holding tank tube has broken off on forward tank on my 53 my Marina sent their strongest man and he could not budge the fitting Could l just buy a new fitting and drill an appropriate hole in the fibre glass tank and fibre glass the new fitting in.

So for my winter project we decided to finally get around to replacing the floor in the salon. The old floor was sagging a little in some places and generally had a little more flex than it should. The substructure viewed from the engine room is a hodgepodge of supplemental support, poorly...

We are looking for our next boat(currently have a Uniflite 42DC), and have zeroed in on the 48MY. We want stabilizers, which limits our choices. I also prefer the 6-71N over the 6V-92TA, which limits things even further. Any ideas on the ratio of these boats produced with these 2 engine choices?...