Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 1006 1 2 3 11 51 101 501 1001 ... LastLast
Threads 1 to 20 of 20111

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1.   Sticky Threads  

  2. Sticky Thread Sticky: Acceptable Use Policy & Posting Guidelines

    Hatteras Talk Guidelines This section of the forum is for the more technical threads and topics specifically related to Hatteras yachts. Threads in this section should STAY ON TOPIC. Hatteras Owners Forum Acceptable Use Policy & Guidelines Listed below are some expectations that...

    Started by administrator‎, 08-21-2006 09:10 AM
    • Replies: 0
    • Views: 15,168
    08-21-2006, 09:10 AM Go to last post
  3.   Normal Threads  

  1. Pex best practices in Marine us.

    I some places in my fresh water system that drip/leak and are nest of connections. I plan to replace them with pex. There are a few questions I am researching.1. I was told that stainless crimp clamps are considered to have more corrosion resistance than the brass compression rings?2. Brass vs...

    Started by Eddieclemons‎, Yesterday 10:12 PM
    • Replies: 2
    • Views: 55
    Today, 09:41 AM Go to last post
  2. Mathers Micro Commander controls

    Iím still having trouble with my Hynautic Controls and am seriously considering replacing the whole mess with an electronic system. Has anyone here done that and did it work out well? How much did it cost?

    Started by Westfield 11‎, Yesterday 04:24 PM
    • Replies: 8
    • Views: 101
    Today, 09:05 AM Go to last post
  3. anyone know this boat

    MR.HATT in cedar creek marina near nashville? she is a 1979 58 yf, also need a good surveyor in the area

    Started by bigbill‎, Yesterday 09:26 PM
    • Replies: 3
    • Views: 85
    Today, 08:48 AM Go to last post
  4. Plum tuckered out- A 15 week project

    When I bought the Southern Drawl about 3 1/2 years ago there were two soft spots noted on the bridge deck. I knew they needed to be fixed but they were not that bad and I had fishing to do. Well they got a bit worse last summer and turned into 3 spots. I decided to start the repairs New Years Day...

    Started by Briankinley2004‎, Yesterday 09:55 PM
    • Replies: 7
    • Views: 80
    Today, 06:49 AM Go to last post
  5. Morning funny

    Here you go

    Started by SEVEN‎, 08-25-2017 06:04 AM
    1745 Pages
    1 2 3 ... 1745
    • Replies: 17,449
    • Views: 1,217,304
    Today, 12:27 AM Go to last post
  6. Show us your Helm

    Started by SEVEN‎, 02-07-2016 06:05 PM
    14 Pages
    1 2 3 ... 14
    • Replies: 131
    • Views: 38,780
    Yesterday, 09:38 PM Go to last post
  7. 8D Batteries Napa vs Duracell

    I need to replace the 8D batteries on our Hatt (4 total). The batteries are used primarily for starting the Detroits and powering a few lights/vacuflush system. We use the generator when away from the dock. Thoughts on Napa brand batteries and Duracell brand batteries. Thanks in advance!

    Started by Hat43c1981‎, 04-13-2021 08:09 PM
    8d battery
    • Replies: 6
    • Views: 210
    Yesterday, 05:12 PM Go to last post
  8. White/grey smoke from Onan 20kw genset after 4 months disuse.

    After a four month pause our 20kw spewed white smoke on startup this morning. It ran fine the last time we used it and since then Iíve changed the oil and filter, changed the engine mounted fuel filter and the racor. It smells like unburned fuel and I was wondering if there is anything I can do to...

    Started by Westfield 11‎, 04-13-2021 05:13 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 535
    Yesterday, 10:01 AM Go to last post
  9. Hatteras Fiberglass Tanks

    Having issues getting the pickup tube in my 32ft Flybridge. Slides in the hole but there is something on the bottom that the tube us supposed to feed into that does not seem to line up right. No clue what it looks like on the bottom to know going on. Any of you guys who replaced tanks ever cut...

    Started by Jackman‎, 04-15-2021 05:44 PM
    • Replies: 7
    • Views: 316
    Yesterday, 08:31 AM Go to last post
  10. EBay

    I just found this on eBay. This is a screaming deal if anybody needs any.

    Started by SEVEN‎, 04-09-2021 03:11 PM
    • Replies: 3
    • Views: 297
    04-15-2021, 08:24 PM Go to last post
  11. Holding tank vent outlet location 43íC

    I am trying to locate where the vent pipe from the holding tank exits through the hull of the boat. Typically, what do the vent covers look like on Hatts (this is my first Hatt). Would it be located just above the water line where the gray water discharges are? Thanks for your help!

    Started by Hat43c1981‎, 04-13-2021 11:03 PM
    2 Pages
    1 2
    holding tank, vent
    • Replies: 19
    • Views: 245
    04-15-2021, 07:36 PM Go to last post
  12. Cable Sizing for Riggers

    Newb Question: I'm installing two down riggers, which call 8 gauge wire for up to 15' and 6 gauge wire for up to 20' away, with a 30 amp breaker inline to the riggers. The instructions state to run everything straight to a battery, which I'd rather not do. My plan is to tie into an unused...

    Started by RyanB‎, 04-12-2021 03:15 PM
    • Replies: 8
    • Views: 227
    04-14-2021, 09:10 PM Go to last post
  13. Loran-C Interference Suppressor

    Any benefit to having these on my alternators still? Loran-C and the unit itself are both long gone, of course.

    Started by brettportzer‎, 04-12-2021 09:57 PM
    • Replies: 4
    • Views: 197
    04-14-2021, 06:52 PM Go to last post
  14. Too close?

    Somewhere buried in another thread Mr Clarkson mentioned a magnet/whacky compass situation which was an "aha" moment for me.... The PO's choice for compass sensor and Algae-X So is this too close?

    Started by oscarvan‎, 04-11-2021 08:44 PM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 688
    04-14-2021, 06:49 PM Go to last post
  15. Cool My 1st Hatt - 1984 52C

    Well, I bought the old girl from a very kind Virginia gentleman with a winter home across the river. It's the first time either of us sold/bought a boat without using a broker - and it worked out great. He had to sell because of a personal loss and was glad to see it go to someone he could tell...

    Started by JuiceClark‎, 02-28-2021 04:12 PM
    12 Pages
    1 2 3 ... 12
    • Replies: 114
    • Views: 4,460
    04-14-2021, 01:23 PM Go to last post
  16. Lifeline diameter

    Does any know the wire size of the plastic coated lifelines that run thru the rail stanchions. Boat is 1971 43DC. I am adding a gate and need to order some fittings. Rob

    Started by rob71‎, 04-13-2021 11:08 AM
    • Replies: 2
    • Views: 109
    04-14-2021, 08:16 AM Go to last post
  17. Lightbulb 1972 Hatteras 45 Convertible Refit

    Thanks to SEVEN I officially signed-up as I'm working on a refit of 1972 Hatteras 45 Convertible which is located in Aqaba, Jordan. My father acquired her in 1983. Unfortunately he is 92 with dementia, but we have great memories together. The grand children are keen on a refit. I'm leading the...

    Started by BlueArrow‎, 06-30-2020 05:54 PM
    11 Pages
    1 2 3 ... 11
    • Replies: 102
    • Views: 8,521
    04-13-2021, 05:09 PM Go to last post
  18. Injector service

    RPM in Lauderdale is highly recommended but my local mechanic normally sends his stuff to Pinellas Diesel. 8-92's and need to replace all tips plus maybe more. My mechanic will send them to whoever I want. Anyone have experience with Pinellas Diesel? I would prefer to have my mechanic work with...

    Started by madhatter1‎, 04-08-2021 10:32 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 468
    04-12-2021, 11:33 PM Go to last post
  19. 1988 Hatteras 38 CAT vs DD

    Looking at a 1988 - 38 Hat with CAT power. Reading an article by Pascoe indicating it is under power and this boat needs the DD 671 to run optimally. Anyone have further evidence that the 671 is the must have solution for this boat? Thanks for any help!

    Started by MiBuckeye‎, 04-11-2021 02:07 PM
    • Replies: 5
    • Views: 205
    04-12-2021, 01:39 PM Go to last post
  20. Beauty Bead

    What type of caulk should I use for various Beaty Beads around the boat? Where the house joins the deck near aft quarter (75 MY) is particularly vexing. Everything Iíve tried eventually becomes a mold/dirt magnet and requires constant maintenance. Iím about to re-caulk the fly bridge area, aft deck...

    Started by GCSI‎, 04-11-2021 11:47 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 274
    04-12-2021, 08:28 AM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts