Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 981 1 2 3 11 51 101 501 ... LastLast
Threads 1 to 20 of 19619

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1.   Sticky Threads  

  2. Sticky Thread Sticky: Acceptable Use Policy & Posting Guidelines

    Hatteras Talk Guidelines This section of the forum is for the more technical threads and topics specifically related to Hatteras yachts. Threads in this section should STAY ON TOPIC. Hatteras Owners Forum Acceptable Use Policy & Guidelines Listed below are some expectations that...

    Started by administrator‎, 08-21-2006 09:10 AM
    • Replies: 0
    • Views: 14,748
    08-21-2006, 09:10 AM Go to last post
  3.   Normal Threads  

  1. Bilge Pumps and Float switches

    Hello. Looking for commercial grade 12V Bilge Pumps and float switches. These Rule products are GARBAGE. I'm on my 2nd float switch in the same compartment within a few week period. This is a charter boat that is out 7 days a week. Cost is not a factor. Quality is. These Rule products are...

    Started by 86Hat41‎, 09-23-2020 05:35 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 428
    Today, 08:46 PM Go to last post
  2. Freshwater (saltwater) Wash Down

    Iím looking for advice on installing a fresh water washdown system and by fresh I mean lake Michigan. I have a number of thru hull fittings that are currently not in use. Most of them are for the overboard waste discharge however I have one that was for the water maker that we removed. I wonít...

    Started by Sadey‎, Today 03:22 PM
    • Replies: 4
    • Views: 63
    Today, 08:28 PM Go to last post
  3. New Fridg Going in 53MY

    Got the new fridge on board and have the doors off. Unfortunately it is just a tiny bit too big to squeeze past the AC panel next to the stairs. I anticipated that and got an oscillating multi tool so that I could remove part of it without hacking it up too much. So far so good. The fridge is an...

    Started by gondolaguy‎, 09-23-2020 07:55 AM
    3 Pages
    1 2 3
    • Replies: 24
    • Views: 407
    Today, 08:21 PM Go to last post
  4. Morning funny

    Here you go

    Started by SEVEN‎, 08-25-2017 06:04 AM
    1355 Pages
    1 2 3 ... 1355
    • Replies: 13,544
    • Views: 817,509
    Today, 06:55 PM Go to last post
  5. Have we talked about this Custom Hatteras 53' yet?

    Pretty wild conversion we have here, I wonder how she performs with the weight moved around like that. https://tampa.craigslist.org/pnl/boa/d/tarpon-springs-custom-53-fishing-boat/7190024575.html

    Started by VieEnRose‎, Today 11:07 AM
    • Replies: 4
    • Views: 119
    Today, 05:22 PM Go to last post
  6. 12 Point Alarm Error

    Came down to the boat to find a 12 Point Alarm beeping. Checked everything and found nothing but dry bilges. The Silence button will not work. At first if I taped it and used the silence a bit it would silence. If you hit test I get the for system light on 3 of 4. The bilge is not lighting...

    Started by metama‎, Today 08:07 AM
    • Replies: 8
    • Views: 107
    Today, 04:44 PM Go to last post
  7. wifi gauge senders

    My gauges need replacing and my alarm system is in-op. Was reading about analog to digital converter with NEMA or wifi outputs. So, rather than replace the originals what do you think about using the analog to digital converter, displaying gauges on a tablet or garmin display and also set the...

    Started by Chasemmc‎, 09-15-2020 09:15 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 296
    Today, 01:32 PM Go to last post
  8. What kind of chain is this?

    See picture. It's 1/4" rod diameter, overall 1.4" and inside 1" It fits my gipsy. But unless it's an especially strong chain I'm wondering if it's heavy enough for a 53MY. It's plenty long so in most water around here I can have 10:1 or even 20:1 if I want, although that would be a lot of swing...

    Started by oscarvan‎, Yesterday 08:50 PM
    • Replies: 9
    • Views: 162
    Today, 09:36 AM Go to last post
  9. Acid flush raw water system.....

    Here are the "before" pictures. Rigging the plumbing as we speak. I don't know if it's bad enough to cause it to run warm, but it certainly looks like it won't hurt. Can't seem to get them in focus but you get the idea.....

    Started by oscarvan‎, 09-22-2020 04:57 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 48
    • Views: 943
    Today, 08:02 AM Go to last post
  10. Leaky window

    My port-side galley window leaks. Has anyone had that problem? It looks like it is leaking from or through the track. Any ideas? It looks like an awful job to remove the window as itís gooped up with lots of silicone. Suggestions? Thanks Bob

    Started by Leland‎, Yesterday 06:46 PM
    • Replies: 3
    • Views: 68
    Yesterday, 08:40 PM Go to last post
  11. Rocna Anchor on a 75

    Iím about to order a 55KG (121 lb) Rocna for my 75CMY. Does anyone know if the Rocna will play nice with my pulpit? Brett

    Started by GCSI‎, 07-30-2019 09:11 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 1,522
    Yesterday, 07:08 PM Go to last post
  12. Vacuflush plumbing

    I am installing new vacuflush toilets in the two heads and will be running them both off a new 4th generation vacuum generator. I want to install a discharge pump that will allow me to discharge the tanks overboard as well. Here is a drawing of my plan for plumbing TO the tanks. Where I am a...

    Started by ageless‎, 12-18-2018 06:17 PM
    • Replies: 9
    • Views: 907
    Yesterday, 01:29 PM Go to last post
  13. Zodiac cleaner?

    Does anyone have a recommendation for an effective cleaner for the tubes on a Zodiac? Also, how about some kind of sealer to keep the dirt and grime at a minimum? Thanks...Bob

    Started by Leland‎, 09-03-2020 11:51 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 356
    Yesterday, 10:36 AM Go to last post
  14. Helm seal kit for 1976 58*yachtfisher

    Where is a good place to buy a helm seal kit FTX HS-01, and bleeding procedures for getting the rudder to work like new. Any suggestions will be greatly appreciated. Wit

    Started by witold933252763‎, 09-23-2020 09:05 PM
    • Replies: 2
    • Views: 62
    Yesterday, 09:51 AM Go to last post
  15. Helm seal kit for 1976 58*yachtfisher

    Where is a good place to buy a helm seal kit FTX HS-01, and bleeding procedures for getting the rudder to work like new.

    Started by witold933252763‎, 09-23-2020 09:03 PM
    • Replies: 1
    • Views: 36
    Yesterday, 09:30 AM Go to last post
  16. designing aft stair project

    My have a, 1989 65í motor yacht without the cockpit. Heading down the aft ladder is difficult for the family. I was thinking of a few options. The easiest thing would be to build stainless spiral stairs and attach to the swim platform and the transom, but I donít love the look. Nor do I like the...

    Started by Shayne‎, 09-17-2020 06:05 PM
    3 Pages
    1 2 3
    • Replies: 25
    • Views: 779
    09-23-2020, 10:50 PM Go to last post
  17. Aft deck hatch removal

    We owners of early 53s have been cursed with an emergency hatch on the aft deck instead of having two large hatches on the transom. Mine has been leaking, corroding, flaking for years and I finally got to the point where I couldn't stand it anymore ... Ripped it out, cut the top skin an extra...

    Started by Pascal‎, 04-28-2017 06:36 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 1,876
    09-23-2020, 10:29 PM Go to last post
  18. Search light not moving.

    Light works... but won't move from either station. Let's start with a fuse. Any suggestion for a location?

    Started by oscarvan‎, 09-12-2020 09:35 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 290
    09-23-2020, 08:40 PM Go to last post
  19. Post fresh water rinse....

    So the buildup in our raw water systems necessitating the acid flush is obviously a byproduct of mostly (alkaline) salt water..... Just like outboards a fresh water flush after running would not be a bad idea. But where to connect the hose. I have a 1/2" NPT hole in an elbow in the intake before...

    Started by oscarvan‎, 09-22-2020 07:54 PM
    2 Pages
    1 2
    • Replies: 15
    • Views: 299
    09-23-2020, 08:10 PM Go to last post
  20. Boat level when polishing fuel

    Last year before launching after the repower in the yard I had the old fuel pumped out and the tanks cleaned. Well as much as you can clean them with the baffles After about 25 hours on the mains and 60 on the gen i Looked at the main racor bowls and found them yucky with slime. The 30 microns...

    Started by Pascal‎, 12-08-2019 09:23 PM
    • Replies: 5
    • Views: 502
    09-23-2020, 07:25 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 316 users browsing this forum. (6 members & 310 guests)

  1. Holiday
  2. barkdee
  3. svan216
  4. pmurphy
  5. metama
  6. Salty lady

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts