Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 1111 1 2 3 11 51 101 501 1001 ... LastLast
Threads 1 to 20 of 22203

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1.   Sticky Threads  

  2. Sticky Thread Sticky: Acceptable Use Policy & Posting Guidelines

    Hatteras Talk Guidelines This section of the forum is for the more technical threads and topics specifically related to Hatteras yachts. Threads in this section should STAY ON TOPIC. Hatteras Owners Forum Acceptable Use Policy & Guidelines Listed below are some expectations that...

    Started by administrator‎, 08-21-2006 09:10 AM
    • Replies: 0
    • Views: 20,303
    08-21-2006, 09:10 AM Go to last post
  3.   Normal Threads  

  1. Electrical switch identification

    I am stumped by a set of electrical switches in my galley. The switch is located near the steps down to the engine and state rooms. There are 3 light switches in a vertical row. 1 for the ac circuit to the light over the galley table. Another ac switch for the fluorescent galley overhead light....

    Started by Kquaine‎, Today 01:03 AM
    • Replies: 4
    • Views: 63
    Today, 02:24 PM Go to last post
  2. Morning funny

    Here you go

    Started by SEVEN‎, 08-25-2017 06:04 AM
    3746 Pages
    1 2 3 ... 3746
    • Replies: 37,456
    • Views: 4,714,482
    Today, 02:19 PM Go to last post
  3. Transom drawings / thickness / swim platform plates? 1980 53 MY

    Transom drawings / thickness / swim platform plates? 1980 53 MY Does anyone have drawings or cross sections of the transom thickness plate locations etc. Trying to figure out if its possible to have a large swim platform that carries a dinghy and/or could withstand the weight of the dinghy...

    Started by Bob Quinn‎, Yesterday 06:35 AM
    • Replies: 9
    • Views: 124
    Today, 02:17 PM Go to last post
  4. Blackwater tanks questions.

    Just got her back from the boatyard after, among other things, having all of the blackwater hoses replaced. I've looked everywhere but I can't seem to get a consensus on holding capacity and which tank was connected to which head. I've read that the VIP and forward head are connected to the front...

    Started by RJM‎, Today 12:14 PM
    • Replies: 1
    • Views: 13
    Today, 01:55 PM Go to last post
  5. Electrical

    My boat has a 120/240 input and a 240 only on each side. When I hook up to the 120/240 output of my marina am I only getting 120 ? If I hook up the 120/240 to the 240 would I get 240? An electrician friend told mine to me the 120/240 is three phase and the 240 single phase. Asking because my...

    Started by Dragonten‎, 06-04-2024 08:21 AM
    3 Pages
    1 2 3
    • Replies: 27
    • Views: 1,596
    Today, 12:18 PM Go to last post
  6. Am I a fool to put a 60 amp fuse in my 50 amp shore power socket?

    When it gets real hot outside we are popping fuses on one of our shore power lines. We are getting smarter about alternating the different loads we are using, and i have cleaned the sockets and added grease to the fuses. The previous owner used 60 amp fuses, but the 50 amp ones I am using get...

    Started by nmcafee‎, Yesterday 06:34 PM
    • Replies: 8
    • Views: 129
    Today, 09:48 AM Go to last post
  7. Holding Tank Fitting Replacement Presenting a Challenge

    So I discovered that I had a crack in the 1" Street Elbow fitting on top of my blackwater holding tank that would spew some blackwater each time the V bunk head got flushed. Obviously this led to some unpleasantries. Merely touching the elbow to analyze the situation made it crumble (looks to be...

    Started by IOLANI‎, 06-21-2024 09:30 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 260
    Today, 09:40 AM Go to last post
  8. Hobbs Meter Running Fast

    Three days of 6+ hours of running and Iíve now verified my starboard engine Hobbs is running fast. I religiously copy down hours run after each calendar dayís run so Iím sure itís fast. Anybody else have this problem or the solution?

    Started by Sadey‎, 06-21-2024 08:59 PM
    • Replies: 5
    • Views: 109
    Today, 09:12 AM Go to last post
  9. Electrical switch identification

    Sorry duplicate post. See original post.

    Started by Kquaine‎, Today 01:15 AM
    • Replies: 0
    • Views: 43
    Today, 01:15 AM Go to last post
  10. excellent silicone hose source

    https://www.siliconehose.com/ I've done business with this company now a number of times and I thought I'd pass it along. Direct sales and prompt shipping. They are manufacturers and offer usda food grade, marine exhaust, wire helix, straight hose, flex hose, bends and all manner of connectors. ...

    Started by bostonhatteras‎, 06-20-2024 03:06 PM
    • Replies: 9
    • Views: 254
    Yesterday, 11:31 AM Go to last post
  11. 1990 Hatteras 52 Cockpit Motor Yatch 8V-92TA Engines

    I am a new owner in the UK. I have a few issues with fresh water in the starboard engine. Any advice before we start pulling it to pieces would be very helpful. Thank you

    Started by stevec1‎, 06-05-2024 06:23 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 1,027
    06-21-2024, 05:30 PM Go to last post
  12. Onan 15kw starts but shuts down when releasing the start button

    Any thoughts? It fires right up, voltage comes up fine, but as soon as I let off the start button it shuts down. Stumped! Any ideas? Thanks!

    Started by Bob Quinn‎, 06-05-2024 09:26 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 1,054
    06-21-2024, 01:54 PM Go to last post
  13. The near on side entrance doors.

    I installed a veneer on the inside panel of both side doors because they leaked water in the past and turn the bottom of the panel jet black. I always hated that look and decided to veneer it. The first photograph is the veneer with one coat of varnish. Obviously it was not going to match so I got...

    Started by SEVEN‎, 06-19-2024 11:32 PM
    • Replies: 4
    • Views: 191
    06-21-2024, 01:47 PM Go to last post
  14. bow pulpit teak, greyed out bad, alternatives to just teak cleaner?

    My bow pulpit is completely grey. I tried multiple attempts using cleaner / brightener /teak oil last year. It only partially cleared up, and went right back to grey after just a couple months. So.... what about a brown toned deck sealer or just flat out paint it? I've also considered...

    Started by Bob Quinn‎, 06-17-2024 08:15 AM
    3 Pages
    1 2 3
    • Replies: 20
    • Views: 658
    06-20-2024, 09:53 PM Go to last post
  15. 1996 CPMY | Ash Wood Veneer | Refinish Question

    Hi all,I made the mistake of misting my ash wood veneer with scented oils and it's created a real headache for me. See picture. There's some water stains from windows leaking and the finish is already heavily worn in high traffic areas, so I guess I'm starting this process now rather than later....

    Started by Victory52‎, 06-20-2024 12:27 PM
    • Replies: 2
    • Views: 146
    06-20-2024, 06:07 PM Go to last post
  16. Racor PMOR2020 Filters

    Anyone have a source for cases of filters at s good price?

    Started by Bob Bradley‎, 06-18-2024 09:51 AM
    • Replies: 6
    • Views: 248
    06-20-2024, 05:04 PM Go to last post
  17. Swim platform edge fenders?

    I keep our dinghy, currently a Boston Whaler tied up behind the swim platform. Regular round fenders tend to get pushed out of the way and the tender just doesn't sit well with them. I have been searching for something that would run along the edge of the swim platform, like a bump rail kind of...

    Started by Bob Quinn‎, 06-19-2024 07:32 PM
    • Replies: 9
    • Views: 185
    06-19-2024, 09:33 PM Go to last post
  18. Starlink High Performance Antenna Cover

    I have the Starlink High Performance Antenna (Gen 3) and I plan on installing it on my 53í Hatteras hardtop. I would like to have a protective cover to protect it from birds/hail and to keep moisture out of the connection. I have searched the internet, but canít really find what I want. Any...

    Started by Jwatson‎, 06-18-2024 10:02 AM
    • Replies: 6
    • Views: 245
    06-18-2024, 05:23 PM Go to last post
  19. Loosing my mind with Mahogany rails.... again

    So last year I sanded my rails, again as I didn't get enough coats of Awlgrip on. Again one rail not enough coats apparently as per pic below. Do I have any options to fix the white peeled areas or do I have to sand again?

    Started by Bob Quinn‎, 06-13-2024 10:29 AM
    • Replies: 9
    • Views: 431
    06-18-2024, 02:42 PM Go to last post
  20. Taps on the internal transformers?

    I was reading the threads about rewiring the transformers to boost the shore power. Is there only one option for a 10% boost or are there multiple taps available. I'm only getting 180 Volts from my shore power. If only 10% is available that would get me 198, but that still is no where near...

    Started by Bob Quinn‎, 06-17-2024 06:36 PM
    • Replies: 5
    • Views: 171
    06-18-2024, 12:40 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 193 users browsing this forum. (4 members & 189 guests)

  1. johnjen50
  2. dar636
  3. Kquaine
  4. Captain Ralph

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts