Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 939 1 2 3 11 51 101 501 ... LastLast
Threads 1 to 20 of 18764

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1.   Sticky Threads  

  2. Sticky Thread Sticky: Acceptable Use Policy & Posting Guidelines

    Hatteras Talk Guidelines This section of the forum is for the more technical threads and topics specifically related to Hatteras yachts. Threads in this section should STAY ON TOPIC. Hatteras Owners Forum Acceptable Use Policy & Guidelines Listed below are some expectations that...

    Started by administrator‎, 08-21-2006 09:10 AM
    • Replies: 0
    • Views: 14,208
    08-21-2006, 09:10 AM Go to last post
  3.   Normal Threads  

  1. DDEC Owners Manuals?

    We recently acquired (last week) a 1997 43' Hatteras Express Sport equipped with 6V92TA's tweaked up to 625hp. I Know, "hand grenades with loose pins". Absolutely no manuals on anything. Second boat with DD's, but first one with DDEC. Also owned and/or operated boats with Cats, Cummins, Yanmar,...

    Started by arcreefer‎, 07-22-2019 10:19 PM
    • Replies: 3
    • Views: 84
    Today, 05:15 PM Go to last post
  2. Troubleshooting stalling Detroit Diesel 6V92

    I have a 1996 43' Express with twin Detroit Diesel 6V92's. The problem I have is as follows: If I start the Starboard engine first and then start the Port engine second during the starting of the Port Engine the Starboard engine loses RPM's and stalls. If I reverse the sequence starting the...

    Started by hfschwing‎, 02-14-2019 05:04 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 32
    • Views: 1,610
    Today, 05:12 PM Go to last post
  3. Morning funny

    Here you go

    Started by SEVEN‎, 08-25-2017 06:04 AM
    704 Pages
    1 2 3 ... 704
    • Replies: 7,039
    • Views: 272,014
    Today, 05:11 PM Go to last post
  4. 43MY trim tab size

    Does anyone know the size of the original trim tabs for my 43’ my? Mine are only about 6x18 which seems small.

    Started by gmcop1‎, Today 01:56 PM
    • Replies: 2
    • Views: 14
    Today, 02:59 PM Go to last post
  5. new wheels

    We ended up going with Veem Conquest propellers, 21x21, moderate cup, four blades. But them on today- immediately noted that the boat is much smoother, and that midrange speed significantly improved. I have not done full power runs yet, to make sure she is not overpropped, but the early indications...

    Started by jim rosenthal‎, 08-05-2019 04:51 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 609
    Today, 12:42 PM Go to last post
  6. What is your convertibles bridge clearance?

    For you Convertible owners what is your model and your bridge clearance with electronics on top. Thanks.

    Started by Eddieclemons‎, 09-12-2019 04:16 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 233
    Today, 10:10 AM Go to last post
  7. Installing Power to TVs

    I have been installing TVs in the staterooms and trying to figure out the best way to get power to them. The master television is mounted on a swing arm in front of the closet. I was planning on using the power to the closet light, but that may be harder than running power from the A/C unit. Same...

    Started by Photolomy‎, 09-13-2019 01:51 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 251
    Yesterday, 03:03 PM Go to last post
  8. New Anchor Chain--The Fun Begins

    Received a 200' drum of 1/2" G43 chain, at my loading dock upstate, while I was hanging out at Hilton Head avoiding Dorian. Handling here is no sweat. Handling at my marina will be sweat-worthy. Gotta get it marked plus make up a new bridle(s). Think I'm going to link it to the existing...

    Started by racclarkson@gmail.com‎, 09-09-2019 11:54 AM
    3 Pages
    1 2 3
    • Replies: 20
    • Views: 537
    Yesterday, 01:00 PM Go to last post
  9. 12v71 TI Detroit’s

    I have seen hp ratings of , 650,750 850 etc. for these motors . Were they special from J/T , Covington ? What are the differences, heads,injectors, turbos ? Can you easily rebuild a 650 hp motor to 850hp ? Regards, Edward

    Started by edward‎, 09-01-2019 11:45 AM
    6 Pages
    1 2 3 ... 6
    • Replies: 53
    • Views: 1,428
    Yesterday, 10:24 AM Go to last post
  10. Bitter End anchor

    Finally getting around to attaching a nylon rope to bitter end of our anchor chain. Looking in the locker, don't see anything solid to tie it off to. Suggestions? Also, what do i measure to determine the size of the existing chain?

    Started by Chasemmc‎, 09-08-2019 02:17 PM
    3 Pages
    1 2 3
    • Replies: 20
    • Views: 567
    09-13-2019, 09:54 AM Go to last post
  11. Galley Refit

    I am getting ready to redo the galley. The countertop, sink, cooktop and convection microwave with integral vent. I have fallen out of love with the original ModernMaid oven.:) Probably going with solid countertop, not granite. The dishwasher (under cooktop) and fridge are pretty new and stainless,...

    Started by Photolomy‎, 09-11-2019 01:00 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 344
    09-12-2019, 10:42 AM Go to last post
  12. Blower motor of AC goign bad

    After 8 years, the blower motor of the Ocean Breeze 16500 BTU unit has lost some bearings. It is making a loud noise when it runs. I checked the cage inside the housing and it is clean, not rubbing against anything and it is not loose. I called ocean beeze. They told me that I can't just...

    Started by akintosyali‎, 09-08-2019 07:16 PM
    • Replies: 4
    • Views: 137
    09-11-2019, 05:07 PM Go to last post
  13. Onan MDJE Raw Water Pump Not Pushing Water/ Cure

    My Onan MDJE raw water pump stopped pumping water this year. I would help it get prime and it would pump for awhile, but then act erratically. Finally, I was out for a short day cruise, running the genny underway, and she lost prime again, overheating, losing internal coolant and the overheat...

    Started by spartonboat1‎, 08-20-2017 11:55 PM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 3,971
    09-11-2019, 09:19 AM Go to last post
  14. gennie room blower

    Can't find the switch. Other blower switches at main helm station. Motor located behind washer dryer. Any clue where to find?

    Started by Chasemmc‎, 09-08-2019 01:49 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 265
    09-10-2019, 10:13 PM Go to last post
  15. Naval Architect in SE FL?

    I’d like to get someone that is well-versed in Classic Hatteras to come on board for a preliminary assessment (I’m willing to pay for the time) to determine feasibility and some basic ideas on the following: - repower with something that will cruise occasionally at 20 knots, but primarily 10...

    Started by nautibake‎, 09-09-2019 07:06 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 218
    09-10-2019, 12:08 PM Go to last post
  16. Cruisair heat pump control system problem…I think

    1984 53’ Extended Deckhouse Using the old mechanical Honeywell T6052B thermostats. Previous owner modified the boat pretty extensively and in the process removed the thermostat that I BELIEVE would have been in the galley. The galley and the v-berth systems run off of one compressor. ...

    Started by Nick in Manitou‎, 08-10-2019 04:18 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 296
    09-10-2019, 10:06 AM Go to last post
  17. 46 Convertible refit begins

    Hi All,The dream of refitting the 46 became a reality yesterday when we finally put the old girl on a hard stand in western Sydney. My friend Mick D and I are joint owners of the boat and we intend on doing most of the work ourselves.Our plan is to repower and completely refit the boat including...

    Started by Mick c‎, 07-26-2019 07:33 PM
    7 Pages
    1 2 3 ... 7
    • Replies: 65
    • Views: 2,784
    09-10-2019, 10:01 AM Go to last post
  18. 1979 hatteras 58 yacht fisherman

    I am thinking of buying a 1979 58 Yacht Fisherman. The owners tell me that the mid-line headroom in each cabin is 6 foot 3 inches...which is almost certainly wrong not least because headroom will vary from cabin to cabin in almost every boat I have ever sailed aboard. I am six foot 4 1/2...

    Started by Peter Hayes‎, 09-09-2019 02:03 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 381
    09-09-2019, 11:49 PM Go to last post
  19. MDJF Onan 15 kw

    Looking for onan part# 149-1046. Rebuild kit for my weeping fuel pump. Cant find one. Any ideas?

    Started by Capt Chad‎, 09-07-2019 02:32 PM
    • Replies: 6
    • Views: 174
    09-09-2019, 11:03 PM Go to last post
  20. NAPA 8D Batteries: any good?

    I need to replace the 8Ds in my inverter bank and NAPA has a replacement for a good price, just over $600 (less with discounts). They are the same 1450cca, 245@20ah batteries, but seem to weigh a bit more than the Lifelines and Trojans I found online. Has anyone had any experience with them? Or...

    Started by Westfield 11‎, 09-09-2019 07:08 PM
    • Replies: 6
    • Views: 151
    09-09-2019, 10:42 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 171 users browsing this forum. (6 members & 165 guests)

  1. sgharford
  2. NC Hatteras
  3. Colwyn D
  4. SEVEN
  5. madhatter1
  6. howhomes

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts