Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 944 1 2 3 11 51 101 501 ... LastLast
Threads 1 to 20 of 18875

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1.   Sticky Threads  

  2. Sticky Thread Sticky: Acceptable Use Policy & Posting Guidelines

    Hatteras Talk Guidelines This section of the forum is for the more technical threads and topics specifically related to Hatteras yachts. Threads in this section should STAY ON TOPIC. Hatteras Owners Forum Acceptable Use Policy & Guidelines Listed below are some expectations that...

    Started by administrator‎, 08-21-2006 10:10 AM
    • Replies: 0
    • Views: 14,255
    08-21-2006, 10:10 AM Go to last post
  3.   Normal Threads  

  1. what wipers for 38c series 1

    Does anyone know what shaft length is required when sourcing replacement wiper motors (a 1972 38c) also optimal arm length and blade size. Regrettably the boat is currently in a cargo ship hold so we cannot measure ourselves and only have a very narrow time window to order a new pair for various...

    Started by gilesosborne‎, Today 09:24 PM
    • Replies: 0
    • Views: 4
    Today, 09:24 PM Go to last post
  2. Morning funny

    Here you go

    Started by SEVEN‎, 08-25-2017 07:04 AM
    807 Pages
    1 2 3 ... 807
    • Replies: 8,064
    • Views: 344,380
    Today, 09:10 PM Go to last post
  3. Generator Muffler Advice

    Centek Vernalift muffler. I'm replacing the exhaust hoses. Do I just replace the muffler too while I'm there because it's 18 years old, or do they never go bad?

    Started by Jammin'‎, 11-16-2019 04:08 PM
    3 Pages
    1 2 3
    • Replies: 23
    • Views: 464
    Today, 07:36 PM Go to last post
  4. Turbo Failure

    When I pulled up the carpet I noticed a small exhaust leak coming from between the exhaust and air side on the port outboard turbo. I pulled it off and low and behold their were metal parts inside and a lot of oil on the exhaust side. 2 pieces found inside the turbo are laying on the air inlet...

    Started by Capt Chad‎, 11-14-2019 09:26 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 443
    Today, 06:18 PM Go to last post
  5. AC Panel Replacment Gauges

    1986 63 MY. Anyone source digital replacements for the AC gauges on the power panel? I have not opened the panel to measure dimensions yet, but they are rectangular with long side horizontal. Several have died and I'd like to replace all (volts, amps, hz) with digital. John MCarley Water...

    Started by divert00‎, Today 02:14 PM
    • Replies: 0
    • Views: 43
    Today, 02:14 PM Go to last post
  6. Belt Upgrade? Trying something different.

    I usually replace belts once every two years unless we put an extreme amount of hours on one season. So tis the time and tis the season. I went to order a couple new matched sets at napa last week and was informed that gates no longer sold matched sets that all their belts were within spec to...

    Started by rustybucket‎, Today 10:21 AM
    • Replies: 3
    • Views: 80
    Today, 12:34 PM Go to last post
  7. Trouble shooting Princess stove

    My 120 Volt Princess stove popped the breaker. Upon examination I found that the oven control switch was loose and rotated into contact with the frame. After fixing that I noticed that even with the breaker off I was getting electrical tingle when touching the frame and the toggle switches. If...

    Started by rob71‎, 11-16-2019 10:35 PM
    • Replies: 2
    • Views: 84
    Today, 10:37 AM Go to last post
  8. Mach 5 Headhunter pump

    I just installed a new Mach 5 fresh water pump on my 55 SF as recommended by Hatteras. It frequently shuts itself off and I have to turn the breaker on and off (breaker is not tripped) then it comes back on. Seems frequent when using the ice chipper. My friend has the same pump on his Bertram...

    Started by Thomas.misskelly‎, 11-16-2019 01:15 PM
    • Replies: 3
    • Views: 118
    Today, 10:26 AM Go to last post
  9. Toilet Paper?

    Okay live aboards, what do you use? We have GM pumps and plan to live aboard in the summer so these are the questions that I think of of in the early hours.

    Started by Sadey‎, Today 07:56 AM
    • Replies: 3
    • Views: 96
    Today, 09:22 AM Go to last post
  10. Hull numbers wanted

    Just a suggestion to all members, thought it would be a great idea that you post your hull number after your signature. This way if you see a current boat with close hull numbers you can reach out to those members. I think it could bring the forum even closer together. This is what mine looks like.

    Started by SEVEN‎, 11-14-2018 08:32 PM
    12 Pages
    1 2 3 ... 12
    • Replies: 117
    • Views: 6,004
    Yesterday, 09:53 PM Go to last post
  11. Black water tank gauge 60c

    Did the series 1 60 convertible come equipped with a waste tank level gauge? If not, can one be retrofitted? On my 1983 the hoses from the galley maid head pumps disappear into a tank on the forward edge of the engine room just aft of the pump room. Is the tank physically in the belly of the...

    Started by oceanjake‎, 11-16-2019 08:36 PM
    • Replies: 6
    • Views: 132
    Yesterday, 08:30 PM Go to last post
  12. Hatteras wiring diagrams

    I'm studying the blueprints hoping to identify some circuits and came across a very helpful key for wire markings: 1-99. Miscellaneous 100-599. DC system 600-699. Ships service 1 700-799. Ships service 2 800-999. 240v ships service 1000-1099. Safety center Unfortunately the key doesn't...

    Started by davidwigler‎, 01-20-2013 09:26 PM
    • Replies: 2
    • Views: 2,694
    Yesterday, 07:57 PM Go to last post
  13. Windscreen Wiper Issue

    The middle 32 volt windscreen wiper did not work and fuse was blown. Replaced fuse with 10amp fuse and wiper now works slowly compared to the other two wipers. I am wondering if there might be a way to loosen up the motor shaft mechanism from the outside. ie. remove blade and panagraph arm...

    Started by scottinsydney‎, 11-16-2019 07:21 PM
    • Replies: 2
    • Views: 82
    Yesterday, 02:07 AM Go to last post
  14. One mor vacuflush question

    Pump was cycling. Traced leak to head where actuator goes through the side to flush. Series 800. Looked up parts diagram online since book seemed vague on parts. Found same diagram online. Only part I can see possible to replace is the cartridge part number 385236096. But the issue is leaking air...

    Started by madhatter1‎, 11-16-2019 12:32 PM
    • Replies: 0
    • Views: 55
    11-16-2019, 12:32 PM Go to last post
  15. Vacuflush duckbill replacement

    I have a pair of VG2 vacuum generators on my boat. Both have been untouched for 17 years since new and one of the systems is starting to leak vacuum. The VG2 has a pair of duckbills on either side of the vacuum generator pump. How do you guys back out the male coupler with solid threads on the...

    Started by Reefgeorge‎, 11-12-2019 11:32 PM
    • Replies: 4
    • Views: 156
    11-16-2019, 10:51 AM Go to last post
  16. Sanihose removal and reuse

    What are your most successful methods for removing sanihose connections with minimal damage to allow successful leak free reattachment? Thanks, George

    Started by Reefgeorge‎, 11-13-2019 03:25 PM
    • Replies: 7
    • Views: 204
    11-15-2019, 03:51 PM Go to last post
  17. ONAN 20 kw Over rev shutdown

    Oh no, it's an ONAN. During last weekends trip, I gave the generator a good workout. Ovens, AC, hot water heater, chargers, all the usual stuff. After about 8 running hours funny things began to occur. First, the forward AC began making a clicking sound like a auto turn signal. Then the...

    Started by Passages‎, 11-14-2019 03:33 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 305
    11-15-2019, 02:05 PM Go to last post
  18. 61' motor yacht new canvas

    I have a 61' CPMY and am down in St Maarten and need to replace all the vinyl on my aft deck and the drops up on the flybridge. The Bimini is newer and does not need replacement. Here is the quote I just received. I specified Strataglass for all the clear windows. $14,000 was the quote. This is...

    Started by rourkeh‎, 11-14-2019 02:41 PM
    • Replies: 1
    • Views: 94
    11-14-2019, 03:12 PM Go to last post
  19. Hatteras 36c

    Hey guys Im new to this group, I purchased a 1970 Hatteras 36c that is in really good condition other then a few cosmetic things but what can you expect on a 49 year old boat. I was just curious if anyone on here owns a 36c and had a spec sheet or a build sheet on the boat, and also what you love...

    Started by cmk1344‎, 11-11-2019 11:03 PM
    • Replies: 3
    • Views: 169
    11-14-2019, 02:28 PM Go to last post
  20. Cockpit Mezzanine & Tuna Tube Winter Project

    Ok, so trying to get my final plans together for two pretty major wintertime projects on SOUTHPAWS. I'll be doing both these projects in tandem so only one single huge mess will be made on the boat. Hope to finish both projects off before april-ish. Be forewarned, these projects may upset the...

    Started by rustybucket‎, 01-07-2019 12:57 PM
    16 Pages
    1 2 3 ... 16
    • Replies: 150
    • Views: 10,983
    11-13-2019, 09:41 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 174 users browsing this forum. (3 members & 171 guests)

  1. polpaul
  2. northshoreone
  3. OurHatt41

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts