Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 1049 1 2 3 11 51 101 501 1001 ... LastLast
Threads 1 to 20 of 20962

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1.   Sticky Threads  

  2. Sticky Thread Sticky: Acceptable Use Policy & Posting Guidelines

    Hatteras Talk Guidelines This section of the forum is for the more technical threads and topics specifically related to Hatteras yachts. Threads in this section should STAY ON TOPIC. Hatteras Owners Forum Acceptable Use Policy & Guidelines Listed below are some expectations that...

    Started by administrator‎, 08-21-2006 09:10 AM
    • Replies: 0
    • Views: 16,191
    08-21-2006, 09:10 AM Go to last post
  3.   Normal Threads  

  1. Aft deck ceiling / weather board repaint?

    Any suggestions on what to use on the aft deck ceiling? I have the popcorn looking texture. The stainless bolts and hardware all have corrosion / green or grey and crusty. I'm assuming just replace that stuff, i.e. remove, paint then reinstall new hardware. If anyone has redone this area I...

    Started by Bob Quinn‎, Yesterday 08:16 AM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 222
    Today, 12:48 AM Go to last post
  2. Morning funny

    Here you go

    Started by SEVEN‎, 08-25-2017 06:04 AM
    2573 Pages
    1 2 3 ... 2573
    • Replies: 25,720
    • Views: 2,269,151
    Today, 12:40 AM Go to last post
  3. Flybridge Drainage

    On my 1981 53MY I get water accumulating in the front part of the Helm Station under the long seat in the front. Upon inspection there is just one scupper hole in the rear port side of the pedestal. Since the floor is curved water won't drain from the starboard front corner to the rear I...

    Started by Dragonten‎, Yesterday 11:01 PM
    • Replies: 0
    • Views: 18
    Yesterday, 11:01 PM Go to last post
  4. Flybridge Cabinet Doors

    The small doors on the port side of my 53MY helm station on the flybridge are rotting. I need to replace them and curious if anyone else has done so. What material did you use? Plastic or wood? Where did you get them? The original doors are some type of wood painted with the hull color. ...

    Started by Dragonten‎, 06-26-2022 10:14 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 204
    Yesterday, 06:23 PM Go to last post
  5. Power select breaker

    Just of of the phone with Jeremy. As always a terrific help. Just before I tell the owner to call with his credit card info, I need to check in with you kids. The shore side of this dual breaker package is weak. You can swap shore cables at the boats in service an the same breaker may hum and...

    Started by Captain Ralph‎, Yesterday 02:44 PM
    • Replies: 0
    • Views: 41
    Yesterday, 02:44 PM Go to last post
  6. Hot Water

    Reduced hot water pressure all faucets. Have hot water, screens clean new relief valve. Any suggestions where to look for obstruction. Cold water great. Thanks Werner Schoenkneht MIRAGE

    Started by Werner Schoenknecht‎, 06-23-2022 07:15 AM
    • Replies: 6
    • Views: 232
    Yesterday, 02:14 PM Go to last post
  7. VDO gauges

    Happy Fatherís Day looking for input 1989 65 MY all gauges work Properly on lower helm upper helm starboard gauges are pegged High including RPM gauge never happened before any ideas what Is wrong input would be appreciated 😊😊

    Started by major hattitude‎, 06-19-2022 11:27 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 432
    Yesterday, 12:25 PM Go to last post
  8. Hand rail refinishing / finish repair question

    So 70 percent of the handrails look o.k. I have a section that the varnish or urethane is peeling off on. Just for kicks I brushed on some Teak oil. The sections were the urethane had peeled off and the wood was white turned basically black. I know teak oil is not the solution, but why would it...

    Started by Bob Quinn‎, Yesterday 08:10 AM
    • Replies: 5
    • Views: 88
    Yesterday, 12:25 PM Go to last post
  9. Racor checkball removal ?

    Running in rough water I experienced engine shutdown due to sludge obstructing the checkball on my Racor 900 filter. I had the tanks cleaned (at least thatís what I thought I payed for) only to have it happen again. Both times I was able to get home by changing the filter element but the vacuum...

    Started by llldks‎, 06-26-2022 06:19 AM
    2 Pages
    1 2
    • Replies: 19
    • Views: 396
    Yesterday, 11:16 AM Go to last post
  10. Odd Stereo Problem

    Iím finally getting around to redoing the sound system in our boat. One stereo system runs the galley, VIP stateroom and the crewís stateroom speakers. Two speakers per location. Thereís another stereo that runs just the master stateroom speakers. The midstate, galley, and forward crewís room have...

    Started by Sadey‎, 06-26-2022 03:47 PM
    • Replies: 2
    • Views: 130
    Yesterday, 07:29 AM Go to last post
  11. Hits just keep on coming.

    Found no 12v power on the bridge which lead me to a dead mastervolt 12/20-3 battery charger. Traced 120v to the connection, other connections are solid but unit does nothing. Only change was replacing the battery with a new Lifeline AGM. Unit isnít hot, doesnít smell burnt, guess it decided the new...

    Started by ageless‎, 06-27-2022 11:55 AM
    • Replies: 3
    • Views: 149
    06-27-2022, 01:28 PM Go to last post
  12. Northern Lights Genny

    I finally got around to doing a service on the genny in my new boat. It's a NL with a Luggar engine. Basic maintenance, including oil change, fuel filters, air filter cleaning, impeller, and antifreeze change. It did smoke a bit more than my old genny and I found the air filter foam dirty and...

    Started by Bob Bradley‎, 06-25-2022 09:29 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 283
    06-27-2022, 11:10 AM Go to last post
  13. Sterling Hatteras White

    I found some old paint in the garage. Sterling Hatteras White and primer. Iím guessing it is 16 years old. I donít think the primer was opened but a little was used from the paint. Is this paint any good? Does anyone have a use for it?

    Started by tonytrakovich‎, 06-27-2022 09:45 AM
    • Replies: 2
    • Views: 90
    06-27-2022, 09:48 AM Go to last post
  14. AC issue

    Hello all! I have two cruiseair systems on the boat, but the one for the salon won't turn on, but the air handler does. There's a dedicated breaker in the salon for each unit and in the engine room, there's one cruiseair breaker for both That then goes to a relay box where each AC and the pump...

    Started by workingonadream‎, 06-26-2022 02:27 PM
    • Replies: 4
    • Views: 131
    06-27-2022, 09:10 AM Go to last post
  15. 56MY anchor / Nav lights are crisscrossed

    I want to replace Nav lights which were not working. The only thing changes was the actual fixtures.Now the stern light and starboard light come one when switch is part way out. The port light comes in with switch all the way out.Does anyone know where wires come together.The back of the switch...

    Started by pmacFL‎, 06-23-2022 05:13 PM
    • Replies: 5
    • Views: 179
    06-25-2022, 10:36 PM Go to last post
  16. 24 Volt Lithium House Bank Upgrade- Silent Ship

    Following the removal of the broken #1 Kohler genset, we now have extra floorspace in the genset room and new wall space on the front bulkhead. There is now only the 20Kva Phasor genset which meets all our power needs. So its time to start planning for next project.... the Silent Ship. The...

    Started by scottinsydney‎, 03-21-2021 11:10 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 47
    • Views: 5,772
    06-25-2022, 07:51 PM Go to last post
  17. Maretron vs navico N2K backbone

    Good morning. Iím in the beginning stages of replacing my Simrad AP22-based auto pilot system with a new Simrad NAC3 AP 44 system. My question is whether in creating the backbone of the N2K system would it be worth it to spend the extra coin on Maretron backbone components. The Navico components...

    Started by bostonhatteras‎, 06-05-2022 09:20 AM
    • Replies: 3
    • Views: 132
    06-25-2022, 07:35 PM Go to last post
  18. How to clean hull

    My 1989 40DC is on the Tennessee River. My boat cleaner was trying to clean the brown stuff above the waterline and told me (I live out of state) he stopped because it looked like the blue strip (Dupont Enamel, I checked) was starting to come off with whatever acid he was using. Does anyone have...

    Started by cnairn‎, 06-18-2022 10:24 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 402
    06-25-2022, 08:49 AM Go to last post
  19. Speco 40-RP/4 ohms

    Need to replace 4 speco SPC-40RP / 4ohms hailers. Can not find any on internet. There are lots of 8ohm units. Any help is appreciated. Russ

    Started by questover‎, 06-24-2022 03:49 PM
    • Replies: 2
    • Views: 87
    06-24-2022, 07:12 PM Go to last post
  20. 41c hull angle for transducer

    Anyone know what the hull angle is? Iím trying to buy a transducer

    Started by Messi‎, 06-23-2022 09:45 PM
    • Replies: 5
    • Views: 119
    06-24-2022, 02:48 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 200 users browsing this forum. (1 members & 199 guests)

  1. Phasma2128

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts