Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1 of 964 1 2 3 11 51 101 501 ... LastLast
Threads 1 to 20 of 19264

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1.   Sticky Threads  

  2. Sticky Thread Sticky: Acceptable Use Policy & Posting Guidelines

    Hatteras Talk Guidelines This section of the forum is for the more technical threads and topics specifically related to Hatteras yachts. Threads in this section should STAY ON TOPIC. Hatteras Owners Forum Acceptable Use Policy & Guidelines Listed below are some expectations that...

    Started by administrator‎, 08-21-2006 09:10 AM
    • Replies: 0
    • Views: 14,562
    08-21-2006, 09:10 AM Go to last post
  3.   Normal Threads  

  1. Hynautic Mil spec 5606 alternative

    I am having my steering arm rebuilt and would like to know some alternatives to the Hynautic 5606 steering fluid. I know Phillips 66 is compatible. Is Teleflex SeaStar Hydraulic Fluid HA-5430 a compatible alternative or Seastar HA 5430H? I can get a gallon and of Phillips 66 on amazon for $43...

    Started by Jwatson‎, 02-10-2018 11:30 AM
    2 Pages
    1 2
    • Replies: 12
    • Views: 673
    Today, 06:18 AM Go to last post
  2. Belching Fuel During Fill-Up

    I'm not sure if there was originally a check valve or something installed to prevent this, but whenever I top off my tanks, no matter how careful I try to be, I always wind up with about 2 tablespoons worth of fuel belching from my vents. Needless to say, by the third tank it is obvious to anyone...

    Started by Play'N Hooky Too‎, 05-27-2020 04:20 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 238
    Today, 05:48 AM Go to last post
  3. ignition switch oddites

    sometimes my port motor stalls out if idling through a no wake for extended periods. I assume I need a tune up But im sure it could be many things. Seems to run fine when moving good. 989 hours on that motor. Anyway when it does stall I try and restart it. But the key will only bring up power tachs...

    Started by Hopffc2003‎, Yesterday 07:47 PM
    • Replies: 6
    • Views: 55
    Today, 12:50 AM Go to last post
  4. MTU 8v331 diesel engine

    I was asked a question about a company I know nothing about, MTU diesel engines. It was about a specific engine their 8V331. If anyone on here knows anything about these I'll pass it along to Paul. I have never even been on a boat with MTU engines.

    Started by Byresch‎, 05-28-2020 10:09 PM
    • Replies: 8
    • Views: 160
    Yesterday, 10:25 PM Go to last post
  5. Morning funny

    Here you go

    Started by SEVEN‎, 08-25-2017 06:04 AM
    1152 Pages
    1 2 3 ... 1152
    • Replies: 11,519
    • Views: 613,475
    Yesterday, 07:06 PM Go to last post
  6. 1989 Hatt 52 Conv in Montauk

    Over the weekend we drove out to check on our Ocean yacht and decided to stop by and look at a 1989 52 Convertible. The boat sat on the land for 4 years. This boat is listed super low so I had to take a look. Here are the details that worry me in order. 1. One 8c92 has 4400 hours the other has...

    Started by Canyonkeeper77‎, 04-26-2020 05:05 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 38
    • Views: 1,811
    Yesterday, 05:27 PM Go to last post
  7. Post Cork vs. Rubber Gasket in Perko Strainers

    Hi All, I have a 493 - 3/4" Perko water strainer (1990) for my AC. I am replacing the cork gaskets. I received the correct size gaskets but wrong material- rubber. My strainers have cork gaskets. I noticed the rubber gaskets fit perfectly....no leaks! I called Perko and was informed that even...

    Started by jmcneill‎, 05-28-2020 08:21 AM
    • Replies: 5
    • Views: 167
    Yesterday, 04:52 PM Go to last post
  8. Difference Between Rotella T1 40W and T 40W

    Is there any difference between older Rotella T40W and newer T140W? Can I mix the two?

    Started by Sadey‎, Yesterday 07:53 AM
    • Replies: 3
    • Views: 96
    Yesterday, 04:19 PM Go to last post
  9. Polishing aft windows in a 53 my

    Kind of like headlight lens on a car. The ones in the master are really crazed.

    Started by Robby‎, 05-28-2020 03:01 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 232
    Yesterday, 10:30 AM Go to last post
  10. Need Some Help

    Having an issue getting the arch and permanently attached mast off our boat to get up the Illinois River. Planned to stop in Seneca and try to use a crane to pluck it off. Problem is the sink/refrigerator housing is attached to part of the arch. Iím sure 5200 was used as it was recently removed and...

    Started by Sadey‎, 05-27-2020 12:33 PM
    • Replies: 6
    • Views: 218
    05-28-2020, 09:40 PM Go to last post
  11. 1981 Hatteras CPMY - Exhaust Leak in 8" Rubber Connection Tubes

    What is up with brand new 8" Trident rubber connection tube leaking. Replaced original blistered tubes with new 8" Trident Blue Stripe tubes and brand new clamps. Still getting leak. Randomly leaking from both ends. Both ends of the 8" fiberglass tubes were cleaned, sanded and resurfaced...

    Started by Hattagirl1‎, 05-22-2020 10:39 PM
    • Replies: 3
    • Views: 153
    05-28-2020, 09:10 PM Go to last post
  12. Alternative to navpod

    Iím looking to mount another furuno navnet3d screen under the back of the bridge to view the fish finder from the cockpit on my 88 38c. Navpods will do the trick but itís as much as a used screen. Any alternatives?

    Started by captcrunch‎, 05-27-2020 10:43 PM
    • Replies: 5
    • Views: 146
    05-28-2020, 08:44 PM Go to last post
  13. Aft Shower Plumbing Access

    I have a 1971 43' Double Cabin. Does anyone know if there's access to the back wall of the aft shower? I have a leak that I think is coming from there.

    Started by Miss Swivel‎, 05-25-2020 06:32 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 217
    05-28-2020, 08:06 PM Go to last post
  14. Exhaust temperature sensor?

    I would like to install some type of high temperature alarm / thermocouple for my 8v71 TI exhaust system. I lost a hose a couple of weeks ago and didn't notice anything until my high water alarm went off. (Actually the hose was fine, the pipe had corroded and slipped out of the end of the hose)...

    Started by Captned‎, 04-18-2006 06:49 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 3,299
    05-28-2020, 11:04 AM Go to last post
  15. Fiberglass Window Frames

    I need to renew my windshield frames , but I am considering going to fiberglass frames, and maybe even the sliders in the salon. I always thought that the aluminum frames were much stronger, but maybe not. Has anyone replaced their frames with fiberglass , and what do you think of the results. I...

    Started by jmooney‎, 05-20-2020 08:26 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 325
    05-27-2020, 10:26 PM Go to last post
  16. Kohler Generator

    Hello, I am looking for a wiring diagram for a 12.5 KVA Kohler Genset model 125CC061. Can anyone help please. Regards and Thanks, Pete

    Started by osprey‎, 05-27-2020 09:24 PM
    • Replies: 0
    • Views: 60
    05-27-2020, 09:24 PM Go to last post
  17. Catastrophic davit crane failure

    My Marquipt davit crane failed today. The stand pipe came off of its foundation, snapped in two and ripped out from the fly bridge fiberglass. I was lowering my novurania davit in still waters. My boat had 1/4 tank of fuel so Iím guessing it was max at 700 pounds. The davit is rated for at...

    Started by RonNP‎, 05-25-2020 07:25 PM
    3 Pages
    1 2 3
    • Replies: 29
    • Views: 889
    05-27-2020, 06:57 PM Go to last post
  18. Will MG507a fit in a Hatteras 36 series I engine bay?

    paired with Cummins QSB 380. Concerned about size of engine bay thanks

    Started by Dwiggmd‎, 05-26-2020 05:34 PM
    • Replies: 3
    • Views: 89
    05-27-2020, 06:23 PM Go to last post
  19. Window tint products

    Itís been years since I had tint installed. Whatís the latest and greatest?

    Started by davidwigler‎, 04-24-2020 09:24 PM
    • Replies: 8
    • Views: 296
    05-27-2020, 04:10 PM Go to last post
  20. Blueprints for a Ď76 Hatteras 46C??

    Anybody have blueprints in .pdf form they can send? Found mine but they are water damaged. Iíll pay for your trouble. Tried calling the factory and they are still shut down apparently. Thanks!

    Started by Shearerlegal‎, 05-26-2020 08:17 AM
    • Replies: 2
    • Views: 76
    05-27-2020, 03:54 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts