Does anyone know the shaft length for a 41C?
I have 8V53 detroits. It is probably in the manual on the boat but I cant get there until Saturday.
Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login
+ Reply to Thread
Results 1 to 5 of 5
Thread: length of shaft for 41C
-
09-10-2007 08:33 PM #1
length of shaft for 41C
Scott
41C117 "Hattatude"
Port Canaveral Florida.
Marine Electronics and Electrical Products Distributor.
-
09-10-2007 10:43 PM #2Senior Member
- Join Date
- Apr 2005
- Posts
- 68
Re: length of shaft for 41C
If your's is the same as mine (1969 41c with 8V53's ) the shafts are 1.5" dia.
and the tail shaft is 48" long and intermediate is 72" long.
Hope this helps.
-
09-11-2007 08:24 AM #3
Re: length of shaft for 41C
It might. Mine have been upgraded to 13/4 and one piece but I was wondering the total length as I might have found a spare
Scott
41C117 "Hattatude"
Port Canaveral Florida.
Marine Electronics and Electrical Products Distributor.
-
Re: length of shaft for 41C
Mine is a 1970 41C with the 1 1/2 in. shaft. I'm like you, the book is on the boat but I can tell you that it is about 6 inches longer than UPS will ship. I had to have two sent by boat from Miami because they were too long to ship by air. I think they are 10 ft. Mine is almost the same boat as Salty Dame but mine are one piece.
Last edited by Full Moon; 09-11-2007 at 11:20 AM. Reason: wrong information
-
Re: length of shaft for 41C
Scott, remember the length of the shaft is not as important as the diameter