Wanted - Port or Starboard side ladder - 43 DCMY

[CaptnRick]

Need to obtain OEM or equivalent ladder that attaches to brackets located on the port and starboard side of a 43 DCMY. The brackets are attached however no ladder. I will pay shipping in addition to agreed upon price.

[hatterasboatguy]

Are you still looking for a ladder? I think I have what you need. The best way to get me is by land line. 408-968-8541
Thanks,
Jim Wagner

[hwginc]

Are you still looking for a ladder? I think I have what you need. The best way to get me is by land line. 408-968-8541
Thanks,
Jim Wagner

can you post a picture i to am looking for a boarding ladder thanks jack 936-295-8269

[CaptnRick]

Jim,

Will give you a call. I have to measure between the brackets so that I can tell you if your ladder will fit. The ladder attaches using the 5/16" pin arrangement.

Rick

[CaptnRick]

Jim,

Tried to send you an email yesterday at the address you gave me. It was returned. Can you email me at Richard.Anderson@Dom.com so I can simply reply to your email? Anyway the measurements are as follows:

Distance between centerline of the left & right bracket's opening where the ladder insert would attach: 18-3/4"
Distance between the ID of the left & right bracket's opening where the ladder insert would attach: 18-1/2"
Diameter of pin that inserts through one side of bracket, through ladder insert and then through other side of bracket: 5/16"

Also Sam's Marine has a bracket that I think is the bracket on my boat:
#90658

Unfortunately, I could not attach a picture of the bracket to this thread.
Thanks,
Rick

[administrator]

Here's a picture of the bracket.

[CaptnRick]

Thanks Doug for the picture....that is the baby....

[CaptnRick]

ok folks,

Still looking for the right ladder. Jim's ladder was a different size.

Thanks anyway Jim,
CaptnRick

[SKYCHENEY]

That looks like a Marquipt bracket. What is the measurement between them? My Marquipt brackets measure 18 3/4" center to center.

[CaptnRick]

Yes,

My brackets measure 18 - 3/4" centerline to centerline of the opening. I do believe they are Marquipt brackets and thus require a Marquipt ladder - a new one I have been told it big bucks.....

CaptnRick