Hynautic Control System for sale

[captruffcs]

Pulled the hynautic system off my 58 Hatteras MY and replaced with electronic. Flybridge and Pilothouse throttle and gear controllers, slave actuators and reservoirs for sale. Will consider parting out the system but would rather sell complete. Set includes 2 CR-T4, 2 CL-T4, 2 CR-B4, 2 CL-B4, 2 Shifter Slaves, 2 Throttle Slaves, 2 R03 Reservoirs with R04 Charging Valves. Located in Pensacola FL. Complete set $1,500 or best offer. Picture samples below (only allowed 3 pictures with post)
.HEIF Image.jpgHEIF Image.jpgHEIF Image.jpg

[captruffcs]

P1300324.jpgHEIF Image.jpgHEIF Image.jpg
added images - have 4 gear levers, 4 throttle levers, 2 throttle slave actuators, 2 gear slave actuators and 2 reservoirs with charging valves. The cosmetic condition of all levers is very good, like new..

[captruffcs]

Still have these -anyone interested.

[Captain Ralph]

I would enjoy a thread about your electronic engine control installation.
Running the wires, install of the controller, install of the actuators, Helm trim if needed, what brand and how well they work?
Why the change out?
Lots of pictures?

[captruffcs]

I would enjoy a thread about your electronic engine control installation.
Running the wires, install of the controller, install of the actuators, Helm trim if needed, what brand and how well they work?
Why the change out?
Lots of pictures?

Hi Cap Ralph - I was dealing with an issue on my port transmission where the Hynautic actuator would occasionally stick in gear. I decided to upgrade the entire system. Installed the Glendinning Smart Actuator 2 system, works great. The cost is high, about $8k for a 2 station system plus install. Unfortunately I didn’t document the installation, I should have but I didn’t. If you’d like to swap yours let me know, I can get you a quote. Next time I’m at the yacht I’ll snap a few pictures of my installation. Wasn’t crazy hard, hardest parts were pulling the old hynautic system out, running the new cables, fabricating new engine cable mounts and addressing the hole in my helm station from the extra controller that was removed. Happy to answer any questions.

https://www.glendinningprods.com/products/complete-controls/mechanical-engine-controls/smart-actuator-2/