The entire starboard side weather boards, railing and stanchions from the PH Door to the stern were wiped out during Irma last year the rest was in ok shape but i never really liked how flimsy it felt and all the seams, screws, etc..
So... i decided to do it in fixed fiberglass. Been kicking around ideas, talked to the yard when i repowered as well as a fiberglass specialist i ve used before on other boats but estimates ranged from 10 to 15k. Plus paint...
I decided to use Coosa and started on this project yesterday afternoon. I am building 4' long panels. Eqch vertical 3/4" panel stands on a 1" thick coosa strip backed up by another 1" strip to reinforced the joint. At each end i had a 3/4" vertical strip of Coosa to mate each panel to the next.
So far so good i have most of the port side assembled and dry fitted. All pieces are assembled with with Epoxy and high density filler. Right now the panels are just screwed into the cap rail, tomorrow i will grind the paint and gelcoat off and epoxy them in place.
When it s all done i ll add a new mahogany hand rail. The old hand rail needed to be redone anyway after all almost 50 years of sanding...
Stay tuned...
Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login
+ Reply to Thread
Results 1 to 10 of 19
Thread: Weather boards replacement
Hybrid View
-
Weather boards replacement
Pascal
Miami, FL
1970 53 MY #325 Cummins 6CTAs
2014 26' gaff rigged sloop
2007 Sandbarhopper 13
12' Westphal Cat boat
-
Re: Weather boards replacement
I bet that will look amazing and much sturdier than OEM.
Looking for a 80 plus foot yacht
Hatteras of Cheoy Lee
-
Re: Weather boards replacement
Send photos once painted. What type of metal did you use?
SEVEN
1979 53' MY Hull #563
Antioch, California
-
Re: Weather boards replacement
You can roll and tip these, with AwlGrip, and they will look great.
-
Re: Weather boards replacement
I used Coosa for deck rebuilds- solid stuff. You should be able to fend off unwanted boarders now!
50 Years on the Great Lakes...
-
Re: Weather boards replacement
Looks solid! Big improvement over the old set up. Will you continue around the aft where the curve at the transom is?