I have the original Galley Maid 32 volt head pumps on my 55c. The forward head had a "dead short" or so I thought when I bought it. Immediately tripped breaker. Took the pump out and there was no debris, string, etc holding the motor but it was stiff to turn. Took home to the bench. Took stators and covers off. The stators were half dry rotted and some residue on the rotors that seemed to have them "stiff" to turn. Cleaned up and applied 36 volts from some 12 volt batteries I had. The motor spun freely so I ordered new stators and seals. Put it together and spun fine on the bench for a few seconds. Didnt want to run dry. Installed back on the boat and it drains bowl and puts water back in. Trouble is after 10-15 seconds it still trips the breaker. I can reset breaker and pump 5 seconds or so indefinitely without tripping but anytime I hit 15 seconds max the breaker trips. Sea strainer is clean. Anyone have any experience with this or suggestions?