Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login
+ Reply to Thread
Results 11 to 14 of 14
-
Re: Proper sealant to use on hatch between “glass” and aluminum frame
Jonathan Brein
1982 43' DCFB #550
"Paragon"
Chesapeake, Virginia
-
Re: Proper sealant to use on hatch between “glass” and aluminum frame
No, not that I have noticed. But, I never used anything with silicone in it. If you do, you will not be able to paint it later. The only reason I used it here was I had to find the right stuff to use on my hatch that would bond to both fiberglass and acrylic and allow for the differing thermal expansion rates of the two materials.
Sky Cheney
1985 53EDMY, Hull #CN759, "Rebecca"
ELYC on White Lake--Montague, MI
-
Re: Proper sealant to use on hatch between “glass” and aluminum frame
Consider using Sikaflex 295 UV (available in white or black).
Available from sources like Jamestown Distributor, Boat outfitters, Defender Marine and of course Amazon.
Sam's doesn't stock it because it does have about a 1 year shelf life.
It has all the right words in the description for i.e. bonding Glass, Acrylic, ceramic, aluminum, fiberglass, metal and plastic.
This is what Sam's recommended to me to use putting in my new glass windows in the pilot house helm aluminum frames and the new Lexan port windows in there aluminum frames back in the aft state room.Tim
1979 53' MY Hull #566
KNOW PRESSURE
Hampton, Virginia
-
03-05-2018 11:24 PM #14
Re: Proper sealant to use on hatch between “glass” and aluminum frame
i'm getting ready to replace my 3 front windshields, what would ya'll recommend for aluminum frame to fiberglass and also glass to aluminum frame? i have been told instead of using the original rubber gasket that it is better to tape off the frame and glass and make a gasket with sealant. this does not allow any water to get to the frame-glass area like the rubber gasket would. what do yall think? 4 of my side windows have this type of sealant gasket and they have not leaked since i purchased the boat 12 years ago.