3 Position Rotary Switch p/n etc?

[MVCaprice]

I am having some shore power issues and I think it's the rotary. I had a high load dock power issue last night (3 ac units + block heaters etc) and popped short power. Only problem was that there was still power at the panel via the indicator and the 220volt light, but no pass through to the sources. The Generator position on the Rotary seems to work fine.

I am fairly certain its the rotary switch. Anyone have a part number for this 3 position switch ( I assume that is what it is?). I assume its a Krause Naimer like most Hatteras boats, but figured I would ask and post up about it.

20180217_202742655_iOS.jpg

[SKYCHENEY]

Those are not cheap. You had better make sure that is your problem before you buy a new one.

[DCMY #92]

These switches have stacked contact modules that can be removed and replace. On some the contacts are visible. If one or more contacts are burned or damaged you should be able to see it. I have a couple I removed when I installed the new breaker panels if you need parts.

[Boatsb]

I have a 50 amp takeout I posted a while back.

I'll look for it in the shop. I'm pretty sure I didn't sell it.

[MVCaprice]

I’m going to take a closer look at it tommorrow and if it’s burnt I’ll post pics. Once I get the panel out some quick continuity checks should find the problem. It’s also possible it’s the breaker. Also I assume this switch is 100amp though as it’s a 20kw genset.

[piripucha]

Take a look at the fuses first, if the 53 is like the 58 YF the may be in the engine room.