Quote Originally Posted by Reefgeorge View Post
The correct size rivets are 5/32" and there is plenty of room for the protruding heads. Some of the less stripped (tighter) holes in the fiberglass need to be drilled with a 5/32" bit and then you get a nice tight fit with the rivet blank. There are stainless available but only in large expensive lots so I went with aluminum. When I do the rest of them I might go with some thin plastic spacers and/or dielectric grease to prevent galvanic corrosion. The itial fit is very tight. We will see if this approach holds up to the rigors of use but there is not much lost because they can be drilled out and then I would be right back looking into internal repair/backing for screws. If it works it saved a lot of repair work. I will reinstall tomorrow and see what we have.

Attachment 23597

Thanks for the suggestions.

George
where did you see or find the stainless rivets.