My Hi-Lo table top rocks quite a bit. I took it apart and found that there are a pair of V-hooks, threaded on one side, that hold down the steel plate that the top mounts onto. The hooks are partly stripped and cannot be tightened - hence the rocking. Other than having them fabricated, does anyone know of a source for them?
Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login
+ Reply to Thread
Results 1 to 9 of 9
Thread: Need Hi-Lo Table hardware
-
01-16-2012 10:03 AM #1Senior Member
- Join Date
- Apr 2005
- Posts
- 3,534
Need Hi-Lo Table hardware
Everyone should believe in something - I believe I will go fishing - Henry David Thoreau
-
Re: Need Hi-Lo Table hardware
Can you post a picture so we can see what you are dealing with?
Bobk
-
Re: Need Hi-Lo Table hardware
MIght try these people
http://www.arrigonidesign.com/tables.htm
or
http://www.alibaba.com/manufacturers...ufacturer.html
good luckLast edited by Tim Powell; 01-16-2012 at 10:12 PM.
-
01-17-2012 10:04 AM #4Senior Member
- Join Date
- Apr 2005
- Posts
- 3,534
Re: Need Hi-Lo Table hardware
Thanks. I'll try to get a pic up later. The bolt is a standard thread 5/16" bolt, about 2" on one side, down to a "V" bent back upward at about 45* for about 1". The 1" upside of the "V" hooks into a hole in the side of the pedestal, and a nut holds down the steel plate to which the table top is attached.
Everyone should believe in something - I believe I will go fishing - Henry David Thoreau
-
01-18-2012 04:00 PM #5Senior Member
- Join Date
- Apr 2005
- Posts
- 3,534
Re: Need Hi-Lo Table hardware
Here's a couple pics of the pieces I need.
DSC_0426.jpgDSC_0427.jpgEveryone should believe in something - I believe I will go fishing - Henry David Thoreau
-
Re: Need Hi-Lo Table hardware
Can't you just run them through a die and clean up the threads?
Eric
41TC 1966 Hull #53 "Requisite"
Kent Island, MD/Ft. Lauderdale, FL
"Though she creaks - She holds"
-
01-18-2012 10:51 PM #7Senior Member
- Join Date
- Apr 2005
- Posts
- 3,534
Re: Need Hi-Lo Table hardware
I already did. There's no meat left.
Everyone should believe in something - I believe I will go fishing - Henry David Thoreau
-
01-19-2012 09:47 AM #8
Re: Need Hi-Lo Table hardware
They look like J hooks. I have seen them before I think at a good hardware store. I know I have also seen them with a wood screw threaded end.
Scott
41C117 "Hattatude"
Port Canaveral Florida.
Marine Electronics and Electrical Products Distributor.
-
Re: Need Hi-Lo Table hardware
I would think you could put a torch to the proper all-thread rod and bend to suit.
Bobk