Re: Another Access Mystery
I haven't pulled mine but have a 40 year old 46C with the same POS equipment. Following to see how you wind up doing it as I expect failure from mine within the next 10 years.
Re: Another Access Mystery
i had a 1977 46c, any possibility to access it from above in the salon? might be easier and less destructive. maybe behind the wet bar/ice maker or through the top under the dash
Re: Another Access Mystery
45 series 1 same master set up. I swapped my original big aluminum box evaporator/blower to a new maraineaire about ten years ago. My boat has a premade access panel below the evap. I cant see any other way of accessing it since you have the finish panel in front where the controls are, the salon bulkhead behind and dash above. access from below the unit is the only way. I used lots of silicone antivibration tape and silicone mounts when mounting the new one. Two aluminum angle between the front of compartment to rear and situated new evap on top of that.
Re: Another Access Mystery
Gotcha. I saw the trim strips where the horizontal panel under it wasn't solid for the width of the compartment like the front panel. Thanks.
Was it possible to see the evaporator in the salon from that area when you pulled the panels under that compartment?
Thanks
Re: Another Access Mystery
The evaporator is right there as soon as you open the access panel. On mine, this evap serves the salon and the master stateroom, with registers above in the dash and the other register as it is in your picture. If I remember I'll try to take a picture when I'm down there later today and post it .