Wanted: Dodgerboard-small scrap piece
Does anyone have any OEM dodgerboard that they would like to sell? I hate to order a whole piece from Sams when I only need a few small pieces.
What I'm looking for is enough to cut out 2 pieces 7"x22" and also 4 small strips 3" wide to make the H-joint for a pull-out gate.
Re: Wanted: Dodgerboard-small scrap piece
Prob a crazy question, but what is "dodgerboard"?
Re: Wanted: Dodgerboard-small scrap piece
Sky,
I may have some....I'll look as soon as I can get down to the yard. I bought a full piece from Sams and used only about 75% of it.
Dogerboard is the thin board that runs under handrails near the wing doors.
Re: Wanted: Dodgerboard-small scrap piece
I need some for the aft corner peices of the flybridge (the curved part). Is this a seperate peice or do can you bend it?
Re: Wanted: Dodgerboard-small scrap piece
SKY,
I just spoke to my guys. They say we have one 2'x2' piece.
It's really really hard to make a rounded corner with it. For the helm area my guys made a template, glassed over it, sanded and painted it.
I may have a photo if you'd like to see it.
Re: Wanted: Dodgerboard-small scrap piece
We have the H joints here in stock @ Sam's Part#13346A
Re: Wanted: Dodgerboard-small scrap piece
Re: Wanted: Dodgerboard-small scrap piece
SKY and North,
This picture was taken as the corners were being fit and before final painting with the color match.
On a 48'9" YF the aft portion of the helm is covered by a canvas piece running from corner to corner. We replaced that with a large section of dogerboard (appx 2x12, runs under ladder) and then made the moulded fiberglass corners.
New canvas enclousure is being made this winter.
Re: Wanted: Dodgerboard-small scrap piece
Quote:
Originally Posted by
jlangley
We have the H joints here in stock @ Sam's Part#13346A
Thanks. I noticed them on your parts section, but I think I would rather make them as I can control the width.
Re: Wanted: Dodgerboard-small scrap piece
Quote:
Originally Posted by
lumina
SKY,
I just spoke to my guys. They say we have one 2'x2' piece.
It's really really hard to make a rounded corner with it. For the helm area my guys made a template, glassed over it, sanded and painted it.
I may have a photo if you'd like to see it.
2x2 may work. I'll measure it up again to be sure and I'll send you a PM.
Thanks