Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 12 of 230 FirstFirst ... 2 10 11 12 13 14 22 62 112 ... LastLast
Threads 221 to 240 of 4586

Forum: Parts Wanted & For Sale

NO COMMERCIAL LISTINGS ALLOWED

  1. 32v Galley Maid Fresh Water Pump

    Used pump, good condition, recently Raz Marine rebuilt. I changed to a 12 FW system. Make offer.

    Started by neildeb2‎, 10-10-2022 11:43 PM
    • Replies: 0
    • Views: 606
    neildeb2
    10-10-2022, 11:43 PM Go to last post

  2. NOS Onan Raw Water Pump

    I was cleaning out my Dad’s garage and found a raw water pump and a couple of impellers. It’s the old style pump for the 7.5 kw generators. Onan shows a part number 131-0152 and 131-0182. This is the early style before they switched to the Sherwood pumps. The price is $350.00 with the 2 impellers....

    Started by dsharp‎, 10-08-2022 09:12 PM
    3 Attachment(s)
    • Replies: 5
    • Views: 1,172
    bigbill
    10-10-2022, 09:27 PM Go to last post

  3. Nice clean pulpit from a 52c

    Nice clean pulpit from a 52c, teak removed, repairs with epoxy filler, sanded, 3 coats Alex seal primer. $800.00 Located in south central Florida, can deliver to Fort Lauderdale or Fort Myers $20.00 for gas. Have a shipper with good rates.

    Started by mrdc‎, 08-29-2022 10:49 AM
    2 Attachment(s)
    • Replies: 2
    • Views: 1,069
    mrdc
    10-09-2022, 09:36 PM Go to last post

  4. 1972 43DC Flybridge

    Removed our flybridge last winter, don't plan to put it back on. Probably will end up putting in the dumpster, but would love to pass it on to someone. Pick up in Albany, NY. Thanks!

    Started by brettportzer‎, 11-22-2021 12:02 PM
    2 Pages •
    1 2
    1 Attachment(s)
    • Replies: 12
    • Views: 2,851
    brettportzer
    10-06-2022, 01:45 PM Go to last post

  5. 32Volt Engine Room Blowers and 1 new Hatteras DC Volt Gauge

    2 32 Volt Engine Room Blowers run fine no noises $75.00 each. 1 new Hatteras Volt Gauge P/N 24226. $65.00.

    Started by mrdc‎, 09-24-2022 09:29 PM
    2 Attachment(s)
    • Replies: 9
    • Views: 1,565
    cww
    10-05-2022, 11:37 PM Go to last post

  6. Intercooler for detroit diesel v71 and 92 engines

    I have one brand new Detroit Diesel intercooler for v71 and 92 series engines. This is brand new ready to go. They sell for 2000-2800 normally. Asking 1250.00 plus shipping. I also have two new aftermarket coolers of the same style for 1200 a piece. If your interested, please call or email Sean...

    Started by ddctech‎, 02-03-2013 09:03 PM
    • Replies: 6
    • Views: 4,540
    BOATER BOB
    10-03-2022, 10:06 PM Go to last post

  7. Exhaust Collectors for 12V71

    Exhaust Collectors for 12V71TI with elbows. 6" tubes with 10" collector. Price $1500.00. For more info pm or call 336-861-6100.

    Started by Top Notch3‎, 03-12-2009 03:28 PM
    1 Attachment(s)
    • Replies: 1
    • Views: 1,521
    Jedymar
    10-03-2022, 11:40 AM Go to last post

  8. Bilge Port Supply Ventilator

    Still looking for port side bilge ventilator clam shell. This would be the ventilator that is mounted on the walkway. Any remarks or suggestions would be greatly appreciated. It would be for a 1985 36' convertible.

    Started by ZeeTom‎, 09-28-2022 03:09 PM
    • Replies: 2
    • Views: 803
    ZeeTom
    09-30-2022, 11:10 AM Go to last post

  9. Robertson F200 remote for AP 200 DL wanted

    Please let me know if anyone has one lying around for sale to a good home. Bruce Freestyle 1986 62 CPMY (54MY with ext) Tampa

    Started by Freestyle‎, 09-28-2022 10:37 AM
    • Replies: 0
    • Views: 684
    Freestyle
    09-28-2022, 10:37 AM Go to last post

  10. Wanted 32V display case style bulbs for lower hallway ceiling

    I know its a long shot but thought I would ask. Also, we tried some of the led ones from the place in Canada. Color is like standing in a refrigerator. Sam's has LED ones and I ordered one. They said it's a softer white- so we shall see. I prefer the warm glow of the old "real" ones.

    Started by Bob Quinn‎, 09-26-2022 01:19 PM
    • Replies: 3
    • Views: 767
    Bob Quinn
    09-26-2022, 03:48 PM Go to last post

  11. Teak Flagstaff 74”

    Found on boat when purchased. Need re-varnishing. Does not have the metal ferrule. Has been cracked in past (picture), but is solidly glued. Glue line needs sanding. $425at SAMs. $60 including shipping within US. John McCarley Water Colors

    Started by divert00‎, 08-27-2022 10:41 AM
    3 Attachment(s)
    • Replies: 1
    • Views: 1,099
    hardshell46
    09-25-2022, 05:27 PM Go to last post

  12. Detroit Diesel Series 71 &92 Engine - Marine Gear, Red Gear and Trans Svc Manual

    Manual for servicing and repairing Allsion transmissions/marine gears. $25 plus shipping. Located in Harbor Springs, Michigan.

    Started by DLCameron2‎, 09-10-2022 07:45 AM
    2 Attachment(s)
    • Replies: 3
    • Views: 1,092
    DLCameron2
    09-14-2022, 08:37 AM Go to last post

  13. Looking for a 16k btu Cruisair 230v R22/417a evaporator (ebo 16)

    Hoping someone has parted out a system and their evaporator is still good. My 30k compressor is working fine, but one of the 16k evaporators has given up.

    Started by BobbyT‎, 09-13-2022 10:19 AM
    #cruisair, #evaporator, #r22
    • Replies: 1
    • Views: 653
    Captain Ralph
    09-13-2022, 10:30 AM Go to last post

  14. Northstar charts

    Does anyone have a Northstar 6100i East Coast USA chart on CF card they would sell? Evidently these are NLA. Thanks, in advance.

    Started by jim rosenthal‎, 09-10-2022 07:26 PM
    2 Pages •
    1 2
    • Replies: 16
    • Views: 1,997
    Captain Ralph
    09-12-2022, 09:30 PM Go to last post

  15. Wanted: Marquipt sea stair steps and 8-step handrail

    Looking for 2 Marquipt middle steps (not the top or bottom steps) for a 19” wide sea stair and a handrail for an 8-step sea stair. I’m hoping to match the tread design below (I already have 2 non-matching steps). I can pick up in South Fla or I will pay shipping.

    Started by firbanks‎, 09-12-2022 08:12 AM
    1 Attachment(s)
    • Replies: 0
    • Views: 523
    firbanks
    09-12-2022, 08:12 AM Go to last post

  16. Marquipt sea stair parts for sale

    Changing my boarding ladder out l. I have 19” wide Marquipt Sea Stair parts that someone might benefit from. Old ladder was a 6-step Marquipt sea stair. For sale: Bottom step ($125); 2 middle steps - one bent up a bit as visible in the corners ($100/$50); Teak handrail ($200). Full disclosure -...

    Started by firbanks‎, 09-12-2022 07:57 AM
    3 Attachment(s)
    • Replies: 0
    • Views: 527
    firbanks
    09-12-2022, 07:57 AM Go to last post

  17. Cool For Sale: LaMarche Charger

    LaMarche Model A41-30-32-B1-16L-10055 Working take out from my boat purchased new in 2011. Asking $300. Local pick up Harbor Springs, Michigan or let's arrange shipping 121Lbs. shipping weight.

    Started by DLCameron2‎, 08-29-2021 02:28 PM
    • Replies: 3
    • Views: 1,397
    DLCameron2
    09-10-2022, 07:35 AM Go to last post

  18. 1 1/4" twisted nylon, 250 to 300 feet

    Approximately 250 feet, 1 1/4" 3 twisted nylon. New. Was a spool of 600', I was to get half so there may be 300'. From Southeast Rigging 4 years ago. Should be Sampson brand. I'm never going to use it. Coiled up in a new RubberMaid trash can. I'm in Satsuma FL 32189. Hate for it to just...

    Started by Captain Ralph‎, 04-08-2022 05:58 PM
    • Replies: 1
    • Views: 900
    Captain Ralph
    09-09-2022, 05:50 PM Go to last post

  19. Cool 1985 ONAN 20Kw Generator

    Running condition removing from my 53ED; works fine includes sound shield. Just completed the Loop running around 700hrs. Total hours unknown but likely in the 3000hour range. Asking $1,500. Located in Cheboygan, Michigan. Pick it up or pay the ride. Can palletize if needed. PM,...

    Started by DLCameron2‎, 07-07-2022 04:15 PM
    • Replies: 1
    • Views: 973
    DLCameron2
    09-08-2022, 08:14 AM Go to last post

  20. FS: Glendining Synch

    For sale, 32v Glendining engine synchronizer. Main box only. Was working when removed during repower, box only, no cables. Decided not to reinstall. $150. Miami

    Started by Pascal‎, 09-07-2022 01:38 PM
    1 Attachment(s)
    • Replies: 0
    • Views: 677
    Pascal
    09-07-2022, 01:38 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 59 users browsing this forum. (0 members & 59 guests)

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules