Does anyone have any info on the early (1961) 41C's? I am curious about the number of hulls that were produced, and lay-up method. I have read the info on the 34C's on the 34.org page. I assume (maybe not too smart) that the lay-up methods were the same. Any thoughts?

Does anyone know where else (who sells / makes) the leather fender holders / hangers that hang off of teak railings? Sams has them but I was hoping to find some alot cheaper (Sams part # FH3N - $230). Maybe this is what they cost...I thought they were like $30!! Shows what I know

Did anyone happen to see the last few episodes of Deadliest Catch? one was showing one of the crab boats having serious diesel failures at sea, same boat 2x. second occurrence was a shattered piston along with related damages. engines looked like Manns and from prior threds appears to have had...

I have a 1975 hatt. 53 MY. Each alternator has a separate voltage regulator mounted on the walls of each engine room just inside the forward engine room doors. I think one of them is caput and needs to be replaced. Does any of you know of a source I can buy these gadgets from? The DD engine...

I tested my newly installed Raritan Atlantes toilets today. After flipping the dip switches so they would retain water in the bowl, two of the three seemed to work great. The two that worked were the fwd and the master (both hooked to the bow tank). The midship(guest) toilet has a problem...

We are planning a trip to the Bahamas this summer and I wondered if someone could tell me how I go about getting the Customs sticker for my boat and if there is anything else I need to do. Have not made a crossing since 1990 and assume things may have changed a bit. Thanks, George ELECTRA VI...

The engine mounts on my 36c w/ 4-53t need replaced. The original mounts are the ones that are vertically aligned - the surveyor said that they sag over the years. The last owner had them welded solid, thus no vibration absorbtion. Is it possible to remove only one mount and have the other 3...

I read in PassageMaker about how the writer anchors with his all chain rode by using a "chain stopper" connected to nylon rope that connects to his two forward cleats making a bridle. Has anyone come up with a way to do the same on the basic rope rode? Know I have thought about it a lot, would...

Our 1971 vintage mirrors in all three heads need replacing. I keep trying to remove them and they will not come out without a fight. Considered breaking them but that makes duplication very difficult. The obvious was to lift them up and angle them out of the tracks but that will not work. I know...

I Emailed phillips petrolium regarding this subject and received the following response Florida is not a Reformulated Gasoline Required State. However, with the new emphasis on renewable fuels via the Energy Policy Act there may be some discretionary blending going on in Florida. Florida...