Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 999 of 1106 FirstFirst ... 499 899 949 989 997 998 999 1000 1001 1009 1049 1099 ... LastLast
Threads 19961 to 19980 of 22111

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. New toilet test

    I tested my newly installed Raritan Atlantes toilets today. After flipping the dip switches so they would retain water in the bowl, two of the three seemed to work great. The two that worked were the fwd and the master (both hooked to the bow tank). The midship(guest) toilet has a problem...

    Started by SKYCHENEY‎, 04-23-2006 10:11 PM
    • Replies: 1
    • Views: 1,354
    04-24-2006, 06:50 AM Go to last post
  2. Transmission fluid

    Soliciting opinions as to preferred brand(s) of transmission fluid to use in an Allison (behind a 8v71T).

    Started by Diver Down‎, 04-23-2006 09:14 PM
    • Replies: 3
    • Views: 1,515
    04-23-2006, 09:38 PM Go to last post
  3. U.S. Customs

    We are planning a trip to the Bahamas this summer and I wondered if someone could tell me how I go about getting the Customs sticker for my boat and if there is anything else I need to do. Have not made a crossing since 1990 and assume things may have changed a bit. Thanks, George ELECTRA VI...

    Started by ELECTRA VI‎, 04-21-2006 02:20 PM
    • Replies: 6
    • Views: 3,473
    04-23-2006, 09:34 PM Go to last post
  4. ONAN Raw Water Pump Will Not Prime

    Today's frustration was the water pump on the ONAN 7.5. New impeller, new gasket, seacock open, manually primed with a hose and no water out the discharge side. No obstructions up or down stream. Belt properly tensioned. WTF :confused: I took the whole pump home, poured a martini and hope...

    Started by Passages‎, 04-21-2006 08:24 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 15,395
    04-23-2006, 08:30 PM Go to last post
  5. Engine mounts

    The engine mounts on my 36c w/ 4-53t need replaced. The original mounts are the ones that are vertically aligned - the surveyor said that they sag over the years. The last owner had them welded solid, thus no vibration absorbtion. Is it possible to remove only one mount and have the other 3...

    Started by CDB101‎, 04-21-2006 01:43 PM
    • Replies: 2
    • Views: 1,780
    04-23-2006, 03:16 AM Go to last post
  6. Boatyard Recommendations in San Diego

    I am new to the San Diego area and I am looking for a reputable boatyard for bottom paint, rebedding windows, and pehaps some interior renovation. Anyone here have any recommendations? My 53C is at Harbor Island West Marina.

    Started by 53hatt‎, 04-01-2006 02:11 PM
    • Replies: 5
    • Views: 1,938
    04-22-2006, 06:25 PM Go to last post
  7. Anchor Bridle

    I read in PassageMaker about how the writer anchors with his all chain rode by using a "chain stopper" connected to nylon rope that connects to his two forward cleats making a bridle. Has anyone come up with a way to do the same on the basic rope rode? Know I have thought about it a lot, would...

    Started by Jaxfishgyd‎, 04-19-2006 10:12 PM
    • Replies: 3
    • Views: 2,730
    04-22-2006, 01:42 PM Go to last post
  8. cleaning wood

    I'm looking to spruce up my interior. Wondering what to use to clean and wipe down all the wood in my interior.. The mojor refit for my interior will be done in a year or two... like i said just looking to get by for now. thanks for any input.

    Started by seacolt‎, 04-20-2006 08:47 PM
    • Replies: 6
    • Views: 2,027
    04-22-2006, 10:53 AM Go to last post
  9. Unhappy How to remove mirrors 53MY/58YF

    Our 1971 vintage mirrors in all three heads need replacing. I keep trying to remove them and they will not come out without a fight. Considered breaking them but that makes duplication very difficult. The obvious was to lift them up and angle them out of the tracks but that will not work. I know...

    Started by Dustoff44‎, 04-21-2006 03:23 PM
    • Replies: 2
    • Views: 1,338
    04-21-2006, 09:34 PM Go to last post
  10. Living on the Hook - HELP!

    Looking for peoples opinions / experiences here.... So, currently my boat is in a slip at a marina (Newport Marina in Jersey City). There is a sea wall at the marina which is supposed to reduce the waves. The marina is located on the Hudson River where from 6am to 10pm there is ALOT of Ferry...

    Started by rangerscott275‎, 04-20-2006 01:07 PM
    2 Pages
    1 2
    • Replies: 13
    • Views: 3,613
    04-21-2006, 12:27 PM Go to last post
  11. Ethanol In Fuel, Florida

    I Emailed phillips petrolium regarding this subject and received the following response Florida is not a Reformulated Gasoline Required State. However, with the new emphasis on renewable fuels via the Energy Policy Act there may be some discretionary blending going on in Florida. Florida...

    Started by 67hat34c‎, 04-21-2006 09:58 AM
    • Replies: 1
    • Views: 1,231
    04-21-2006, 10:07 AM Go to last post
  12. O-ring sealed fuel pipes

    A local DD dealer recommended the O-ring sealed fuel pipes to replace the flared tube design fuel pipes. Is this a DY project. Do you have to do a comlete engine tune-up after installing new pipes? Any other thoughts. Thank you in advance.

    Started by HATT 46‎, 04-19-2006 10:30 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 2,782
    04-21-2006, 08:37 AM Go to last post
  13. Piling Protection

    My boat is on the Shrewsbury River in New Jersey, off Sandy Hook Bay. We currently have about a 4-4.5 foot tide change with little current running through our yacht club. The docking situation is fixed docks with a 30 foot port side finger with a mid piling and an end piling on the finger and...

    Started by MicroKap‎, 04-18-2006 03:08 PM
    • Replies: 9
    • Views: 2,987
    04-21-2006, 07:31 AM Go to last post
  14. Corroded/Leaking Raw Water Drain Valve

    Passages got splashed today :) but found a problem on the raw water side of my port 6-71. :mad: The little spigot valve for draining raw water from the exit flange of the expansion tank (follow that?) is blowing water. I suspect when I boiled out my raw water system this winter, I unwittingly...

    Started by Passages‎, 04-20-2006 08:23 PM
    • Replies: 3
    • Views: 1,380
    04-21-2006, 06:19 AM Go to last post
  15. Maiden Voyage, Words of Advice

    I have recently acquired an older 38c. I have been lurking in this Hatteras forum for quite some time and would like to thank those talented individuals that share information and put their expertise into words for all to share. The boat "MADURO" is currently in Tampa and I will be moving the...

    Started by HEMI‎, 04-19-2006 06:43 PM
    3 Pages
    1 2 3
    • Replies: 27
    • Views: 5,471
    04-20-2006, 09:47 PM Go to last post
  16. Polyethylene Fuel taks

    In response to the Ethanol/FRP compatibility situation, I spent some time measuring the dimensions of the fuel tanks in my 38’ DCMY as a first step in replacing them later. They are under the single beds in the aft cabin, and not particularly accessible to measure except through a small port. -...

    Started by smoothmove‎, 03-21-2006 03:32 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 40
    • Views: 7,979
    04-20-2006, 03:39 PM Go to last post
  17. Learned another lesson - boat plumbing expansion tanks

    Over the winter, with the system winterized (water heater off - this is important), I was questioning why our 53MY boat had the Galley Maid Fresh water pump with the attached galley maid expansion tank AND a separate expansion tank. I posted something about that here and then after a couple days...

    Started by MikeP‎, 04-20-2006 06:39 AM
    • Replies: 5
    • Views: 2,112
    04-20-2006, 02:08 PM Go to last post
  18. Diesel Fuel Pouring out Breather

    Hello, recently I took my hatt out for maiden voyage for the season. Boat has 2 x VT-8 370's w/ forward & aft tank and a fuel polishing system. It ran perfectly the whole trip...about 1 1/2 hours but when I pulled into marina I noticed fuel trickling out of breather to aft fuel tank. I shut...

    Started by rangerscott275‎, 04-18-2006 12:50 PM
    • Replies: 7
    • Views: 2,255
    04-20-2006, 12:15 PM Go to last post
  19. Headliner

    looking to replace headliner. think someone here had a good supplier, could not find the thread. Please let me know where to get the materials

    Started by 67hat34c‎, 04-19-2006 02:57 PM
    • Replies: 6
    • Views: 2,452
    04-20-2006, 06:17 AM Go to last post
  20. Permanent Fuel Polishing systems- I think it's hype.

    Yesterday I was talking to a marina mechanic who was working on a 2Year old boat He was installing a fuel polishing system at the owner's request - total price $3000. He was also bemoaning the fact that he can't get some service info and parts he needs on the 2-year old electronically-controlled...

    Started by MikeP‎, 04-19-2006 06:15 AM
    • Replies: 9
    • Views: 2,870
    04-19-2006, 10:05 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 274 users browsing this forum. (2 members & 272 guests)

  1. RJM
  2. brettportzer

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts