Remember when we were talking about 30A service and how we didn't need it? Well, in the yard that is all they have, and so I bought a single 50ft 30A cord, cause my chargers are only on one side. Anyways, it plugged into the yard outlet ok, but what I thought were 30A/125v outlets on the boat are...

I've been chasing down why my stbd engine (crusader 454) keeps back firing, when trying to start. I had replaced everything electrical, in hopes that it would fix - not luck. I then read the upgraded electronic dist. I installed and found out I had to remove the ballast resistor to offer full...

Does anyone have a source/part number for the red round cylinder bulbs/lights that are on the flybridge /helm on 81' vintage? I have a number of them that are out that I would like to replace.

So. It looks like we sucked some of that delicious Fear river mud into the system. The Cruiseair was not happy. I need to pull the strainer and see just how far it got. As this is my first go-round with this I was watching vids on flushing the system to determine what I needed to do. One thing that...

I have removed the factory bow rail after it was significantly bent on the port side. I want to repair the mounting areas on the toe rail and a few other small/moderate glass chips, then roll/tip. I have done research and feel like buying the $200 west epoxy kit (slow hardener)should get the job...

Tore out our old tackle locker and found the bulkhead pretty well rotted. Mostly the sides but also behind the bait freezer and under the window. Anyone done this project? Looks like it's 3/4 and 1/2" ply laminated together. The top of the ply is tabbed to the bridge bottom but I can't tell where...