Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 91 of 1107 FirstFirst ... 41 81 89 90 91 92 93 101 141 191 591 1091 ... LastLast
Threads 1801 to 1820 of 22131

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Stand Alone Dehumidifiers- Good idea or not worth it?

    Guys...I notice that I my humidity onboard tracked pretty much with the prevailing exterior conditions, especially during the winter when the AC’s weren’t running much.Since we live in Charleston, SC it’s humid all the time so I got a stand-alone dehumidifier which measures about that which rolls...

    Started by jrmccoy‎, 02-06-2020 05:35 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 30
    • Views: 7,152
    10-04-2021, 06:31 PM Go to last post
  2. How to use Parallel switch 1972 58' Hatteras Yachtfish

    My starting batteries were low because someone removed the shore plug while some items were on and inverter drained the batteries. I finally charged the batteries, but what is the procedure to use the parallel switch if batteries are too low to start?

    Started by jusbumn‎, 10-03-2021 11:05 AM
    • Replies: 4
    • Views: 876
    10-03-2021, 08:15 PM Go to last post
  3. AC/Heat upgrade

    Plenty of intermittent problems with current ac controls. I was thinking about upgrading to Nest thermostat controls. Anyone have any input or advice?

    Started by Phasma2128‎, 09-30-2021 09:34 AM
    • Replies: 2
    • Views: 627
    09-30-2021, 09:01 PM Go to last post
  4. 1979 6V92T Losing RPM

    I have a 1979 43 convertible with twin 6V92T's. Last trip 10 mile run at the end of the trip the starboard engine started to smoke ever so lightly (greyish) and it dropped from 1900 to 1700 rpm's and would not go over that. Ran it this weekend same trip and at about the same point did it again. ...

    Started by tdsurfrider‎, 09-27-2021 04:36 PM
    • Replies: 4
    • Views: 748
    09-30-2021, 01:30 PM Go to last post
  5. How to add water temp alarms?

    I currently don’t have anything that beeps if the water temp shots up due to a possible impeller failure. What are the different ways I can install an alarm system against over heating?

    Started by akintosyali‎, 09-29-2021 12:15 AM
    • Replies: 4
    • Views: 1,106
    09-29-2021, 08:23 PM Go to last post
  6. Winterizing - water filters

    I have the original factory water filters on the boat for the wet bar and kitchen/fridge. To remove them, you just unscrew them 1/4 turn to the OFF position and pull down. My question is, when they're in the OFF position and cartridge is out, will the pink antifreeze flow through the filter base?...

    Started by RichardM‎, 09-29-2021 07:03 PM
    • Replies: 1
    • Views: 465
    09-29-2021, 07:08 PM Go to last post
  7. cracked heads on a 426

    Machine shop called. I have cracked head on my 426 Chrysler. Current heads are cast iron, but most new replacements are aluminum. I am assuming I should stay with aluminum, but is there a strong case for not using aluminum? It looks like the wedge blocks come in 2 different combustion chamber...

    Started by akintosyali‎, 09-21-2021 05:32 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 2,246
    09-29-2021, 04:48 PM Go to last post
  8. priming pump

    How does one prime a Detroit 8V71 engine with a priming pump?

    Started by witold933252763‎, 09-27-2021 11:06 PM
    • Replies: 3
    • Views: 697
    09-28-2021, 11:02 AM Go to last post
  9. How to fend boat off dock in winds

    I did try to google how to build big boat fender boards, no go, so changed it to yacht, same results. My dock is a pier that faces south. Westerly winds are no problem as the 46 will hang off the dock not hitting it. Easterly winds pin it to the dock and I need a good way to fend off without making...

    Started by madhatter1‎, 05-18-2021 09:00 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 44
    • Views: 7,669
    09-27-2021, 07:45 PM Go to last post
  10. Air Con Fans & Blowers

    A few years ago I sourced in America a replacement blower/fan for a Crusiair evaporator. I need another fan, but cannot remember the supplier's name. This business had a huge range of Cruisair compatible fans, motors etc Any ideas? Thanks.

    Started by scottinsydney‎, 09-27-2021 06:28 AM
    • Replies: 5
    • Views: 711
    09-27-2021, 07:06 PM Go to last post
  11. McBee fuel primer AS5110760

    Looking for the hook up diagram of the above priming pump to the fuel pump on a Detroit diesel 8V71. any help will be greatly appreciated. Wit

    Started by witold933252763‎, 09-27-2021 05:58 PM
    • Replies: 0
    • Views: 387
    09-27-2021, 05:58 PM Go to last post
  12. Can you help with how to change bulbs

    I am repairing the air switch to the black water tank and only one of the three bulbs are glowing. I have not been able to remove the red covers to replace the bulbs. Can you help. Thanks Craig McRoberts 1998 Hatteras 52 SD

    Started by Craig mcroberts‎, 09-24-2021 09:38 PM
    • Replies: 5
    • Views: 696
    09-27-2021, 12:24 PM Go to last post
  13. RPM vs. expected speed

    Running a 46C with 8v71TIs at 2000 rpm I am seeing about 14 knots. Seems a bit slow, but over to the crowd. I’m not sure what wheels are on her other than 4 bladed. I was not loaded down with fuel / water.

    Started by jason.erbecker‎, 08-19-2021 04:58 PM
    2 Pages
    1 2
    • Replies: 15
    • Views: 2,579
    09-26-2021, 08:56 AM Go to last post
  14. Rupp center rigger mount

    Want to mount a center tigger on my 1988 38c. Have the rupp pole, but there is a canvas top on boat so no hardtop to mount the rupp mount onto. Anyone have any suggestions as to best way to mount without a hard top

    Started by captcrunch‎, 09-25-2021 08:32 PM
    • Replies: 2
    • Views: 650
    09-26-2021, 07:25 AM Go to last post
  15. Recommended Bilge Mounting location.

    I plan to change my engine bilges pumps and switches very soon I have several best practices questions? I will pull everything out and do a good cleaning and then put all new equipment in. I currently have Rule 2500's on standard float switches with no high water alarms. I was thinking new pumps...

    Started by Eddieclemons‎, 09-11-2021 07:05 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 1,786
    09-24-2021, 12:27 PM Go to last post
  16. Battery voltage

    Had battery blow up last week replaced two 8d in series Battery was only 2 years old measured voltage with Charger on reads 28.8 volts input would be greatly appreciated 🤔🤔🤔🤔

    Started by major hattitude‎, 09-13-2021 05:25 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 1,726
    09-23-2021, 04:27 PM Go to last post
  17. Remove sleep sofa?

    How do I get the sleep sofa (2 cushion loveseat ) off the boat to have it reupholstered?

    Started by Artie Nelsen‎, 09-23-2021 08:24 AM
    • Replies: 3
    • Views: 776
    09-23-2021, 12:45 PM Go to last post
  18. Getting ready to splash after refit

    58 YF has been on the hard for a year and a half getting repairs and updates. Looks like were done, and last items before going back in are repacking all stuffing boxes and seals, impellers, fresh oil and raycors. Pressurizing and topping off hydraulics. Fuel Tank additive. The yard has run the...

    Started by dmoore1200‎, 09-22-2021 08:30 AM
    • Replies: 7
    • Views: 806
    09-23-2021, 09:24 AM Go to last post
  19. Question on cleaning and painting brass through hull fittings

    I am in the process of cleaning the filter and replacing rubber gaskets in the raw water through hull fitting and wanted to ask what is the easiest way of getting rid of that green stuff on the through hull fittings and would priming and paining them with Rust Oleum paint be advisable and lasting...

    Started by brico‎, 09-20-2021 11:39 AM
    • Replies: 4
    • Views: 1,180
    09-21-2021, 10:53 PM Go to last post
  20. A few more knots and a few less GPH

    I have a 1989 41' sport fish with 692s. love the boat. Have been researching lifting strakes. A few years ago I got one of those helicopter pictures of my boat running in very smooth water and noticed how large the water displacement was coming off the hull at mid-ships, 4-5 ft high from where...

    Started by gglenewinkel‎, 09-12-2021 10:29 AM
    • Replies: 5
    • Views: 1,643
    09-21-2021, 01:11 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 426 users browsing this forum. (4 members & 422 guests)

  1. doc g
  2. Big Chief
  3. Phasma2128
  4. Play'N Hooky Too

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts