Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 885 of 1106 FirstFirst ... 385 785 835 875 883 884 885 886 887 895 935 985 ... LastLast
Threads 17681 to 17700 of 22112

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Re Lining a generator sound shield.

    I need to re line a generator sound shield that I am putting in my boat. The original fiberglass is gone. I would like to use something that is long lasting and will not burn or absorb oil or diesel fuel. The housing has some curves and dimension so a ply able material may be best. I am open to...

    Started by Boatsb‎, 05-29-2007 07:48 PM
    • Replies: 8
    • Views: 4,424
    05-30-2007, 03:11 PM Go to last post
  2. Lightning protection?

    Does anyone know if Hatteras took any special precautions to minimize lightning strikes and damage? The reason for the question: We found a metal 'bar' that looked like a copper alloy sandwiched into the core of the hard top when the wet balsa was removed. It ran for and aft, but I have no idea...

    Started by bobk‎, 05-22-2007 01:41 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 2,987
    05-30-2007, 09:16 AM Go to last post
  3. Question opening windshield

    Has anyone had to deal with a once opening center section windshield that has been caulked shut? Are they prone to leak or have other problems? It would be nice to get a flow of air through the pilot house. What kind of seal was used, and is it still available? This is on a 1968 TC. All the...

    Started by Capt Ratty‎, 05-30-2007 06:33 AM
    • Replies: 1
    • Views: 1,223
    05-30-2007, 09:15 AM Go to last post
  4. Finished painting bottom and top

    Just finished painting my good old project boat, and I am very happy with the results: (it won't look like a project boat anymore) :D Bottom: Belt sand what I could with 50 then 80 grit, hand sand the rest. Used 2 gallons of fairing compound to fill gel coat chips and hairline cracks 6...

    Started by akintosyali‎, 05-29-2007 09:09 PM
    • Replies: 5
    • Views: 1,811
    05-30-2007, 12:14 AM Go to last post
  5. Bent stanchion

    I had a run-in with a pump-out dock this week, (it came out of nowhere)! After pumping the holding tank the wind was putting me onto the dock. I did the Pascal move of turning the bow into the dock, then backing off. It worked well except something caught one of my stanchions and bent it slightly....

    Started by Beckytek‎, 05-29-2007 09:15 PM
    • Replies: 4
    • Views: 2,052
    05-29-2007, 10:07 PM Go to last post
  6. Burned by a non-problem

    I’m coming to the conclusion that maintenance is a bad thing, and that it makes more sense to simply let stuff break and fix it when it happens. I decided to finally replace my canister filters with spin-ons on my Allisons. I drained the oil, removed the old filters, and installed the new...

    Started by Bob Bradley‎, 05-29-2007 02:25 PM
    • Replies: 5
    • Views: 1,775
    05-29-2007, 07:20 PM Go to last post
  7. Water pressure system

    I was reading a thread from a while back regarding different water pressure systems. I just purchased a boat that needs a new water pump, the Galleymaid unit is inoperable. I haven't inspected yet to see where the problem lies, but i started pricing new units and GM was around $730, headhunter...

    Started by skrmetta90‎, 05-23-2007 01:04 PM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 4,893
    05-28-2007, 06:59 PM Go to last post
  8. PFD Storage

    I keep my PFD’s stored in these large Ziploc’s:http://www.ziploc.com/?p=b8 One bag can hold 3 Type I’s. They stay clean and I can grab a bunch at a time if I need to. Nothing is stored on top of them and they are accessible in an emergency. Are there any CG Reg’s against using these for...

    Started by Traveler 45C‎, 05-22-2007 01:59 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 5,834
    05-28-2007, 10:31 AM Go to last post
  9. 56 vs 53 classic?

    It seams to me like the 56 is an improvement on the great 53 in just about every way, is there something I'm missing? I'm thinking of changing my search for a Hatt to the 56.

    Started by Mark B‎, 05-23-2007 09:04 AM
    • Replies: 5
    • Views: 1,958
    05-28-2007, 07:22 AM Go to last post
  10. still searchin...

    You find the strangest things inside the helm. I did manage to find the AP pump, but still no compass. Also EXORCISED about a hundred feet of old wires going nowhere and a coffee can full of wire trimmins', old connectors, and of course, a pile of zip ties (used and left by the professional that...

    Started by yachtsmanbill‎, 05-26-2007 08:44 PM
    • Replies: 3
    • Views: 1,615
    05-27-2007, 11:50 PM Go to last post
  11. Galley Countertop

    I was thinkiong of putting granite in the galley of my 56 MY.I thought i had heard someone put it over there existing top.Was it 3/4 granite or thinner?Any thoughts. Thanks Chris

    Started by clubdowd1983‎, 05-27-2007 11:58 AM
    • Replies: 7
    • Views: 4,774
    05-27-2007, 10:55 PM Go to last post
  12. VHF antenna envy

    After spending the better part of Saturday curled up INSIDE the FB helm, I finally traced most of the antenna cables. The sub has 6 whip antennas. 3 of these are VHF with one being used for the lower helm and one on the FB with a broken cable at the antenna end. This one is a typical 8 foot antenna...

    Started by yachtsmanbill‎, 05-27-2007 08:08 AM
    • Replies: 0
    • Views: 1,179
    05-27-2007, 08:08 AM Go to last post
  13. Turnkey 43 DC going to "Broker"

    I have decided to put this beautiful Yacht where it will see some traffic. With the volume of boats available it is hard to make it stand out as the gem it is. Thanks to everyone that expressed interest.

    Started by Finalee‎, 05-25-2007 08:13 AM
    • Replies: 5
    • Views: 1,938
    05-26-2007, 08:46 PM Go to last post
  14. Cool Mounting for Laptop Computer

    Hi Guys: I have a Dell laptop I want to mount on the "dash" in the pilothouse of our 53ED. I want a clean looking set up that will hold it in place. Nothing big or obtrusive. Anyone have any thoughts/suggestions? Thanks in advance. DC

    Started by DLCameron2‎, 05-26-2007 09:53 AM
    • Replies: 4
    • Views: 1,536
    05-26-2007, 08:46 PM Go to last post
  15. Seacock Location for Mid-Cabin Head

    This might sound crazy, but I can't seem to find the toilet pickup seacock for the mid-cabin head in my 1972 53MY. The strainer is mounted on the starboard aft bulkhead, with the feed hose heading into the guest head just behind the toilet bowl. It then travels under the guest head floor,...

    Started by pmurphy‎, 05-14-2007 05:56 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 2,719
    05-26-2007, 08:35 PM Go to last post
  16. 48 MY Entertainment Center Finished

    I finally finished the new entertainment center in Chateau de Mer and thought I'd share the result. The design idea and all sorts of help came from Walt P :) , thanks again Walt. This aft salon wall on the 48 MY series I is virtually a blank wall and looks 'plain'. Top inboard cabinet usually...

    Started by bobk‎, 05-26-2007 09:07 AM
    2 Pages
    1 2
    • Replies: 11
    • Views: 7,493
    05-26-2007, 04:05 PM Go to last post
  17. Got my renewal today

    Am going to look at it as a "good thing". In 2005 my premium was $2410 In 2006 my premium was $3660 (increase of $1250) For 2007 my premium is $3840 (increase of ONLY $180) Now in 2000 my premium was $1080 and was with a real insurance co, not Great Lakes which is the only game in...

    Started by Jaxfishgyd‎, 05-25-2007 10:05 AM
    • Replies: 1
    • Views: 1,242
    05-26-2007, 07:09 AM Go to last post
  18. Shut Down Solenoid

    This last weekend I went to shut down the Genny, 15kw Onan, 1980, and the shut down switch when pushed dropped the RPMs down to idle speed but would not shut down the genny. I had to manually shut down the genny by pushing down the throttle at the injector pump. I started it back up and than hit...

    Started by chris piazza‎, 05-24-2007 09:56 AM
    • Replies: 8
    • Views: 2,178
    05-25-2007, 04:03 PM Go to last post
  19. 70C and 16V2000 HELP!

    Just found this site and it sounds like there are some very knowledgeable people on here. I have looked through this site and boatdiesel, but I havent been able to find much info on the 16V's. I need some help on pro's and cons of a 2000 70C with 16V2000's. I am new to the larger boat world and...

    Started by 1crazy1‎, 05-23-2007 04:34 PM
    • Replies: 9
    • Views: 2,309
    05-25-2007, 12:12 AM Go to last post
  20. Bridge Ladder

    I'm going to have a custom aluminum ladder made up to replace the existing SS bridge ladder. For now, the welder was going to use oval pieces of pipe for the steps. Does anyone know of any steps made that bolt or attach to the vertical pipe in a ladder? I'd save some $$$ and have a better end...

    Started by CDB101‎, 05-22-2007 10:41 PM
    • Replies: 8
    • Views: 2,298
    05-24-2007, 09:01 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts