I noticed last night that the water flow from the Cruisair heat exchanger was diminished significantly. Checked everything up to the Exchanger and flow was normal. I was able to blow out the exchange coil somewhat using lung pressure, but it clogged up again shortly after that. I suspect I need to...

One of my GM heads fills with water to an unusually high level - nothing to the point of overflowing or sloshing out, but appears to be consistent with the sea level outside the hull. This happens slowly, but not every time. The air lock tube is clear and water flows through it when flushing and...

does anyone know where i can purchase the track that hatteras used for window and shower curtains in mid 70's model boats? i looked on sams parts catalog but couldn't find any. thanks , bigbill

Take a look at my summer project: http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=020&sspagename=STRK%3AMEWA%3APIC&viewitem=&item=300113448209&rd=1,1 Hull is in good shape w orig gel coat. On port side is a large primer spot that needs paint so I'm wanting to repaint. Very few...

When my boat was new in 1985, Hatteras installed 2 transducers and 2 speed sensors, one for each helm. Apparently the owner did not want to put any electronics on the bridge, so he just put the Datamarine Offshore units in the pilothouse and that is all. Later, another owner added a sounder on...

I have a port engine which always runs oil pressure about 20% less than stb. (32psi vs 40 at 2000 rpm) Below 1500 rpm, the pressures match up. Is this something I can forgetabout or do I need a new oil pump? Oh, the engines are 6-71 ti.

These are 435hp 1979 engines. Anbody certain of the max rpm while under way? I'm having the props tunes.

Out of my 4 a/c units, 2 of them are original 1969 units and until now, have always worked fine. recently, I've started having some problems with the AC and am down to only one working unit. I think it may be time to put in some new ones and was wondering 1) where people have found good deals on...

Has anyone replaced the mirrors in their medicine cabinet doors? Looks like the afromosia panel on the back of the door is glued on to the wooden frame that surrounds the mirror. Can it be taken apart without damaging the frame? Thanks. Ted

Here goes... The boat has 2 VHF radios, one on the FB and one below. The starboard side FB VHF antenna is gawn with just a wire poking out. There are 2 VHF antennas on the port side with both wires going below. Evidently one is not used. 1. Can I use a multi meter to determine which one is...