Could someone help me with the total oil capacity for the DD 12V71TI? Thanks,

I’ve just purchased an 85’ 36c and have a question about the access hatch over the genset. The previous owner just filled the joint with silicon sealant and this looks terrible. I called the folks at Sam’s Marine and they kindly set me up with an “L” shaped gasket. ...

I have 1986 vintage NAIAD stabilizers that are not working properly and one that is leaking water. A NAIAD dealer has told me I need new actuators and that parts for my model (172) are no longer available so I need to upgrade the whole unit. The control unit is also of the older hydraulic gyro...

I am exploring the repowering of a 37C. I have 671's now and am considering upgrading to engines of current manufacture. I am wondering if anyone here has completed such an exercise? I am specifically interested in the engines selected and why they were selected. I would also appreciate knowing...

I have a problem. When I don't have the charge on, I turn the battery switch to starboard and everthing works, when I turn the switch to port, all goes off/no power. When I turn the charger on the port works, and all the starboard works. Batteries are all good, on both port and...

our trouble with our crusader 454's model 350's came back. ran fine on way off shore but would not run on way back. speeds under 2300 rpms are fine. give it the juice and it runs up then dies back. port engine hits 3500 rpms and starboard hits 2800 then dies back to about 2300. checked...

What size are you guys using? I have diesel now and want to replace my battery cables...they're large enough but they are shot from years in the bilge. More a of a safety thing for me. Another thing...I'm thinking I need at least 100A capacity. That would be 2/0, 2 guage or 2AWG? I know one...

Dear Members,, I very much interested with your opinion & benefit information which you always submit. But now I'm facing some problem, I need some spare parts for my engines & gears. All companies are asking for serial number for my engine, but I don't have it. It goes while our local agent...

I have a recently purchased 1972 38 Convertible in Cozumel. We pulled the boat out for the recent hurricane Dean and after 5 days on blocks, water started dripping out of the keel through small cracks, about 3 feet from the rear of the keel. It stopped after about three gallons had poured out. ...

Does anyone have the right part numbers for a raw water impller kit? I want to put new impeller kits in. Can't find the data in all the Hatteras info with the boat. 1996 Hat 39C- DD 6-71 J & T's 425 hp. I want to make sure I get the right ones. A good place to order them from would help too. ...