After my repower I noticed my boat had a slight list to the port and on occasion shifted from port to stbd. I looked all over the boat for water where it should not be, ect ect but found no clues about why it does this until I worked my way through the Bennett Trim tab system...which has been on...

I have 8V71TI's and I am chasing a temp creep on the stbd engine. i have been through all the usual stuff (impeller, raw water circuit flush w/phosphoric acid, fresh water engine flush) and decided since I haven't looked at the showerheads since I've bought the boat ('00), I should check them out....

I am in the process of adding mechanical oil pressure and temp gauges. My question is where do I put the temp bulb on a 6v92? I see a plug just above the water pump that might be suitable, but I don't want to put it where it has the possibility of restricting the flow. I thought maybe someone...

Just wanted to weigh in on my recent experience with the dreaded E10 situation. Purchased my 1971 36' Sportfish (Gas) knowing about the E10 situation and fiberglass tanks. When I purchased the boat the port tank was just about empty, the starboard tank registered between 1/8 & 1/4 tank. Ran the...

Can someone please tell me why I need to pull the Racor filter lid off and lift the filter halh way out of the canister, then a big bubble, gurgle, and the filter fills up. then put the lid back on and the motor runs fine all day! if I don't do this, the motor will run for four or five mins and...

Greetings all, I am repainting the bottom of my lower station when I started wondering if I should keep it at all. The boats a 1978 46 C. I have the throttles disconnected but the gears are still hooked up. Only once have I used it, when one of my upper station gear controls broke. If I got rid of...

I know basic maint. on my new cummins diesels...not the extreme stuff yet like I have had with a full rebuild of my gassers. One thing I'm thinking about is what I can do to keep them looking good..especially since they are new? What products do you guys use and what items do you pay attention to...

As some of you know, I'm in the midst of refitting/restoring a 1964 34 Sport Cruiser. Currently, I'm finishing up the steering system. All the old copper has been removed and replaced. The steering pumps seem to be working but to my surprise I found out that I didn't have the Crowell system that...

Attached is a photo of my secondary fuel filter. I am changing this old, original style filter to the spin-on type, per DD's recommendation. I am curious as to what the electric wires attached to it would be. On this fitting, to the right is the hose coming from the Walbro priming pump. To...