Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 749 of 1105 FirstFirst ... 249 649 699 739 747 748 749 750 751 759 799 849 ... LastLast
Threads 14961 to 14980 of 22082

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Nipples For You

    Bet I got your attention!!! Hard to find bronze pipe nipples available here http://www.midlandmetal.com/online_catalog.php?p=113 Brian

    Started by Brian Degulis‎, 04-01-2009 03:44 PM
    • Replies: 3
    • Views: 2,206
    SKYCHENEY
    04-01-2009, 07:00 PM Go to last post

  2. And another battery charger question

    I have (extensively) covered my plans to use my Outback 3232 to charge my two main batt banks in lieu of the old LaMarche. But there is also a 12v system on board, providing batt capacity to start the genny and provide a 12v "house" bank that is actually almost unused. I have two 12v batts, in...

    Started by MikeP‎, 03-31-2009 06:48 PM
    • Replies: 4
    • Views: 1,501
    GJH
    03-31-2009, 10:14 PM Go to last post

  3. More Harm Than Good?

    Due to travel schedules, there are times when a few months lapse in between available trips to get to the boat (53 Sportfish- 1271TI's). There are also times when I can only go over to check it briefly in the evening, or I am alone and too much of a hassle to take it out for a run. My question is:...

    Started by 53hatt‎, 03-30-2009 05:00 PM
    2 Pages •
    1 2
    • Replies: 14
    • Views: 5,269
    Robby
    03-31-2009, 07:57 PM Go to last post

  4. cleaning a RIB

    Just inherited an 2005 Avon RIB. It is structurally sound but stained with mold/mildew. This thing sat around for a year or more covered in leaves, debris, etc.. Any suggestions for cleaning/restoring pontoon material?

    Started by takefive‎, 03-27-2009 07:29 PM
    2 Pages •
    1 2
    • Replies: 12
    • Views: 4,733
    LUV'N LIFE
    03-31-2009, 04:45 PM Go to last post

  5. Cost for restoring stub shafts

    I've got a pair of 2" diam s/s stub shafts worn where they went through cutless bearings....for my 1972 48ft YF.... Anybody know an approximate cost for resurfacing the worn part of the shaft? Anybody know an approximate cost for new stub shafts? I know it's cost effective to repair large...

    Started by REBrueckner‎, 03-28-2009 03:38 PM
    • Replies: 7
    • Views: 3,509
    Brian Degulis
    03-31-2009, 04:27 PM Go to last post

  6. Is this preventive maintanence

    All this talk of too much power from the motors has me worried. I have a 91 Hatteras with 8/92. Low hours, very strong, but 720HP a side. Should I consider getting these reduced to 650-675 and is that just injestors. I have no idea what I would be in to to reduce the power. I enjoy 8-9 knots,...

    Started by Toronto‎, 03-27-2009 11:06 AM
    2 Pages •
    1 2
    • Replies: 11
    • Views: 4,610
    Brian Degulis
    03-31-2009, 04:11 PM Go to last post

  7. Injector and Valve Adjustments while out of water

    Wondering if it makes much of a difference whether I have the mechanic adjust the valves and injectors with the boat in the water or out of the water. Only negative I can think of out of the water is that he cannot turn engines over to test. My babies smoke like Cheech and Chong when there cold –...

    Started by sgharford‎, 03-31-2009 08:20 AM
    • Replies: 7
    • Views: 10,255
    sgharford
    03-31-2009, 01:50 PM Go to last post

  8. mystery water

    hello from a rookie, i have a problem with wetness in my master stateroom. the subfloor next to the drawers on the strboard side of the master stateroom gets wet often. have cleaned limber holes and been inside cabinets and noticed no water in there. dont know where else to look. thanks, nicki

    Started by nicki‎, 03-25-2009 10:57 PM
    3 Pages •
    1 2 3
    • Replies: 20
    • Views: 5,333
    MikeP
    03-31-2009, 09:48 AM Go to last post

  9. 85 Extended Deck Cruising Range- 6V92

    Good Morning Everyone. Fixing to head to Florida in a month and trying to find the approx cruising range. 1985 53' Extended Deck with 6V92. 700 gallon capacity. Thanks in advance.

    Started by sanddollarII‎, 03-29-2009 08:54 AM
    • Replies: 6
    • Views: 2,207
    ron6785
    03-31-2009, 12:33 AM Go to last post

  10. Blister Repair and Warranty

    Folks, I am having my 55C refit this year with complete Awlgrip paint job hard top and bottom job. As part of the work we removed about 2 thousand pounds of bottom paint, found a miriad of small blisters and decided to soft pad the gel coat below the water line and now seal with epoxy and barrier...

    Started by True Grit‎, 03-08-2009 11:29 AM
    2 Pages •
    1 2
    • Replies: 16
    • Views: 8,848
    Brian Degulis
    03-30-2009, 10:41 PM Go to last post

  11. 1986 41' Sportfisher

    Does anyone know if all 1986's had cored hulls? I know the cored hull didn't last long in this model and read that it was a concern but are there any known cases of core failure other then improperly sealed holes drilled in the hull? Should I stay clear of the 86 model year? Resale does not...

    Started by Flick‎, 03-30-2009 09:52 PM
    • Replies: 1
    • Views: 1,285
    shark 1007
    03-30-2009, 10:27 PM Go to last post

  12. New Starter issue

    I recently had a tech replace my Cat Starter on the port engine. It has an integral solenoid and in addition he replaced the relay mechanism mounted near the starter at the back of the engine. Started boat up this weekend and all was well. Moved boat to bulkhead to wash down. Went to restart...

    Started by whaler23‎, 03-30-2009 12:26 PM
    • Replies: 4
    • Views: 1,647
    Trojan
    03-30-2009, 09:33 PM Go to last post

  13. Bow Thruster on 55C??

    Thinking about putting a bow thruster on my 1987 55c. Anyone have any experience with this. What would be the downside if any? What would be potential challenges?

    Started by habanero‎, 03-29-2009 12:57 AM
    4 Pages •
    1 2 3 ... 4
    • Replies: 33
    • Views: 9,204
    Brian Degulis
    03-30-2009, 11:39 AM Go to last post

  14. Grounding/bounding

    To avoid further corrupting the shower head thread with this stuff... I found a very interesting article that essentially says the opposite of what most stuff on this site says about bonding. It says NOTHING should be bonded and all in-water metal components should be isolated from each other....

    Started by MikeP‎, 03-25-2009 05:20 PM
    6 Pages •
    1 2 3 ... 6
    1 Attachment(s)
    • Replies: 58
    • Views: 22,730
    fissioneng
    03-30-2009, 11:37 AM Go to last post

  15. Help - Advice on Helm pump replacement

    So after finding the strange 3/8 flare to #5 pipe fitting, I installed the helm pump and it was still leaking (by the shaft). I had already spend $350 on its rebuild and I have no intention on spending another $350. Here is the current/old Crowell system:...

    Started by akintosyali‎, 03-29-2009 11:24 AM
    • Replies: 5
    • Views: 2,229
    akintosyali
    03-29-2009, 08:43 PM Go to last post

  16. motor mounts 36c

    I posted my thread in the wrong section. Does anyone know how to move the post to the tech talk? If not, could you please read my post in the parts for sale section and respond. Thanks.

    Started by pathat315‎, 03-27-2009 08:12 PM
    • Replies: 5
    • Views: 1,719
    pathat315
    03-29-2009, 04:27 PM Go to last post

  17. Benmar binacle

    Does anyone know where the auto pilot binacle (compass) is located on a 1970 or around that time. 32 ft. Hatt? BILL

    Started by Trojan‎, 03-29-2009 12:09 PM
    • Replies: 1
    • Views: 1,245
    Captned
    03-29-2009, 01:34 PM Go to last post

  18. battery combining question

    I apologize in advance for asking a question that I should remember the answer to or, if I was on the boat, I could physically check or look at the wiring diagrams. But I'm not there... I want to combine my battery banks for charging purposes, using the Outback inverter/smart charger to...

    Started by MikeP‎, 03-27-2009 10:14 AM
    2 Pages •
    1 2
    • Replies: 18
    • Views: 6,049
    MikeP
    03-29-2009, 11:11 AM Go to last post

  19. HELP! -Need a 5/16 pipe to 3/8 flare brass fitting.

    I was at the boat toady reinstalling the hynautic steering pump (Crowell, old style). (Bill, I stopped by twice but you were not there. Do you take Sundays off??) As I was tightening one of the tubes into the cylinder, the piece that connects the tube to the pump broke. I took it to HD and...

    Started by akintosyali‎, 03-22-2009 11:00 PM
    2 Pages •
    1 2
    • Replies: 11
    • Views: 3,895
    captddis
    03-29-2009, 10:37 AM Go to last post

  20. new system for servicing batteries

    I found this link on another site. It seems like a good and easy way to service batteries. our batteries are in hard to reach placeses. Could this system be the trick? http://www.flow-rite.com/qwik-fill/index.html?open_menu=0&sub_menu=2

    Started by MarioG‎, 03-26-2009 11:38 AM
    2 Pages •
    1 2
    1 Attachment(s)
    • Replies: 15
    • Views: 5,238
    MikeP
    03-29-2009, 10:07 AM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 358 users browsing this forum. (4 members & 354 guests)

  1. Dmloveland
  2. Randy J
  3. Freestyle
  4. firbanks

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules