Hello all, There is a Bomar hatch on my Imroned Hatteras MY that has some peeling which has exposed bare and pitted cast aluminum. I do have some matching Imron and catalyst for touch up, but I would like to know what some of you think about priming (and primer to use) after clean up and before...

While my 40 Gallon hot water tank is still working, it is getting on and I am worried about a sudden leak or failure. With a 6 week trip planned in remote areas, I feel a need to intervene early. It is approx 32" high and 22" wide and won't fit through the engine room door (18.25") on my 54MY. ...

When I replaced my elbows on my 6-71's I didn't like the looks of the supplied gaskets. Sure enough they leak some exhaust. I want to rplace the gaskets. Any sugestions for selant (or should I use some) and gaskets? thanks Bill

Forgot the name of it and my parts guy isn't finding it. Anyone remember or did it change or go away? thanks garyd

Well I got the salon a/c unit working by getting the water flow up to par. But the bow a/c unit just doesn't even try to start it did a little now not at all. I can hear the relay click on then click off but the compressor (seperated units) does not budge. Anybody have some detailed...

I don't know if Hatteras used Morse Chargicators back in the day, but my old Connie is equipped with one and it's recently started acting up. These days, with folks going to Outback 3232 inverter chargers with remote panels, it might seem odd to be concerned about an old gauge going on the fritz,...

My port transmission shifts fine from the pilothouse but is intermittent going into forward gear from the bridge. If I move the lever forward to the stop on the bridge there is another inch or more of travel at the lower helm. Are these cables adjusted at the helms or at the transmissions? Any...

im refinishing the teak stairs to the bridge, wondering if anyone knows where a person can get tread protectors suitable for outdoor use the vinyl ones on ebay say for indoor use only. any suggestions?

Hi All, I'm still looking for the classic all teak steps. I've seen them in 2 and 3 step models. All teak ie sides steps etc......look at the steps in the upper right side of the picture attached. You usually see them going from a cockpit to a helm area or helm are down into the salon.....