Just completed a 2000 mi trip and the 1971 --671's ran great however the port oil pressure gage needle moved around at times and even pegged and stuck on the high side--made me wonder but all seemed ok-the next day it was fine----what caused it and can it be fixed or can I replace the gage-was told...

As some of you know, I am doing the Great loop in my 1973 43' DCMY. I have had a problem with occasional power loss on the port engine, generally while running in rough seas. I found algae in the fuel line to the port engine Racor, so had the fuel polished and the lines blown out, however, the...

Hi all, We are looking at buying a 58 my with 8v92 ti detroit diesels can they run at slow speeds like cruising at 6- 10knts or not? Cheers Peter B

Hello listees, My 1983 Hatteras 48 motoryacht has three head exhaust fans and the same exhaust fan over the stove in the galley. The circuit breaker which covers all of them as well as the port side AC electrical outlets is on the AC panel. The original electrical schematic for the boat...

i'm sure this has been talked about before, but i cant seem to find a thread in the archives about it. i am re finishing my salon aft doors, new glass, sand and varnish, and replacing the original 3 hinge setup(i have worn out 2 sets already) with stainless piano hinges. what is the best method...

I am removing my Galley Maid windlass. Removed capstan and gear box , both are off without any problem, Rich from G/M helped . Now there is deck plate left alone, it is just glued , and hard, no other connection but the glue keeps the plate with the fiberglass . I do not see how to get it off, it...

OK, I know it's on here somewherw but,I cannot find it. I need to clean and oil the afromosa. Someone please help.

My '72 36 C appears to have a fiberglass water tank. I do not know how big it is, but it serves as a walking platform when servicing engines. No leaks, but the level gage located under the steps is hosed. Suggestions on how to fix, replace??

Trying to find a spotlight mount for the front of the flybridge ( slanted). Having a hard time locating one. the previous was made of wood and rotted. I'm not having any luck finding one that will adust to the angle. Any suggestions on where to locate one?

Well, After several months of looking and negotiating we are bringing home a 53 ft YF. We were down to 3 different boats all three were aware of the other two. We effectively had them "bidding" against each other to lower the price. We ended up at a very good price point. The owner of the boat...