My current setup is heads to diverter valve that can go to the holding tank or to direct overboard via a 2" thru hull in front of my port engine. I am about to have a bottom job and the valve is in need of replacement. I do have a pump in the forward bilge that I can pump my holding tank overboard...

I have a 1983 32 sf with cat 2 3208t. Iam looking to upgrade my gauges and possible turning the analog signal into digital signal so I can see them on my Chart plotter and fish finder. The boat has cable driven tachs that run the glendenon synchronizer . Iam looking to read the tachs also. Any info...

Does anyone know the route the discharge toilet hose takes to get to the forward holding tank I know it goes through the starboard engine room but where does it enter the generator room

Have a lead on a good pair at 450hpwith 1.75-1 zf gears. Any thoughts on these motors to replace 671 tibs in my 1988 38c

Can anyone recommend a Detroit Diesel mechanic to do maintenance on a pair of 6V-71T in San Diego? Thanks.

I recently had my engines rebuilt, and ever since then my throttles don't stay where you put them. You push them forward and then as soon as you take your hand off of them they fall back on their own. It's very annoying. I called the mechanic who did the rebuilds, who blamed this on that I need new...

My boat has 2 self contained AC units. Each has its own thru hulk, strainer and pump. After a day trip, anchored for several hours then returning home at hull speed. Turned on the ACs and neither would pump water. Troubleshooting revealed air lock or lost prime. Cracking open the hoses at the...

Was sold an Ocean Breeze compressor as a direct replacement for 7000 btu Cruiseair , will not work. The guy that installed it called Ocean Breeze and was told I need their control. Any thoughts?