Hi all, one of my kitchen cabinets has a "crisper", or small heater rod in it. It seems to stay hot all the time. I pulled the fuse for it to shut it down, but is there a switch for it somewhere? Thanks

As part of a Cummins 450 Diamond repower, I need to swap out my 1.5" Aquamet 17 shafts for 1.75" Aquamet 22. I've priced them out new but have been wondering about used shafting. Given the large number of propeller vendors and private sellers around, including Sam's Prop Place, I've been surprised...

Sky, Ang (and others who have done this), Did you attach the PVC to the stringers with clamps or just let it sit? I'm trying to decide if clamping it is a good thing or whether it would actually make it more prone to a problem due to any flexing of the boat or the PVC.

Hello All, I was recently introduced to a different type of fire suppression than what we carry here on the ship. It is basically an anti fire hand grenade that will knock the shit out of a fire fast and you remain at a safe distance. We bought one so far but will be adding 2-3 more because...

Well I decided that the very first thing I should do is to make sure the 4 8D house bank is in good condition:mad: .We had another battery boil and that makes two batterys boiled sence Aug 28 of this year .Mind you these are the orginal Batterys that the PO installed before they did the Loop 4...

48 LRC owners, I am new to the 48 LRC so still on a steep learning curve. I started checking my bilge pumps and high water alarms only to find out some are very difficult to get too, mainly the ones forward of the engine. The port engine my be possible with a lot of swearing but the starboard...

I have been looking early 2000 sportfishers and many have a milky look to the interior finish. This is only on the ones with the super hi-gloss finishes. Not sure if this is epoxy or what do you have to do for a refinish.

I am new to east coast trawling. We have a 48 Hat LRC and getting ready to bottom paint. My experience has been west coast and mexico sailing and have had good success with blue water marine 67% SCX ablative paint. I know the differences between hard and ablative, but was wondering what some of...

After much discussion with the broker (& then a mechanic), we've determined that the engines in the '62 41'er aren't 6v71's - as the Forum insisted don't fit in the early trunkcabins - but are 6-53 nats. I'm not looking for a high 20's cruise (close to 20 would be fine), but can this boat get out...

Well, it's that time of year.. starting to get into the 50's. I was checking to make sure all my cruiseair's were making heat. I have a couple that don't want to cooperate! (1987 63MY) They make AC fine. The thermostats are old Honeywell units, and there is NOT a place to swap from AC to heat, just...