My 1988 36 has the original bronze colored window frames. The finish is so thin you can see through it in places. It's not corroded, I'm in fresh water, just bleached out by the sun. Question is, has anyone refinished their frames to the original color? Every one I've seen are painted the hull...

Well seems like I'm on our way to getting out inverter project fixed(I sure Hope so!!)it time to get something new done.So I'm off to the land of Wifi antennas and coax.I know I asked before and Charlie and a few of the other 43DCMY owners stepped forward and some said that their mast was hollow...

Time to purchase a new battery charger for mr 36C. Is there a charger that wll run 12V blowers and fans while Ginny is running so that battery is not drained? (Engines are off while drift fishing but cooling fans stay on) recommendations?

I don't know if this is Tech Talk but I am going tomorrow AM to Warwick to start prepping the boat for moving to Stuart the 22nd. I haven't been on board since the surveys and sea trial 6 weeks ago and know the slightly odoriferous bilges are probably quite distinctive in aroma by now. I...

In my removing the white waste hose/installing PVC (completed) I discovered that the shower drain in the guest shower is leaking around the base so it needs to be removed/recaulked/reinstalled. I was able to get the drain pipe removed but I cannot loosen the large nut that holds the drain itself...

Would anyone have a schematic of a 3126 Cat. About a 2001 model. I'm trying to help my boss locate all the zincs on the motor since he sprayed all them white. They had red paint on the tops of all them and now he can't remember where they all were. It seems like there were about 4 or 5 of the...

Hi all, one of my kitchen cabinets has a "crisper", or small heater rod in it. It seems to stay hot all the time. I pulled the fuse for it to shut it down, but is there a switch for it somewhere? Thanks

As part of a Cummins 450 Diamond repower, I need to swap out my 1.5" Aquamet 17 shafts for 1.75" Aquamet 22. I've priced them out new but have been wondering about used shafting. Given the large number of propeller vendors and private sellers around, including Sam's Prop Place, I've been surprised...

Sky, Ang (and others who have done this), Did you attach the PVC to the stringers with clamps or just let it sit? I'm trying to decide if clamping it is a good thing or whether it would actually make it more prone to a problem due to any flexing of the boat or the PVC.

Hello All, I was recently introduced to a different type of fire suppression than what we carry here on the ship. It is basically an anti fire hand grenade that will knock the shit out of a fire fast and you remain at a safe distance. We bought one so far but will be adding 2-3 more because...