Preface - I'm not a DC wiring guru and if you throw a switch in there, I'm a little more useless. I am, however, pretty good at replicating what was there which has worked well for me over the years. I understand AC wiring way better. That said, I need some help with reconnecting the wires...

I went down into the genny room to poke around and look at things. I saw that the 2" exhaust hose which runs between the Vernalift and the elbow that passes through the sound shield was bulging, about ready to rupture, and in need of replacement. After much work wrestling that piece of hose off,...

I am about to start my galley remodel, having just ordered new cabinets, some of the appliances, etc. In the plans, I have a trash compactor going in. I’d like some opinions/recommendations on trash compactors from those of you who have some history with them either on your boat or in your home. ...

I am beginning to tackle the job of replacing the headliner. I intend to use removable panels that are covered in a thin foam-backed vinyl. While I’m in there, I want to start replacing the overhead lighting fixtures, and I’d like to go with recessed dimmable LED lights. There isn’t a lot of...

Calling all you Detroit breathing/bleeding gurus.... The heat exchanger/radiator "box" on the front of my starboard engine has to come off and get refurbished. A gasket or two started leaking the last time we went out and the whole thing turned to crap quick. There was salt cakes on the floor...

OK...I give...how do the bathroom sinks come out? I've disconnected the water pipes, cut through what I suspect is 5200 underneath, released the tie down clamps (those were apparently just for show), and it still won't budge. I'm trying to get the sink out unscathed, and without tearing up the...

I hope this isn't like asking which is the best toilet. :D I've been removing my flybridge rails so I can fix the leaks. I plan to re-bed them with white butyl when they go back up, after repairing any coring damage below. It's amazing how much water gets in these rails, given that the joints...