Preparing to install new washer/dryer. I replaced 2 blowers, one of them a 32vdc generator exhaust blower. It worked fine, but later started tripping the breaker immediately on start up. I traced the problem to a "hot" motor case. If I take the grounding strap off, the blower works fine. Touch the...

Hello: My first post and thanks for any feedback I get. I am seriously considering purchasing a 1968 45' Convertible. I will be purchasing it as a 'project' boat ( although my wife is not too happy about this its the only way I will ever be able to afford a boat like this. ie do the work...

My compressed air system is not charging when I run the engine. After shut down air blows out of the relief valve. My best guess is I should replace teh relief valve and see what happens. But before going with my guess I thought I would see if anyone here has a better idea. Thanks in advance....

We did find a nice set of stairs. Now we need helm seats. The original is long gone. Is there a source for an original or a newer replacement? Does anyone have a good picture of the original? as always thanks so much! Russ and The Admiral:cool:

I have a water leak where the hose connects the copper tube running from the thermostat to the heat exchanger. The engine is a 671ti 390 hp Covington. The copper tube measures 2.25 inches OD and the hose slips over the tube. Hope it is just a matter of replacing the hose. Advice on the correct...

I am the proud owner of a 1981 Hatteras MY and need some help with a repair. ALthough I have been a boater for many years, this is my first "Hat". I am told that the washer/dryer has a leak at the bottom of the washing machine. I am not sure where the proper access to the unit is or what is...

Just heard from the mechanic. The Whirlpool Piggy back washer dryer washing machine works in all modes other than hot wash/cold rinse. So, warm/warm/warm/cold/cold cold is fine. If it is the selector switch, easy to access and repair. If it is the solenoid hung or broken, whole machine needs to be...

I have a granite (or composite) table top on a high/low pedestal on our aft deck. It is grossly over-sized for the area. We are looking to replace it with a granite coffee table sized top that when can the attach to the high low pedestal. My guess is something about 24" x 36" or so. I have found a...

I'm wanting to replace original washer valves and wiper motor controls with newer single 'motor and washer control' (that does not leak). Can call SAMs but thought someone may know. I have 12 volt; off, slow, and high speed motors that self park. Replaced o-rings in brass valves but still have to...