Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 50 of 1106 FirstFirst ... 40 48 49 50 51 52 60 100 150 550 1050 ... LastLast
Threads 981 to 1000 of 22119

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. 120V Service line at 60V

    I just tried to run 120V 30amp service to our 53 my. In Service Port 1 it comes in as 120V. In Service Port 2 (both Port and Starboard) it comes in at 60V. This is fed from the same connection and line. Also tested on different 120V source. I have never used 120V 30amp before. I...

    Started by metama‎, 11-16-2022 04:33 PM
    • Replies: 1
    • Views: 307
    SKYCHENEY
    11-16-2022, 05:38 PM Go to last post

  2. Allison m20 service manual or advice

    Hi, im after advice for slow shifting m20 transmission where is the strainer located? oil pump pressure test point location? oil pressure specification?

    Started by Goldy46c‎, 10-17-2022 09:29 PM
    2 Pages •
    1 2
    • Replies: 10
    • Views: 1,441
    Goldy46c
    11-15-2022, 02:37 AM Go to last post

  3. Valve cover Data

    I have a 1988 41C, 6V92. I was under the impression these were 550hp. I thought that was pretty much the only configuration they put in these boats. Looking at my rocker arm covers, it say the motor is 332HP @2300. IS this correct, did these ever go in these boats? According to the last...

    Started by Messi‎, 11-12-2022 08:36 PM
    • Replies: 1
    • Views: 478
    Captain Ralph
    11-12-2022, 08:57 PM Go to last post

  4. Windshield wiper repair

    Has anyone repaired the windshield wipers on a 42 LRC Mk II?

    Started by PleasureBay‎, 11-12-2022 09:18 AM
    • Replies: 1
    • Views: 391
    SEVEN
    11-12-2022, 02:51 PM Go to last post

  5. Port Gear Shifter will not engage forward

    My port gear shifter on my 1987 Hatteras 54' stopped responding in the midst of docking - will not stay forward - "spongy" to the touch. Shift lever simply reverts back to neutral position. Same for both helms. Have noticed some oil leak around the lower helm gear shift station - apparently from...

    Started by bobstorey‎, 11-08-2022 09:45 AM
    • Replies: 5
    • Views: 527
    Pascal
    11-11-2022, 11:57 AM Go to last post

  6. Inverter ideas for '84 53 EDMY

    Hello - Has anyone fit a house bank and inverter to run the fridge and outlets? If so, any suggestions? Thanks! Dave Randall "On Liberty"

    Started by Dave R‎, 11-01-2022 11:47 AM
    2 Pages •
    1 2
    inverter/ charger
    • Replies: 13
    • Views: 1,314
    SKYCHENEY
    11-08-2022, 10:52 PM Go to last post

  7. 53 MY Length

    Has anyone actually measured their 53 with the factory swim platform? The marina is looking at it and thinking it’s a lot longer.

    Started by Salty lady‎, 11-08-2022 03:59 PM
    • Replies: 3
    • Views: 413
    Dreamboat
    11-08-2022, 09:52 PM Go to last post

  8. Silicone impellers

    Just wanted to pass on the extremely poor service that I received from pumpvendor.com. I bought two of the silicone impellers for the Detroit diesel and sent them back because they were so hard I couldn’t collapse the veins to fit it into the housing. They did everything they could to say that it...

    Started by SEVEN‎, 11-08-2022 03:18 PM
    • Replies: 3
    • Views: 424
    SEVEN
    11-08-2022, 08:54 PM Go to last post

  9. 43DC Upgrades and renovations?

    There seems to be a handful of us on here that own 43DC’s. Mine is a ‘79 Hull #510. She seems to be mainly original other than electronics and aft deck enclosure. I would like to do some galley and head renovations. Maybe even the salon. I do have the forward day head with dinette. What...

    Started by 43DoubleCabin‎, 11-07-2022 06:59 PM
    2 Pages •
    1 2
    2 Attachment(s)
    • Replies: 16
    • Views: 1,225
    UNIQUE_NAME
    11-08-2022, 01:27 PM Go to last post

  10. Eliminating toilet circuit boards

    Both toilets on my boat came with electronic circuitry to trigger the fill/ flush cycle. A Jabsco and a Vetus brand. The Jabsco failed after a year and the Vetus lasted about 4 yrs Instead of shelling out several hundred $$ for replacement switches, I was able to connect an “on off on” rocker...

    Started by rob71‎, 11-07-2022 05:45 PM
    • Replies: 1
    • Views: 486
    Pascal
    11-07-2022, 07:32 PM Go to last post

  11. Pulling engine for re-manned crate

    looking at a 53 Hatteras that had 8-71ti pulled out and replaced with re-manned crate engine. Curious, what is process of getting the old engine out and new in? Thanks!

    Started by sunsetacres1318‎, 11-07-2022 11:49 AM
    • Replies: 1
    • Views: 529
    Pascal
    11-07-2022, 12:03 PM Go to last post

  12. Twin Disk Gearbox leaking oil at coupling--is there room?

    My starboard gearbox has started flinging oil out of the coupling joint. it looks like the outer seal is not leaking. I suspect the inner flat rubber O-ring ("Lathe Cut Ring" M2074S) is the culprit. Does anyone know if I have room to service this without dropping the propshaft or lifting out...

    Started by 52CMY‎, 11-04-2022 01:20 PM
    2 Pages •
    1 2
    7 Attachment(s)
    • Replies: 15
    • Views: 1,370
    Captain Ralph
    11-06-2022, 01:30 PM Go to last post

  13. Vertical Wind Turbine?

    I saw that this question was asked in 2010 with no answers, and now I'm also looking for an answer. The question is if anyone has experience or done research on a vertical wind turbine on a Hat. I don't like the typical horizontal wind turbines you see on many sail boats, but it looks to me like...

    Started by dawg6‎, 11-05-2022 09:28 AM
    • Replies: 0
    • Views: 222
    dawg6
    11-05-2022, 09:28 AM Go to last post

  14. Help with these Isolation Transformers (assuming that is what they are)

    I have 2 large boxes in the engine room (see below) which I believe to be isolation transformers as well as possibly voltage boosters/frequency converters. Of all the documentation I have on board, I don't have any information on these. I've attached a photo of the top unit and hope maybe...

    Started by zigzag930‎, 10-30-2022 02:21 PM
    3 Pages •
    1 2 3
    10 Attachment(s)
    • Replies: 20
    • Views: 1,674
    cww
    11-04-2022, 02:35 PM Go to last post

  15. Leaking windows and impact on hull

    looking at a mid 1990s boat that had windows that leaked over its life and needs some wood refinishing. Are the cored hulls sealed well at the window openings? or is the hull suspect. I have not decided to pass on the boat but thought I would ask for advice.

    Started by ekm‎, 10-27-2022 02:14 PM
    2 Pages •
    1 2
    1 Attachment(s)
    • Replies: 12
    • Views: 1,286
    Gavra Meads
    11-04-2022, 09:44 AM Go to last post

  16. 6v92 airbox pressure test

    Looking to check airbox pressure. Is there a good port to do so? I don’t see any likely places. Thanks

    Started by Messi‎, 11-03-2022 02:21 PM
    • Replies: 2
    • Views: 385
    Messi
    11-04-2022, 08:59 AM Go to last post

  17. Re-maned DD 8-71 TIC. Concern??

    Looking at a 53 Hatteras. Very nice Boat. Problem is I am not sure about engine situation. The starboard DD 8-71 TIC was replaced with a re-maned DD 8-71 TIC. The port engine was not removed but has new heads, injectors, Turbos, blower, water pump. Should I be concerned or excited? Thanks!

    Started by sunsetacres1318‎, 11-03-2022 06:17 PM
    • Replies: 5
    • Views: 710
    rsmith
    11-04-2022, 08:35 AM Go to last post

  18. 53 MY Ice Maker/sink on Aft deck. Where is the water shut off valve? Thank You!

    53 MY Ice Maker/sink on Aft deck. Where is the water shut off valve? Thank You! PT

    Started by PJT‎, 10-30-2022 02:05 PM
    • Replies: 5
    • Views: 1,776
    PJT
    11-02-2022, 08:39 PM Go to last post

  19. Hydrolock??? Help, unkown cause.

    I installed a new starter on my port engine on my 53MY with 8v71N. Went to start and nothing. After going over every possible senario we checked to oil dipstick and it was 2 inches higher thatn normal. I went to the oil transfer pump and pumped out some oil and the water, salt water. I drained...

    Started by Shaunc‎, 10-30-2022 09:16 AM
    2 Pages •
    1 2
    2 Attachment(s)
    • Replies: 11
    • Views: 1,245
    Shaunc
    11-02-2022, 03:38 PM Go to last post

  20. Holding tank overboard discharge

    Our '84 53' EDMY has the standard starboard side and forward holding tanks. She presently has only the dockside pump - out option but we have thoughts about going to the Bahamas which lacks that option. Has anyone retrofitted a means to pump out their tanks? Thanks! Dave Randall "On...

    Started by Dave R‎, 11-01-2022 11:49 AM
    blackwater, discharge, holding tank, pump out, sewage system problems
    • Replies: 5
    • Views: 580
    rwaldrop13
    11-02-2022, 03:38 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules