Our #2 gen is a kubota/phasor 12.5kw V1505-EBG Generator is Lima Electric 250 gold medallion12 lead 240 volt single phase; which runs fine for 2-4 hours, and then the 220 and 120 volt service flickers with a constant load-no breakers blow, and then the engine stumbles as it reloads. the 220 comes...

I had the intercoolers cleaned and now ready to reassemble. The output hose is 4.5" ID which is available. The inputs are 3.5" ID but parts list shows 3.125. The cast number is 892223 which I can not locate on the net. Is this something specific to marine or am I just missing something?

So I must be a little bit Slow here but I assumed that I could take the Model # number off of the plate of my Jabsco raw water pump (2750-001) and I would be able to find replacement impellers for it. I didn’t think these would be hard to find as the Detroit 8V53 are very common. but I am guessing...

I'm not sure if this belongs here or on the sandbar, so forgive me if I've posted in the wrong place. We're in the process of redecorating BUFFALO GAL. Finding a good carpet installer who is willing to work on a boat is proving to be more of a problem than I thought. Apparently business must be...

We stripped the wallpaper (it is a paper not vinyl) of our midship cabin and there is a very thin (1/16 to 1/8) foam product glued to the substrate. Has anyone run into this before? I'm thinking it might be a vapor barrier??? One of the walls is common with the full beam engine room leading to...

I run a charter boat in Costa Rica. What recommendations would you have for me to re-power. I just yanked my 671's, they were the original Covington diesels blown out to 450 bhp, although after many rebuilds and not being able to get the proper injectors I was probably only getting 350 bhp. My max...

I have a raw watter pump maybee see some evidence of leaking is there a way to check without going in the bilge while it is running. It is not leaking at the dock at idle or eaven if i rev it up a little. Maybee be taking a short trip soon. There is little to no pressure on the pump so can not put...

I was wondering how many 43's have cabinets over top the re fridge. I have 2 6 X 12 in. doors. I was going to install a flip up bar type table on the back side like a few of the 43's have. I need a lunch table since most of the 43's don't have dinnets. But I ran into a little problem. My refridge...

Looks like I need to replace all of my raw water strainers (3) due to leaks that the yard doesn't seem to think they can fix. I need brand suggestions please. JT 6-71TI's and ONAN 8.5KW Thanks:cool: