I need to replace 4 strainers. After 33 years they are in need of service. The 4 are located in my genset hole. 2 larger ones for the Genset and heads and 2 smaller ones for the raw water pumps for the a/c compressors. Cost wise it is better to replace than rebuild. Any reason to not replace with...

I just tried to run 120V 30amp service to our 53 my. In Service Port 1 it comes in as 120V. In Service Port 2 (both Port and Starboard) it comes in at 60V. This is fed from the same connection and line. Also tested on different 120V source. I have never used 120V 30amp before. I...

I have a 1988 41C, 6V92. I was under the impression these were 550hp. I thought that was pretty much the only configuration they put in these boats. Looking at my rocker arm covers, it say the motor is 332HP @2300. IS this correct, did these ever go in these boats? According to the last...

My port gear shifter on my 1987 Hatteras 54' stopped responding in the midst of docking - will not stay forward - "spongy" to the touch. Shift lever simply reverts back to neutral position. Same for both helms. Have noticed some oil leak around the lower helm gear shift station - apparently from...

Has anyone actually measured their 53 with the factory swim platform? The marina is looking at it and thinking it’s a lot longer.

looking at a 53 Hatteras that had 8-71ti pulled out and replaced with re-manned crate engine. Curious, what is process of getting the old engine out and new in? Thanks!

I saw that this question was asked in 2010 with no answers, and now I'm also looking for an answer. The question is if anyone has experience or done research on a vertical wind turbine on a Hat. I don't like the typical horizontal wind turbines you see on many sail boats, but it looks to me like...