Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 401 of 1106 FirstFirst ... 301 351 391 399 400 401 402 403 411 451 501 901 ... LastLast
Threads 8001 to 8020 of 22115

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. bilge pump voltage question

    Many years ago, I added a Jabsco diaphragm pump to the bilge pump array in my Hatteras. All the other pumps ever on the boat were centrifugal pumps, which will not strip the bilge dry, as they will not generate suction. The Jabsco pump, which was the largest they made, with 1" inlet and outlet...

    Started by jim rosenthal‎, 12-13-2014 02:05 PM
    • Replies: 6
    • Views: 2,510
    tonytrakovich
    12-16-2014, 02:50 PM Go to last post

  2. KVH vs Intellian

    I am planning to purchase a new small KVH or Intellian sat dish and am looking for information on one versus the other brands. Also, where is the best place to buy one? I have heard that KVH will treat you like dirt if you did not buy it from an "authorized" dealer even though KVH sells new...

    Started by seasalt‎, 12-13-2014 11:20 AM
    2 Pages •
    1 2
    • Replies: 18
    • Views: 11,729
    SeaWhisper
    12-16-2014, 01:26 PM Go to last post

  3. How many 8D batteries

    I have a 1979 43DC with 6-71Ns. There are two 8D batteries in each bank. Port bank for engine and genny. Starboard bank for engine and house panel. 1400 CCA each battery. My question is: do you really need two 8D's to start an engine? I use the boat year round here in South Carolina, temps...

    Started by eze2bme‎, 12-15-2014 08:39 PM
    • Replies: 8
    • Views: 3,682
    Dan Mapes
    12-16-2014, 11:39 AM Go to last post

  4. Venting the air from the cooling system?

    I am about to refill the engine with water for flushing and after that i will drain again and put the recommended antifreeze mixture. I have two hoses which are coming from the front end if the water manifold and one shorter one from the top of the front side of the engine block, both of which are...

    Started by brico‎, 12-14-2014 11:29 AM
    • Replies: 0
    • Views: 1,141
    brico
    12-14-2014, 11:29 AM Go to last post

  5. My turn for water leak

    The floor in front of master head had a spot of water on it. I tried to ignore it for days but it was growing. It turns out the tub drain was installed with silicone caulk. The nut on the bottom wasn't holding anything. I need a huge fender washer for the bottom to snug up the drain, and a...

    Started by davidwigler‎, 12-13-2014 07:22 PM
    • Replies: 1
    • Views: 1,309
    magnawake
    12-14-2014, 08:01 AM Go to last post

  6. Hatteras 53my generator room holding tank

    I have searched everywhere including under the stairs from the engine room and cannot find the plate ahere the hoses connect.The tank seems very close to the ceiling in the generator room and access is nearly impossible.Anyone know where acess is gained-is it necessary to remove the stairs?

    Started by ian w‎, 12-03-2014 09:11 AM
    2 Pages •
    1 2
    • Replies: 10
    • Views: 5,522
    Nonchalant1
    12-13-2014, 12:54 PM Go to last post

  7. heat exchanger pic

    Took an end cap off my heat exchanger Saturday and this is what I found. Cleaned the cap and end of the exchanger,runs cooler. What do you think the other end might look like? I did the other engine 2 years ago. Had the core dipped the whole nine yards. This was just a quickie job and it runs...

    Started by ram‎, 12-10-2014 10:00 PM
    2 Pages •
    1 2
    3 Attachment(s)
    • Replies: 10
    • Views: 5,307
    ram
    12-12-2014, 11:39 PM Go to last post

  8. 8v195 batteries

    I found at Carquest, the 8v195 batteries for 209.99. I compared the specification with the Deka 8v195 and they are the same. Has anyone any knowledge about any difference?

    Started by jusbumn‎, 04-22-2014 09:40 PM
    3 Pages •
    1 2 3
    • Replies: 24
    • Views: 14,928
    MikeP
    12-12-2014, 11:22 AM Go to last post

  9. Galleymaid Fresh Water Pump

    My Galleymaid 32v pump comes on and cuts off when pressure is correct. Go wash hands and it works great. Hop in shower and it kicks on several times and then "flips" the breaker. Any suggestions?

    Started by tunasea‎, 11-11-2014 08:58 AM
    2 Pages •
    1 2
    • Replies: 14
    • Views: 7,043
    MikeP
    12-11-2014, 01:46 PM Go to last post

  10. Block Heaters on the fritz

    Does any one recognize these block heaters. Both are bad. Corrosion has set in and when I turn them on at the breaker, I can hear an electrical arcing at the probe. I have JT 671TI in my 1981 37C. The probes are installed just behind what appears to be a fuel pump(not positive). Pictures...

    Started by Luckyducky‎, 12-08-2014 01:57 AM
    2 Pages •
    1 2
    7 Attachment(s)
    • Replies: 12
    • Views: 5,664
    Luckyducky
    12-11-2014, 11:08 AM Go to last post

  11. Overland trucking a 45 or 46 Convertible

    Good Morning: Does anyone have any experience with having a 46 or 45 Convertible trucked along the Eastern portion of the US? I have been in the market for a nice older sport-fish and I often see nice Great lakes boats that I'm not willing to bring down by water to MD. I've done the Erie Canal...

    Started by Vince‎, 11-22-2014 10:33 AM
    2 Pages •
    1 2
    • Replies: 13
    • Views: 6,261
    Tres03
    12-11-2014, 01:48 AM Go to last post

  12. does it take less power to run heat as opposed to AC?

    I'm on the boat for a while doing some work. It's 33F degrees outside, water temp is 41F and I have all 4 heat/ac systems running. Here's my question... Does it take less current to run the oem cruiser units on heat as opposed to AC? I would have thought it would be the same since, as I...

    Started by MikeP‎, 12-09-2014 02:42 PM
    2 Pages •
    1 2
    • Replies: 17
    • Views: 5,566
    Luckyducky
    12-10-2014, 10:09 PM Go to last post

  13. Chart/Chartplotter Question

    Yesterday while running out of Ft Walton on the .3 mile scale the heading line simply disappeared.What gives?Is it all over the ICW?

    Started by Robby‎, 12-07-2014 10:26 AM
    • Replies: 6
    • Views: 3,215
    Robby
    12-10-2014, 11:39 AM Go to last post

  14. Shaft Packing

    Hello all, I have read every where and have not found out the answer. What is the size of the packing that goes on my shafts? I have one that is leaking pretty good, its a steady poor. I have tightened the bolts all the way to the point it will not tighten any more and it will not slow down. I...

    Started by Tres03‎, 12-09-2014 01:07 PM
    • Replies: 4
    • Views: 2,098
    Tres03
    12-10-2014, 11:00 AM Go to last post

  15. DD 8V92Ti cylinder Temp.

    Hello, I am seeking advice. In the effort to get the most out of my old engines, I have preformed a couple complete tune ups. Rebuilt the blowers and turbos, bought a couple exhaust manifolds, and a set of injectors. (No, I did not have the injectors flow checked before installation, this I learned...

    Started by osprey‎, 12-10-2014 01:05 AM
    • Replies: 4
    • Views: 2,772
    MikeP
    12-10-2014, 09:42 AM Go to last post

  16. New Member New Project

    Hello All, My name is George and I am Chief Engineer on ships in Alaska. I Rebuilt a 26' Alglas sportfish a few years ago and I wanted another project an so I've been lurking here a while during my search for a boat, my choice was between a Hatteras or Egg Harbor and I ended up with A 46...

    Started by geofish‎, 07-27-2011 05:23 PM
    2 Pages •
    1 2
    9 Attachment(s)
    • Replies: 18
    • Views: 9,015
    geofish
    12-10-2014, 02:02 AM Go to last post

  17. Muriatic acid / Oxalic acid / Water mixture effectiveness?

    I have not done it and am asking those that have, how effective is it? I have my expansion tank removed and heat exchanger element taken out. I've used some Zep "Bath tub and Tile Cleaner" (Home Depot Canada) and managed to remove some of the growth on it, but not completely. Would the soaking...

    Started by brico‎, 12-05-2014 11:02 PM
    2 Pages •
    1 2
    2 Attachment(s)
    • Replies: 17
    • Views: 9,848
    brico
    12-09-2014, 09:23 PM Go to last post

  18. Picture Shadow

    My wife and I have been working through the projects on the 52 and we have come to an issue. On the door that covers the electrical panel in the back of the boat there once was a picture and now that we have removed that picture there is an outline of the picture. Cleaning doesn't seem to work. I...

    Started by Texastailboard‎, 12-08-2014 10:11 PM
    • Replies: 2
    • Views: 1,579
    Tim Powell
    12-09-2014, 07:59 PM Go to last post

  19. LED replacements for G4 Halogen bulbs...

    Hello All I jus purchased a 2006 Hatteras 50 SF... The overhead lighting in the salon and all staterooms have G4 base 24v 10w and 20w Halogen bulbs... I would like to replace them with LED versions... They would also have to be dimmable... Should I get warm or bright white? Please give me best...

    Started by GregS‎, 12-07-2014 02:07 PM
    • Replies: 6
    • Views: 2,528
    dave1985
    12-09-2014, 05:16 PM Go to last post

  20. iPad chart plotters

    New iPad for early Christmas gift to myself. Navionics automatic chart plotter now works after an update. Up to 100 waypoints at a time. I want to compare Active Captain but can't find the app. What's it called?

    Started by davidwigler‎, 12-08-2014 07:04 AM
    • Replies: 6
    • Views: 3,285
    magnawake
    12-08-2014, 06:46 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules