Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 390 of 1105 FirstFirst ... 290 340 380 388 389 390 391 392 400 440 490 890 ... LastLast
Threads 7781 to 7800 of 22097

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Rudder Post Cutlass Bearings - 1979 43C

    I finally removed my rudder cutlass bearings yesterday. Whoever replaced them last did a pretty bad job cutting them - apparently with a hacksaw. The interior ends of both were quite irregular. Both were quite worn, with the rubber having separated from the brass sleeve. There was noticeable...

    Started by Bob Bradley‎, 03-09-2015 01:56 PM
    • Replies: 0
    • Views: 1,258
    Bob Bradley
    03-09-2015, 01:56 PM Go to last post

  2. Underwater lights

    I've been doing a lot of research on underwater lights and think I have made the decision to go with Aqualuma 12 series. Has anyone had luck with this brand? Can anyone make a better recommendation. Thanks Rusty

    Started by SEVEN‎, 03-07-2015 03:28 PM
    • Replies: 6
    • Views: 2,354
    thoward
    03-09-2015, 12:51 PM Go to last post

  3. How many freshwater tanks?

    Hello all, I have a 1987 63' motoryacht. Does anyone know how many fresh water tanks? And if more than one, anyone know if the aft fill will fill both at once? Dottieshusband, I'm sure that you must know ;-)

    Started by GalaxyGirl‎, 03-03-2015 11:34 AM
    • Replies: 6
    • Views: 2,942
    GalaxyGirl
    03-09-2015, 02:58 AM Go to last post

  4. Need Tools

    Greetings all, I will add a toolbox to my ER on my Hatteras 38c, which has DD 6-71s. What tools beyond the normal screw drivers, sockets and wrenches, would be wise to include? Any special tools or wrenches? Thanks Phil

    Started by AV8‎, 03-06-2015 09:21 AM
    3 Pages •
    1 2 3
    • Replies: 23
    • Views: 9,023
    brian4190
    03-08-2015, 03:21 PM Go to last post

  5. Change out ship service power from 30 amps to 50 amps.

    I have a 1981 43 DCMY. It has two 30 Amp shorepower connectors. One for ship service and the other for HVAC. Has anyone ever upgraded from 30 Amp to 50 Amp for ship service? I live aboard and in the winter am constantly having load balancing problems. Am only able to run a couple of appliances...

    Started by Triskele‎, 02-21-2015 06:32 PM
    2 Pages •
    1 2
    • Replies: 16
    • Views: 6,614
    Boatsb
    03-08-2015, 11:47 AM Go to last post

  6. Why do the 6v92s Have such a bad reputation

    I have never owned one but have been aggressively in the market looking to go to a bigger Hatt and every boat I'm interested in have that model Detroit.When really taking a look at things like time on market ,prices they sold for and opinions of people who have had them or worked on them they are...

    Started by Hatt-Trick‎, 03-06-2015 04:01 PM
    2 Pages •
    1 2
    • Replies: 10
    • Views: 5,684
    polarizer
    03-07-2015, 04:00 PM Go to last post

  7. March Pumps

    Are the March AC raw water pumps for Cruise air rebuildable?

    Started by Robby‎, 03-06-2015 03:43 PM
    • Replies: 4
    • Views: 1,854
    Robby
    03-07-2015, 08:10 AM Go to last post

  8. How do I save my ZINCS?

    Had to haul boat this week for insurance survey, just six weeks from splashing with new bottom job and new zincs. To my surprise, shaft zincs were half gone. Can someone provide advice on Galvanic Isolators? Or, provide other suggestions that may extend life of zincs. Note, I have visuall...

    Started by Kim Beatley‎, 09-28-2013 09:48 AM
    2 Pages •
    1 2
    • Replies: 12
    • Views: 5,080
    Maynard Rupp
    03-07-2015, 07:58 AM Go to last post

  9. outback fx2532mt inverter (sealed)

    Is anyone using a Outback fx2532 MT 2500 watt inverter. I selected the 2500 watt vs the 3232 because the 2532 is sealed and the 3232 is vented. I am thinking of adding a separate battery bank of 8d's with a Mate II. Also, does anyone see any problems? I have a 1972 58 Hatteras Yachtfish with 871...

    Started by jusbumn‎, 04-01-2014 01:26 PM
    2 Pages •
    1 2
    • Replies: 14
    • Views: 5,797
    Doug.T
    03-06-2015, 10:29 PM Go to last post

  10. 871 oil pan 2 dipstick outlets ???

    the oil pan on my 871 has rotted out, can't weld or use jd weld. For a week I have tried to locate a oil pan for this engine that has a dipstick option on both sides. I am not a mechanic and realize one side is used connecting to a hose for whatever. The ID numbers are no help. Seems engines were...

    Started by jusbumn‎, 03-06-2015 06:23 PM
    • Replies: 0
    • Views: 1,012
    jusbumn
    03-06-2015, 06:23 PM Go to last post

  11. Onan MDL-4 question

    I have a 1989 20kw MDL-4 gen set. Trying to replace the exhaust hi temp switch. According to the parts manual this is an Onan p/n 309-0484. The part is about $100 depending where you shop. I found a company that makes these switches. Can buy for around $10. Problem is that I don't know the temp...

    Started by tonytrakovich‎, 03-02-2015 10:17 AM
    2 Attachment(s)
    • Replies: 5
    • Views: 3,180
    GJH
    03-05-2015, 02:30 PM Go to last post

  12. Under water lights

    Could anyone recommend an underwater light for the transom of a 45c?

    Started by Summerfun‎, 03-01-2015 05:07 PM
    • Replies: 6
    • Views: 2,081
    Tinman
    03-04-2015, 05:00 PM Go to last post

  13. hydraulic reels to install

    Im wanting to install 2 hydraulic deep drop reels on my 1986 Hatteras convertible. Is there a factory installed hydraulic pump and tank already on it that I can use for supply to the reels.

    Started by Bordaddy‎, 03-02-2015 07:35 PM
    • Replies: 3
    • Views: 1,500
    thoward
    03-04-2015, 01:46 PM Go to last post

  14. Marine Air

    I've got the original marine air units on our 46C. Obviously they're loud. Not bad enough to pull out running equipment though. Question is, are newer units of the same size going to be any more efficient?

    Started by Capt Chad‎, 03-01-2015 06:59 PM
    • Replies: 7
    • Views: 2,998
    Tim Powell
    03-04-2015, 12:49 PM Go to last post

  15. Kohler 9kw Gen Problem

    I purchased a Hatteras 38c knowing I had to replace the generator due to failure. Fate stepped in and the shipyard I do business, happened to have a brand new generator which was mis-ordered and could not be used that I bought at a reduced price. I would like to repair the old generator,...

    Started by AV8‎, 03-03-2015 07:26 PM
    • Replies: 2
    • Views: 1,229
    AV8
    03-03-2015, 10:06 PM Go to last post

  16. Washing Machine Rec. for 58' 1973 HatterasYacht Fisherman

    The PO removed the stacked washer/dryer combo on my 58' 1973 Yacht Fishermen. I would like to purchase an all in one unit, so I can add some additional storage drawers. Was my old unit 220? What units do people like?

    Started by Rob Dengler‎, 03-01-2015 08:34 PM
    • Replies: 6
    • Views: 2,325
    Steve Mannshardt
    03-03-2015, 09:35 PM Go to last post

  17. What transducer is this one on 1980 37 Convertible?

    I have several (what I believe are ) transducers fitted on the bottom of my 1980 37 Convertible but the only one I use is the depth transducer. To be honest I do not know where is it. When working around my Port engine I noticed some sea water pooled and i suspect it is from a transducer that is...

    Started by brico‎, 03-01-2015 11:58 PM
    • Replies: 5
    • Views: 1,772
    steve flury
    03-03-2015, 07:56 PM Go to last post

  18. Used Capitol Transmission HE 11200

    Hi. Anyone know where I can get a used Capitol Transmission HE 11200. I’m looking for one in operating condition. Perhaps a boat that was repowered or a Katrina boat that wasn't submerged etc… There’s no real rush, but I’d like to have one drop in ready incase one of mine does fail.

    Started by 86Hat41‎, 03-03-2015 02:27 PM
    • Replies: 3
    • Views: 1,291
    steve flury
    03-03-2015, 07:49 PM Go to last post

  19. Removing painted name

    I want to rename my boat to something different than the choice of the previous owner. The name is pained on the transom and on each side of the flybridge coaming. Considering the boat was originally painted with Imron paint over gelcoat, is there a safe paint remover that will not damage/lift the...

    Started by brico‎, 03-01-2015 10:49 PM
    • Replies: 7
    • Views: 3,142
    SeaEric
    03-03-2015, 06:44 PM Go to last post

  20. Tower/Half Tower Canvas

    Does anyone have a good contact in the Fort Lauderdale area that is fair and does a good job. I'm looking to replace the canvas that streaches over the half tower top at bridge level on our tower. It's starting to wear thin and show it's age. Any suggestions would be appriciated. Thanks Tony

    Started by capttonyf‎, 03-02-2015 03:20 PM
    • Replies: 1
    • Views: 1,532
    Fanfare
    03-03-2015, 06:29 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 297 users browsing this forum. (6 members & 291 guests)

  1. tkbsurf
  2. volkerrb
  3. SEVEN
  4. carolinacoast
  5. madhatter1
  6. johnjen50

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules