Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 201 of 1107 FirstFirst ... 101 151 191 199 200 201 202 203 211 251 301 701 ... LastLast
Threads 4001 to 4020 of 22132

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. Battery switch panel

    Sometime back Chris ( Boss Lady ) and I bought an aluminum box/panel to mount the battery switches in from Tom Slane. The favor we are asking is can some one post a pic of their box so we can see how it is set up with the switches inside ?

    Started by Starman‎, 03-04-2007 06:09 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 3,578
    03-12-2007, 07:58 PM Go to last post
  2. 120V vs 12 volt DC

    I have to replace my fresh water pump. I have a 45C and am wondering if I need to replace it with another Pool Pump or can I use a 12 volt pump. Thnaks Tom/Gina Marie

    Started by Gina Marie‎, 03-10-2007 09:42 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 3,558
    03-12-2007, 08:10 PM Go to last post
  3. Paint prep?

    Tried a search because I know I've read threads about this in the past, but came up with zip (which speaks alot about my computer skills, but I digress.. :o ) I'm going to be purchasing a bunch of stuff to paint a car restoration project and slowly climb up the learning curve on how to do it...I...

    Started by Rickysa‎, 03-12-2007 11:30 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 2,991
    03-12-2007, 10:45 PM Go to last post
  4. Allison question

    I just ordered 7 cases of 6-1 gallon jugs of Rotella 40W for a complete oil change including gears. I am going to pull and clean the screens this time as well and drain the trans coolers as there is still a slight water contamination evident on the port trans. These are MH20's. 1. Is the screen...

    Started by yachtsmanbill‎, 03-10-2007 09:00 AM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 4,769
    03-13-2007, 12:35 AM Go to last post
  5. Too cool temperatures

    Ran the boat the other day with sea water temp. about 60 degrees. Engine jacket water temp. (8V-53's) stabilized at cruise speed at about 165 degrees. It is normally about 185 degrees in the summertime with sea temps. about 80-85 degrees. Thermostats are either 180 or 185 degree, I don't...

    Started by Lucky Dog‎, 03-12-2007 06:46 AM
    • Replies: 5
    • Views: 1,977
    03-13-2007, 07:01 AM Go to last post
  6. Cool Stainless Steel Exhaust Elbows

    I need to get a new stainless steel exhaust elbow for my 671 TI Detroit on my 1987 Hatteras Motoryacht. The present one has corroded at the solder joint and at another point and is leaking. Can anyone give me info as to where I can get one made? Also info on how to get it off and a new one on...

    Started by jzanni‎, 03-12-2007 08:33 PM
    • Replies: 5
    • Views: 4,182
    03-13-2007, 07:45 AM Go to last post
  7. 6v92 Raw water pump zinc size

    Does anybody know offhand the correct zinc size?

    Started by Bob Bradley‎, 03-12-2007 03:31 PM
    • Replies: 8
    • Views: 4,730
    03-13-2007, 10:14 AM Go to last post
  8. DD power graphs

    I'm looking at the power graphs for the 8V71N ... can you guys explain the difference between the Rated Shaft HP curve and Power Propeller Load curve ? at 1500 RPM cruise, it's gives 220hp on the first one, and 85hp on the second one.. which makes more sense. also, any idea how much...

    Started by Pascal‎, 03-12-2007 08:50 PM
    2 Pages
    1 2
    • Replies: 10
    • Views: 7,903
    03-13-2007, 02:28 PM Go to last post
  9. NEED HELP about early 38' Convertibles,

    I am asking for some help with the early 38' Convertible; namely 1968 to 1974. I am looking at three boats that are from the Chesapeake Bay. Two are gasoline powered and one is diesel (8V53N). I have owned several boats in varying lenths and styles, but I have been waiting patiently for a...

    Started by jarhead24‎, 03-07-2007 10:28 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 4,180
    03-13-2007, 04:19 PM Go to last post
  10. How do I make it go away?

    After digesting many good pointers on going about changing out the coolant in my engines I'm haveing a really tough problem trying to find out what is the best way to properly dispose of old engine coolant. (I thought this was mentioned in the past and did a "search" on old Threads). I have made...

    Started by (Nobody You Know)‎, 03-13-2007 01:00 PM
    • Replies: 7
    • Views: 2,859
    03-13-2007, 08:17 PM Go to last post
  11. Batteries to replace 8D's

    Greetings all, I'm looking to replace my last two 8d's I have on board with batteries that will fit in the 2-8d boxes I have now. I have 8 other golf cart batteries for the house bank and to start my starboard engine. The 2 - 8d's I need to replace are dedicated port engine start batteries. I...

    Started by Captned‎, 03-10-2007 10:57 AM
    • Replies: 5
    • Views: 2,195
    03-13-2007, 08:39 PM Go to last post
  12. Twin discs slinging oil

    Both of my 2:1 twin discs sling oil out of the rear shaft seal when running. After a ~three hour 1850 rpm run, they have thrown (in micro sized droplets) maybe 2 good sized drops or so, (less than 1/2 cc) the starboard one a bit less. I probably wouldn't even notice, but with snow white bilges......

    Started by luckydave215‎, 03-13-2007 10:22 AM
    3 Pages
    1 2 3
    • Replies: 22
    • Views: 4,585
    03-13-2007, 11:05 PM Go to last post
  13. Anchor Rode Bolt Cutter?

    Do you have an all chain rode? If you do, how many of you have bolt cutters on board? If you answer the first question yes and the second question no, how to you free up a stuck anchor without losing all of your chain? Just getting ready for recommissioning up here and made sure I had a bolt cutter...

    Started by JLR‎, 03-08-2007 11:43 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 4,785
    03-14-2007, 02:09 AM Go to last post
  14. Copper fuel lines.

    I have been researching the repair on a copper fuel return line and decided to replace the whole line. The are two types of tubing. Both are 1/2 inch OD and .032 walled. One is tinned inside and one isn't. Whats the difference and which one should I use. Thanks for the info.

    Started by Courageous‎, 03-13-2007 04:15 PM
    • Replies: 8
    • Views: 2,437
    03-14-2007, 02:47 PM Go to last post
  15. Fuel Use, 53 vs 58?

    I am looking at buying either a 53 or a 58 yacht fisher. The prices are about the same for each. I wonder what the fuel use is. they both have the same engines.

    Started by belandd‎, 03-14-2007 02:00 AM
    2 Pages
    1 2
    • Replies: 15
    • Views: 3,805
    03-14-2007, 05:34 PM Go to last post
  16. New Member/43DC '71 Owner Looking for Info

    Hello all, My wife and I are the PROUD owners, as of 12/05, of a 1971 Hatteras 43 DC. I am trying to determine the best source of finding the history of this boat. We purchased her in Tarpon Springs a year ago December and are currently living aboard at Twin Dolphin Marina in Bradenton, Fl. ...

    Started by tim45haley‎, 03-12-2007 07:24 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 3,380
    03-14-2007, 06:13 PM Go to last post
  17. 21XX Radar Problem

    Been trying to hold out another year or two to purchase all new electronics, but last weekend I turned on my 21XX radar and received the message "zero heading - pulse error." Is my radar/open array toast, or am I missing a setting or calibration? As always, all help is appreciated... :confused:

    Started by kwerges‎, 03-14-2007 12:22 AM
    • Replies: 8
    • Views: 2,268
    03-14-2007, 10:08 PM Go to last post
  18. Hot or not hot

    Anybody know what is the normal operating temperture for 3208 CATs? (no response from boatdiesel.com or gregorypoole.com (CAT dealer). Also, not in owner's manuel either! I would just like to have a general idea exactly what the cruising temperature should be (or range). (Hell, maybe they have...

    Started by (Nobody You Know)‎, 03-14-2007 07:47 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 4,347
    03-14-2007, 11:32 PM Go to last post
  19. Extended Life Coolant

    In Feb. 2004 (Nobody You Know) engines were flushed and refilled with Dexcool Extended Life Coolant. While I'm sure the running time per year is way under the life of the coolant a Freightliner dealer and a CAT dealer (not the same) advise that the coolant is good for 5 years. The litmus strip...

    Started by (Nobody You Know)‎, 03-14-2007 11:21 AM
    • Replies: 8
    • Views: 5,242
    03-15-2007, 09:17 AM Go to last post
  20. Oil Analysis 12v71

    I am looking for values on other oil reports. These are Blackstone values.... EMT Av My Sample Alu 3 6 Chr 3 7 Irn 63 174 Cop 8 6 Led 4 8 Tin 4 7 Mly 35 23

    Started by thoward‎, 03-14-2007 01:06 PM
    • Replies: 8
    • Views: 2,477
    03-15-2007, 09:20 AM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

There are currently 358 users browsing this forum. (2 members & 356 guests)

  1. Pascal
  2. RJM

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts