helloi. i own a 1970 hatteras 45c. im trying to find out the height from the heighest point of the bridge to the keel. basically transport height to props removed. thanks all

Within the last year, a local shop installed a Victron battery monitor. (the Xantrex one I had prior stopped working and this is an upgrade from that one) All was well until last winter when I noticed that even with both banks fully charged, the house read full voltage and the aux bank (the...

Hi, I am new to the diesel side and trying to change out the secondary filter on our 12v 71. I believe its a canister twist on typ but can't find a part numnber of any type on the outside. Does anybody know which size it uses? Trying to avoid opening it then going again to the shop which is a...

We are in Ft Lauderdale prepping for Bahamas trip. While doing systems check realized my fire suppression system is due for inspection. Can anyone recommend a vendor? Brett

The good news is that I got about 2 hours or cleaning and fixing done today, the bad news is that I did it over 5 hours. I am installing Starlink on the arch where the old glomex TV/radio antenna was. I got the cable ran through the arch, then down the pipe with the AC duct into the cubby hole in...

Ive got A 1981 37C with DD 671 TI JT, trying to replace the Rt engine throttle cable with new. I can not find the model number on either end. I did call Sams and they have identified about 7 different cables under my hull number 415. However it does not say what position each of the cables are...

Replacing my Hynautic k31 steering cylinder with a new seastar unit. The bushings that attach the cylinder to the tiller arm have seen better days and I want to replace them while I've got everything apart. They appear to be copper or brass/bronze maybe? Anyone have a source for these bushings? ...