Welcome to the Hatteras Owners Forum & Gallery. Sign Up or Login

Enter partial or full part description to search the Hatteras/Cabo parts catalog (for example: breaker or gauge)
+ Post New Thread
Page 1105 of 1106 FirstFirst ... 105 605 1005 1055 1095 1103 1104 1105 1106 LastLast
Threads 22081 to 22100 of 22110

Forum: Hatteras Tech Talk

Techinical Discussion & Hatteras Related Topics Only

  1. 58‘ LRC Mast wiring

    Anyone KNOW what the path is for the wiring from inside the mast to the pilot house? My spreader lights have good ground but no power at the terminal block inside the base of the mast. I have power at the upper and lower helm switches but can’t find the terminal block where the upper and lower...

    Started by Conchyjoe‎, 09-24-2023 11:48 PM
    • Replies: 0
    • Views: 164
    Conchyjoe
    09-24-2023, 11:48 PM Go to last post

  2. Wire gauge supplying helm DC panel

    All, I am trying to figure out what gauge wire is supplying the DC panel at our helm. We have a 1981 43c. The DC panel is original to the boat and has a total of 8 breakers. I have the factory wiring schematics but they are on the boat which is 2.5hrs away. I thought someone might know off the top...

    Started by Hat43c1981‎, 03-25-2023 03:57 PM
    gauge wire dc helm
    • Replies: 0
    • Views: 298
    Hat43c1981
    03-25-2023, 03:57 PM Go to last post

  3. Blocked air con intake

    That’s a new one to me…. For the last couple of weeks, both my chillers have been running 15 to 20 degrees higher than normal, one of them tripping occasionally. Measured outflow using a jug and a timer and was barely getting 100gph at each chiller discharge. Not enough for 36k units. Popped...

    Started by Pascal‎, 09-29-2023 01:32 PM
    2 Attachment(s)
    • Replies: 0
    • Views: 239
    Pascal
    09-29-2023, 01:32 PM Go to last post

  4. Master cabin headliner

    Hello, The headliner in my master cabin was replaced by a PO with padded plywood sections that are too heavy for heavy duty velcro they used to hold them up, they sag and fall down. Not cool. I'd like to go back to the original headliner material but wondered how it is fitted around the short...

    Started by dar636‎, 04-02-2023 04:08 PM
    3 Attachment(s)
    • Replies: 0
    • Views: 406
    dar636
    04-02-2023, 04:08 PM Go to last post

  5. Fuel, Water tank sensor / gauge size / format

    Before I order a bunch of sensors. Can someone please confirm the side of: Fuel tanks format and Gauge Water tank format and Gauge Looks like I have 1 1/4 NPT on the holding tank.

    Started by metama‎, 04-04-2023 09:59 AM
    1 Attachment(s)
    • Replies: 0
    • Views: 200
    metama
    04-04-2023, 09:59 AM Go to last post

  6. Fuel, Water tank sensor / gauge size / format

    Before I order a bunch of sensors. Can someone please confirm the side of: Fuel tanks format and Gauge Water tank format and Gauge Looks like I have 1 1/4 NPT on the holding tank plumbing. Anyone know what the copper tube sensor is attached with? Im ordering level pickups.

    Started by metama‎, 04-04-2023 10:02 AM
    • Replies: 0
    • Views: 351
    metama
    04-04-2023, 10:02 AM Go to last post

  7. AC Voltmeter

    One of my AC voltmeters is not working. Replaced it with another one slightly different style analog and its not reading accurate. Has anyone installed modern digital ones that fit? Seems the vintage Hatteras ones are not available anymore.

    Started by Dragonten‎, 07-17-2023 10:12 PM
    • Replies: 0
    • Views: 346
    Dragonten
    07-17-2023, 10:12 PM Go to last post

  8. Analog Ammeters No Working

    1986 63 MY. Both AC ammeters in the electrical panel have not worked since buying 3+ years ago. They are made by Hoyt Meter. Voltage and HZ gauges work fine. It seems odd both gauges are inoperable. Inside the panel there is a bank of low voltage old style glass tube fuses. I believe these drive...

    Started by divert00‎, 04-17-2023 11:00 AM
    2 Attachment(s)
    • Replies: 0
    • Views: 276
    divert00
    04-17-2023, 11:00 AM Go to last post

  9. MDL4 Injection pump

    Big shout out and thanks to Derek (avenger) and East Coast Diesel Service, Lynbrook NY for rebuilding the injection pump for my 20Kw Onan MDL4. Looks better than a new one. Thanks Derek

    Started by dottieshusband‎, 07-30-2023 11:45 AM
    1 Attachment(s)
    • Replies: 0
    • Views: 324
    dottieshusband
    07-30-2023, 11:45 AM Go to last post

  10. 1981 Vintage Teak Interior Rail Molding

    Looking for a source of used/new teak interior rail molding to match the profile used on my 1981 Hatteras 42 LRC. All the "new" stuff just has the straight face cut and not the concave sculpting. Thanks for the insight.

    Started by Dry Dock‎, 04-28-2023 11:18 AM
    • Replies: 0
    • Views: 298
    Dry Dock
    04-28-2023, 11:18 AM Go to last post

  11. Cruiseair 3 Knob A/C panel needed

    Hi all, I am in need of a cruise air 230v A/C panel. Specifically the temp/thermostat part. Anyone have a spare they are willing to let go? I am in the Jax, FL area willing to pickup if it makes sense. Thanks in advance!

    Started by tkbsurf‎, 05-02-2023 11:17 AM
    • Replies: 0
    • Views: 374
    tkbsurf
    05-02-2023, 11:17 AM Go to last post

  12. Twindisc mg506 issue

    1978 43 DC with 6-71 and twi disc mg506 transmissions. In idle, Trans oil pressure shows 300 psi but shift into gear and pressure drops to near zero. Prop does turn when in gear. Saw previous posts about pressure relief spring in selector valve but I don't have parts diagram or disassembly...

    Started by Pda1964‎, 08-07-2023 02:49 PM
    • Replies: 0
    • Views: 214
    Pda1964
    08-07-2023, 02:49 PM Go to last post

  13. Bow thruster R and R

    Had the MaxPower Thruster shear a pin last summer in the driveleg. Finally was able to haul it out and replace it. I forgot how big these boats are, very cool! 62000 lbs. Had to cut off the old blades, not too bad and the lower unit came out with the help of leverage and a 2x4. Cleaned the...

    Started by dar636‎, 11-12-2023 10:37 PM
    3 Attachment(s)
    • Replies: 0
    • Views: 209
    dar636
    11-12-2023, 10:37 PM Go to last post

  14. Impellers for DD 6V71s

    Can I ask where everyone is getting thier impellers, brand name, and cost? Thanks guys!

    Started by sunsetacres1318‎, 05-12-2023 05:54 PM
    • Replies: 0
    • Views: 384
    sunsetacres1318
    05-12-2023, 05:54 PM Go to last post

  15. Crane Maintenance

    I am not having any problems but am wondering what regular maintenance does the crane for my tender likely require. We replaced the electric switch and installed a new wire about 5 years ago but nothing else. Thanks for your thoughts Bruce Freestyle 1986 62 CPMY (54MY with ext)

    Started by Freestyle‎, 08-21-2023 03:55 PM
    • Replies: 0
    • Views: 184
    Freestyle
    08-21-2023, 03:55 PM Go to last post

  16. Extrending Marquipt Davit

    So the Marquipt davit is being rennovated at the same time the dinghy chocks are being repositioned on the back flybridge deck. The davit has not been used often in the seven years we have owned the boat. Mechanically and electrically its fine, but we will replace the wire with dyneema. ...

    Started by scottinsydney‎, 08-23-2023 07:36 AM
    3 Attachment(s)
    • Replies: 0
    • Views: 215
    scottinsydney
    08-23-2023, 07:36 AM Go to last post

  17. Fuel capacity

    Hi, can anyone tell me what the useable fuel is the original tanks in 1971 36C

    Started by Kathy L‎, 05-26-2023 10:13 AM
    • Replies: 0
    • Views: 310
    Kathy L
    05-26-2023, 10:13 AM Go to last post

  18. recommended Detriot mechanic in Panama City, FL

    Morning, new to the Panama City area and need to find a good Detriot. Does anyone have a good guy in mind? Engines are 12v71s. Thanks in advance!

    Started by BJones‎, 06-01-2023 09:53 AM
    • Replies: 0
    • Views: 144
    BJones
    06-01-2023, 09:53 AM Go to last post

  19. 37C Throttle cable identification and R and R

    Ive got A 1981 37C with DD 671 TI JT, trying to replace the Rt engine throttle cable with new. I can not find the model number on either end. I did call Sams and they have identified about 7 different cables under my hull number 415. However it does not say what position each of the cables are...

    Started by Luckyducky‎, 06-03-2023 10:52 PM
    • Replies: 0
    • Views: 156
    Luckyducky
    06-03-2023, 10:52 PM Go to last post

  20. Interceptor Tabs

    Decided to delete the old trim tab system and install a set of interceptor style tabs. Figured somebody would like to see the process… First we removed the old system including all pumps, rams and tabs then we had to glass in the remaining “pockets” where those things lived. Once that was done, we...

    Started by Boattrash‎, 03-08-2023 11:07 PM
    3 Attachment(s)
    • Replies: 0
    • Views: 242
    Boattrash
    03-08-2023, 11:07 PM Go to last post

Forum Information and Options

Moderators of this Forum
Users Browsing this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules